Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Research data Set de datos (Dataset)

Supplementary Material of Ash interaction with two Cu-based magnetic oxygen carriers during biomass combustion by the CLOU process [Dataset]

  • Filsouf, Amirhossein
  • Adánez-Rubio, Iñaki
  • Mendiara, Teresa
  • Abad Secades, Alberto
  • Adánez Elorza, Juan
Under a Creative Commons BY license 4.0, https://creativecommons.org/licenses/by/4.0/, After 15 h of pine sawdust combustion, in the case of the Cu30MnFe oxygen carrier shows unstable operation in the continuous unit and attributed to the high generation of fines as it can be seen in Figure S1b, where fines particles can be seen together with oxygen carrier particles partially broken. However, it was not detected physical deposition of ashes over the particle surface in both cases of used oxygen carriers Cu30MnFe and Cu30MnFekao7.5, see Figures S1b and S1d, respectively.-- In Figure S2 a uniform distribution of three metal oxides of the oxygen carrier in the fresh Cu30MnFe sample is observed.-- Figure S3 depict the distribution of Cu oxide, Mn oxide, and Fe oxide, which remained unchanged during combustion in the plant. Therefore, there was no interaction between the oxygen carrier Cu30MnFe and biomass ash.-- Figure S3. SEM-EDX mapping of used Cu30MnFe.-- Figure S4 presents SEM-EDX elemental mapping of the fresh Cu30MnFekao7.5. It reveals that Cu oxide, Mn oxide, and Fe oxide are homogeneously distributed within the particle, along with kaolin, which includes Al and Si. K, Mg, and Ca are also present throughout the particle, but are not concentrated in any specific areas.-- Figure S5 presents the SEM-EDX elemental mapping of the used Cu30MnFekao7.5. It shows that K is accumulated in regions containing Al and Si, identified as kaolin. In these areas, the concentration of Cu, Mn, and Fe oxides is low.-- Figure S6 presents BSE images of the two particles of Cu30MnFekao7.5 oxygen carrier after 56 hours of combustion. The EDX results reveal that accumulative K can be observed in the darker areas, particularly where there is a high concentration of kaolin. Specifically, at points 13, 15, 16, and 17, where Si and Al are present in the used oxygen carrier Cu30MnFekao7.5, K is also detected. Conversely, at points 14 and 18, where the concentration of Si and Al, indicative of kaolin, are low and the levels of Cu, Mn, and Fe are high, no K is detected. Additionally, surface-section images in Figs. S6b and S6c show that the amount of K on the surface is significantly lower compared to the interior of the particle.-- Figure S7 presents the SEM line scan image of the cross-section of the used oxygen carrier Cu30MnFekao7.5. The image reveals that K accumulates in regions where Al and Si are present, which corresponds to kaolin within the particle. In these areas, the concentrations of Cu, Mn, and Fe oxides are low, while the concentrations of Si and Al are high.-- Figure S8 presents the SEM-EDX elemental mapping of the surface of the used oxygen carrier, Cu30MnFekao7.5. The analysis indicates the presence of minor amounts of Al and Si on the particle surface, with no significant accumulation of K detected.-- Although in SEM-EDX photos for oxygen carrier Cu30MnFe be observed that metal oxides are distributed homogeneously but in Figure S9, free CuO could be found by XRD. It means this free Cu oxide can improve oxygen transport capacity as active phase compared to the fresh oxygen carrier which data in Table 1 confirm this additional potential to release oxygen., This work was supported by PDC2021-121190-I00/AEI/10.13039/501100011033, financed by MCIN/AEI/10.13039/501100011033 and the European Union NextGenerationEU/PRTR. I.A.-R. acknowledges the Juan de la Cierva Programme (Grant IJC2019-038987-I funded by MCIN/AEI/10.13039/501100011033) and the Ramón y Cajal Programme (Grant RYC2022-035841-I funded by MCIU/AEI/10.13039/501100011033 and FSE+)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Research data Set de datos (Dataset)

Supplementary material for Physicochemical evolution of a Cu/Mn/Fe oxygen carrier in a 50 kWth chemical looping with oxygen uncoupling unit with solid fuels [Dataset]

  • Filsouf, Amirhossein
  • Mendiara, Teresa
  • Adánez-Rubio, Iñaki
  • Izquierdo Pantoja, María Teresa
  • Adánez Elorza, Juan
  • Gayán Sanz, Pilar
  • Abad Secades, Alberto
Under a Creative Commons BY-NC 4.0 International license., Table S1 shows physical properties of oxygen carrier at different operating times. Crushing strength, attrition rate, porosity, density, and magnetic permeability were determined as the function of the fuels, redox cycle and operation time. Table S2 illustrates the phase composition of the fresh oxygen carrier and the transformations that occur during combustion. As observed, free copper oxide disappears, while Cu0.5MnFe1.5O4 becomes the dominant phase, replacing the initial spinel phase Cu0.5Mn0.5Fe2O4. This phase transition indicates a structural evolution in the oxygen carrier during prolonged combustion. Phase analysis was performed on the fines generated during the experiments, as presented in Table S3. The dominant phase in the fines was identified as Cu0.5MnFe1.5O4, which closely aligns with the phase composition of the main oxygen carrier particles under the same test conditions. This similarity suggests that the fines originate primarily from the bulk oxygen carrier material, maintaining a consistent phase structure despite the attrition process., This work was supported by Grant PDC2021-121190-I00 funded by MCIN/AEI/10.13039/501100011033 and by the European Union NextGenerationEU/PRTR. Iñaki Adánez-Rubio acknowledges for “Ramón y Cajal” Program (Grant RYC2022-035841-Ifunded by MCIU/AEI/10.13039/501100011033 and FSE + )., Peer reviewed