BUSCADOR RECOLECTA

17 pages. -- Figure S1. XRD patterns of perovskite films with and without HTAB perovskite films. -- Figure S2. Fitting results from Figure 4b using CasaXPS software. -- Figure S3. XPS core-level spectra of C 1s of pristine and modified perovskite films. -- Figure S4. XPS spectra (a) Pb 4f and (b)I 3d (c)survey spectrum for I 4d, Br 3d, Pb 4f, Br 3p and C 1s (d) enlarged image of C 1s of pristine and passivated perovskite films. -- Table S1. X-ray photoelectron spectroscopy (XPS) quantification analysis with and without HTAB treatment perovskite films from Figure S1c. -- Table S2.Calculated atomic ratios from data of Table S1. -- Figure S5. SEM combined with EDS mapping for HTAB modified perovskite film. -- Figure S6.Raman spectra of perovskite films with and w/o HTAB modification. -- Table S3. EIS Fitting parameter from Nyquist plot. -- Figure S7. VOC decay of w/o MAI containing pristine and HTAB passivated perovskite films. -- Figure S8. J-V curves of C-PSCs using different concentration of HTAB (1 mM and 2mM in IPA) as with and w/o passivated devices. -- Table S4. Photovoltaic parameters of C-PSCs derived from J-V curves using different concentration of HTAB with and w/o modified devices. -- Figure S9. Statistical distribution of the photovoltaic parameters for 2 mM HTAB as passivated devices for 10 devices. -- Figure 10. -- Table S5. Photovoltaic parameters of C-PSC prepared without MAI in solution [1], either with or w/o HTAB passivation. Figure 11-15. -- Table S6. Stability test under low humidity (RH ~20 ± 5%) at room temperature over 1700 h. VOC is increased from 0.97 to 1.02 V., Peer reviewed

10 pages. -- Contents: Measurement of the thickness of the quantum wells. -- Charge noise measurements. -- Noise spectra for a quantum dot from heterostructure C 5. -- Frequency and gate voltage dependence of noise spectra. -- Operation gate voltages for charge sensor quantum dots. -- 6. Lever arm extraction. -- 7. Simulations of dephasing times and gate fidelities. -- Dephasing of charge qubit. -- Dephasing of spin qubit. -- Gate fidelity simulations. -- References, Peer reviewed

17 pages. -- S1. Materials, methods and characterization. -- S1.1.Materials. -- S1.2.Methods. -- S1.3. Characterization. -- S2. Characterization of BCN-348. -- S2.1. Single-crystal X-ray diffraction. -- S2.2. Powder X-Ray Diffraction. -- S2.3. N2 sorption. -- S2.4. Thermogravimetric Analysis. -- S3. Heterogeneous degradation of simulant diisopropylfluorophosphate (DIFP) in unbuffered solution. -- S3.1. Gas Chromatographic (GC) studies. -- S3.2. 1 H and 31P-NMR studies. -- S4. Reference, Peer reviewed

This PDF file includes: Supplementary Text Figs. S1 to S7 Table S1, Peer reviewed

Table 1.DOCX Image 1.TIF Image 2.TIF Image 3.TIF Image 4.TIF Image 5.TIF Image 6.TIF, Peer reviewed

[Description of methods used for collection/generation of data] - Bioinformatics: DeepCLIP analysis (https://deepclip-web.compbio.sdu.dk/) - Sanger sequencing - Fluorescent Fragment Analysis., This dataset corresponds to a comprehensive study of the alternatively spliced exons 8 and 10 of the breast cancer susceptibility gene CHEK2. For this purpose, we have used a minigene with exons 6 to 10, where we introduced 12 internal microdeletions of exons 8 and 10 and 87 variants by site-directed mutagenesis that were assayed in MCF-7 cells. We identified three minimal (10,11,15-nt) regions essential for exon recognition. Thirty-eight variants impaired splicing, and 3 of which were classified as pathogenic/likely pathogenic variants according to ACMG/AMP (American College of Medical Genetics and Genomics/Association for Molecular Pathology)-based guidelines, so carrier patients and families may benefit from tailored prevention protocols and personalized therapies., EAV lab is supported by grants from the Spanish Ministry of Science and Innovation, Plan Nacional de I+D+I 2013-2016, ISCIII (PI20/00225) co-funded by FEDER from Regional Development European Funds (European Union). Lara Sanoguera-Miralles is supported by a predoctoral fellowship from the AECC-Scientific Foundation, Sede Provincial de Valladolid (2019–2023)., File: DeepCLIP_Predictions_Variants_exons_8_10.xlsx Folder: cDNA_Sequences. Transcript Sequencing: • 176 *.ab1 files of cDNA sequences of the wild type and mutant minigenes. Folder: Fragment_Analysis. Fluorescent Fragment Analysis: • 267 *.fsa files of fluorescent fragment analysis of the wild type and mutant sequences. Folder: Minigenes_Sequences. Sequence files of wild type and mutant constructs (89 *.ab1 files)., Peer reviewed

Appendix A. Supplementary material, Peer reviewed

Appendix A. Supplementary material, Peer reviewed

Multimedia component 1., Peer reviewed

12 pages. -- Figure S1-S18. -- Table S1. Atomic percentages determined by XPS in the electrodes after OER. -- Table S2. Comparison of the CoFeP-based electrodes for OER in 1 M KOH in chronological order., The development of high current density anodes for the oxygen evolution reaction (OER) is fundamental to manufacturing practical and reliable electrochemical cells. In this work, we have developed a bimetallic electrocatalyst based on cobalt–iron oxyhydroxide that shows outstanding performance for water oxidation. Such a catalyst is obtained from cobalt–iron phosphide nanorods that serve as sacrificial structures for the formation of a bimetallic oxyhydroxide through phosphorous loss concomitantly to oxygen/hydroxide incorporation. CoFeP nanorods are synthesized using a scalable method using triphenyl phosphite as a phosphorous precursor. They are deposited without the use of binders on nickel foam to enable fast electron transport, a highly effective surface area, and a high density of active sites. The morphological and chemical transformation of the CoFeP nanoparticles is analyzed and compared with the monometallic cobalt phosphide in alkaline media and under anodic potentials. The resulting bimetallic electrode presents a Tafel slope as low as 42 mV dec–1 and low overpotentials for OER. For the first time, an anion exchange membrane electrolysis device with an integrated CoFeP-based anode was tested at a high current density of 1 A cm–2, demonstrating excellent stability and Faradaic efficiency near 100%. This work opens up a way for using metal phosphide-based anodes for practical fuel electrosynthesis devices., Peer reviewed