Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 1
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Mechanical characterisation of stereolithography-printed TPMS scaffolds: geometry and density property relationships

  • Garzón, Luis
  • Abril, Pedro
  • Cobos Maldonado, Christian
  • Ferrándiz Bou, Santiago|||0000-0001-7137-9298
  • E. Rayón|||0000-0002-0653-2046
[EN] Triply periodic minimal surface (TPMS) lattices were stereolithography-printed to investigate how topology and relative density govern the elastic behaviour of sheet-based architectures. Five TPMS topologies¿Gyroid, Diamond, Schwarz P, Lidinoid, and Split-P¿were mechanically characterised under uniaxial tension and compression across multiple wall-thickness levels. Mechanical properties were first obtained as net-section quantities using the minimum resistant cross-section. Apparent (homogenised) moduli were then reconstructed through a strain-preserving rescaling to the external cross-section, ensuring compatibility with continuum-level scaling. Relative density was defined purely on a volumetric basis from the exact implicit geometry. Crucially, the solid resin modulus, E<sub>S</sub>, was measured experimentally on fully dense specimens with the same external gauge dimensions as the TPMS tensile samples, yielding a metrologically consistent normalisation, E¿/E<sub>S</sub>. Within this framework, linearised Gibson¿Ashby fits reveal topology-dependent scaling that is robust to the choice of E<sub>S</sub>. Diamond is the topology closest to stretching-assisted behaviour, whereas Gyroid and Schwarz P are bending-dominated. Split-P lies near the bending limit, while Lidinoid exhibits an extreme bending-controlled response with pronounced geometric inefficiencies. In terms of geometric efficiency, the prefactors rank as Schwarz P > Gyroid > Lidinoid > Diamond > Split-P, demonstrating that increases in relative density or wall thickness do not necessarily produce proportional gains in stiffness for sheet-based TPMS architectures. This study provides a traceable, topology-centred methodology together with design guidelines that are directly transferable to other photopolymers and loading modes, provided that the same volumetric-density definition and strain-preserving reconstruction principles are employed., This research was supported by the Research Council of the Universidad Politécnica SalesianaGrant No. 006-003-2023-06-08.