Pasar al contenido principal

NALISIS DE LA PLANTILLA DEPORTIVA: PREFABRICADAS VS PERSONALIZAS SOBRE PARAMETROS BIOMECANICOS EN FATIGA DURANTE LA CARRERA

DEP2013-48420-P

•
Nombre agencia financiadora Ministerio de Economía y Competitividad
Acrónimo agencia financiadora MINECO
Programa Programa Estatal de Fomento de la Investigación Científica y Técnica de Excelencia
Subprograma Subprograma Estatal de Generación de Conocimiento
Convocatoria Proyectos de I+D (Excelencia / Generación de Conocimiento)
Año convocatoria 2013
Plan Estatal 2013-2016 Plan Estatal de Investigación Científica y Técnica y de Innovación
Unidad de gestión Secretaría de Estado de Educación, Formación Profesional y Universidades
Centro beneficiario UNIVERSITAT DE VALÈNCIA
Identificador persistente http://dx.doi.org/10.13039/501100003329

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

The location of the tibial accelerometer does influence impact acceleration parameters during running

  • Lucas Cuevas, Ángel Gabriel
  • Encarnacion Martinez, Alberto
  • Llana Belloch, Salvador
  • Pérez Soriano, Pedro
  • Camacho-García, Andrés|||0000-0001-8542-4264
Tibial accelerations have been associated with a number of running injuries. However, studies attaching the tibial accelerometer on the proximal section are as numerous as those attaching the accelerometer on the distal section. This study aimed to investigate whether accelerometer location influences acceleration parameters commonly reported in running literature. To fulfil this purpose, 30 athletes ran at 2.22, 2.78 and 3.33 m · s–1 with three accelerometers attached with double-sided tape and tightened to the participants’ tolerance on the forehead, the proximal section of the tibia and the distal section of the tibia. Time-domain (peak acceleration, shock attenuation) and frequency-domain parameters (peak frequency, peak power, signal magnitude and shock attenuation in both the low and high frequency ranges) were calculated for each of the tibial locations. The distal accelerometer registered greater tibial acceleration peak and shock attenuation compared to the proximal accelerometer. With respect to the frequency-domain analysis, the distal accelerometer provided greater values of all the low-frequency parameters, whereas no difference was observed for the high-frequency parameters. These findings suggest that the location of the tibial accelerometer does influence the acceleration signal parameters, and thus, researchers should carefully consider the location they choose to place the accelerometer so that equivalent comparisons across studies can be made. © 2016 Informa UK Limited, trading as Taylor & Francis Group, This study was supported by the Spanish Government [Ministerio de Educacion, Cultura y Deporte, Grant FPU12/00574; and Ministerio de Economia y Competitividad, Subdireccion General de Proyectos de Investigacion, Convocatoria Proyectos I+D "Excelencia", Subprograma de Generacion de Conocimiento, 2013, Grant DEP2013-48420-P].
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Influence of custom-made and prefabricated insoles before and after an intense run

  • Lucas-Cuevas, Ángel
  • Priego Quesada, Jose Ignacio
  • Llana-Belloch, Salvador
  • Pérez Soriano, Pedro
  • Camacho-García, Andrés|||0000-0001-8542-4264
  • Llinares Llopis, Raúl|||0000-0002-9732-2262
[EN] Each time the foot contacts the ground during running there is a rapid deceleration that results in a shock wave that is transmitted from the foot to the head. The fatigue of the musculoskeletal system during running may decrease the ability of the body to absorb those shock waves and increase the risk of injury. Insoles are commonly prescribed to prevent injuries, and both custom-made and prefabricated insoles have been observed to reduce shock accelerations during running. However, no study to date has included a direct comparison of their behaviour measured over the same group of athletes, and therefore great controversy still exists regarding their effectiveness in reducing impact loading during running. The aim of the study was to analyse the acute differences in stride and shock parameters while running on a treadmill with custom-made and prefabricated insoles. Stride parameters (stride length, stride rate) and shock acceleration parameters (head and tibial peak acceleration, shock magnitude, acceleration rate, and shock attenuation) were measured using two triaxial accelerometers in 38 runners at 3.33 m/s before and after a 15-min intense run while using the sock liner of the shoe (control condition), prefabricated insoles and custom-made insoles. No differences in shock accelerations were found between the custom-made and the control insoles. The prefabricated insoles increased the head acceleration rate (post-fatigue, p = 0.029) compared to the control condition. The custom-made reduced tibial (pre-fatigue, p = 0.041) and head acceleration rates (pre-fatigue and post-fatigue, p = 0.01 and p = 0.046) compared to the prefabricated insoles. Neither the stride nor the acceleration parameters were modified as a result of the intense run. In the present study, the acute use of insoles (custom-made, prefabricated) did not reduce shock accelerations compared to the control insoles. Therefore, their effectiveness at protecting against injuries associated with elevated accelerations is not supported and remains unclear., This work was supported by the Spanish Government (Ministerio de Educacion, Cultura y Deporte, Grant FPU; and Ministerio de Economia y Competitividad, Subdireccion General de Proyectos de Investigacion, Convocatoria Proyectos I+D Excelencia, Subprograma de Generacion de Conocimiento, 2013, Grant DEP2013-48420-P).