Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

MC3T3-E1 cell response to microporous tantalum oxide surfaces enriched with Ca, P and Mg

  • Alves, C. F. Almeida
  • Fialho, L.
  • Marques, S. M.
  • Pires, S.
  • Palacio, C.
  • Carvalho, S.
  • Rico Tortosa, Patricia María
[EN] The formation of a porous oxide surface doped with osteoconductive elements, Ca, P and Mg, to enhance osseointegration, was achieved through micro arc oxidation. Micro arc oxidation parameters, such as electrolyte composition, concentration and applied voltage, were studied to understand their effect on the morphology and chemical composition of the samples surface.& nbsp; Considering the optimum atomic concentration reported in literature for each osteoconductive element, microporous Ta anodic oxide samples treated with calcium acetate (CaA) and 13-glycerophosphate (13-GP) revealed that an increase of 13-GP molarity in the electrolyte boosts Ca incorporation, as well as, increasing the porosity. In adding magnesium acetate (MgA) to the electrolyte, when composed by CaA + 13-GP, both addition and variation of MgA did not affect the surface morphology along the samples, being incorporated into the oxide layer for 0.1 M.& nbsp; Finally, in vitro tests were carried out to study the biocompatibility of Ta, to verify the cytotoxicity of the samples and their behavior towards cells, by performing adhesion and differentiation tests with the MC3T3-E1 cell line. Cytotoxicity tests revealed that the samples were non-toxic. Despite none of the samples having been raised up through cell adhesion tests, cell differentiation revealed promising results for the Ta-CaP., This research is sponsored by FEDER funds through the program COMPETE -Programa Operacional Factores de Competitividade and by the Portuguese Foundation for Science and Technology (FCT) in the framework of the Strategic Funding UIDB/04650/2020, and UID/EMS/00285/2020 and with a PhD fellowship SFRH/BD/98199/2013. The authors also thank the financial support in the framework of HEALTHYDENT -POCI-01-0145-FEDER-030708, PTDC/CTM-NAN/4242/2014 projects and On-SURF (co-financed via FEDER (PT2020) POCI-01-0247-FEDER-024521) projects. The authors would like to acknowledge that this project has received funding from the EU Framework Programme for Research and Innovation H2020, scheme COFUND - Co-funding of Regional, National and International Programmes, under Grant Agreement 713640.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Giant Voc Boost of Low-Temperature Annealed Cu(In,Ga)Se2 with Sputtered Zn(O,S) Buffers

  • Zutter, Marco
  • Virtuoso, Jose
  • Anacleto, Pedro
  • Yasin, Liam
  • Alves, Marina
  • Madeira, Miguel
  • Bondarchuk, Oleksandr
  • Mitra, Saibal
  • Fuster, David
  • García Martínez, Jorge Manuel
  • Briones Fernández-Pola, Fernando
  • Waechter, Rolf
  • Kiowski, Oliver
  • Hariskos, Dimitrios
  • Colombara, Diego
  • Sadewasser, Sascha
Large-scale industrial fabrication of Cu(In,Ga)Se (CIGS) photovoltaic panels would benefit significantly if the buffer layer chemical bath deposition could be replaced by a cadmium-free dry vacuum process suitable for in-line production. This Letter reports on the development of a Zn(O,S) buffer layer deposited by vacuum-based magnetron sputtering from a single target onto commercial CIGS absorbers cut from a module-size glass/Mo/CIGS stack. The buffer-window stack consisting of Zn(OS)/i-ZnO/ZnO:Al is optimized for layer thickness and optical and electronic properties, leading to an average device efficiency of 4.7%, which can be improved by annealing at 200 °C to a maximum of 10.5%, mainly due to a considerable increase in the open-circuit voltage (V). Temperature-dependent current density versus voltage (J–V) characteristics show a reduced interface recombination upon annealing, explaining the observed V boost. Quantum efficiency shows improvements in the long and short wavelength region, setting in at different annealing temperatures, and photoemission depth profiling indicates interdiffusion of all atomic species at the CIGS/Zn(O,S) interface. Electrical device simulations explain the observed effects by a modification of the band offset at the interface and defects passivation. Both effects are attributed to the observed interdiffusion during annealing., This work was partially supported by the European Union's Horizon 2020 research and innovation program under grant agreement No. 641004 (project Sharc25). The authors acknowledge additional support by the Spanish project AIC‐B‐2011‐0806, and by the “Micro‐concentrator thin film solar cells (MiconCell)” project (028922) and the “Correlated Analysis of Inorganic Solar Cells in and outside an Electron Microscope (CASOLEM)” project (028917), both co‐funded by FCT and ERDF through COMPETE2020. DC acknowledges the European Commission for funding the NanoTrainforGrowth II project No. 713640 through the Marie Curie Cofund programme.