Pasar al contenido principal

TECTONICA, FLUJO TERMICO Y EVOLUCION PLANETARIA DE MARTE

PGC2018-095340-B-I00

•
Nombre agencia financiadora Agencia Estatal de Investigación
Acrónimo agencia financiadora AEI
Programa Programa Estatal de Generación de Conocimiento y Fortalecimiento Científico y Tecnológico del Sistema de I+D+i
Subprograma Subprograma Estatal de Generación de Conocimiento
Convocatoria Proyectos de I+D (Excelencia / Generación de Conocimiento)
Año convocatoria 2018
Plan Estatal 2017-2020 Plan Estatal de Investigación Científica y Técnica y de Innovación
Centro beneficiario UNIVERSIDAD COMPLUTENSE DE MADRID

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

Docta Complutense
Publicación Artículo científico (JournalArticle)

Subsurface Geometry and Emplacement Conditions of a Giant Dike System in Elysium Fossae, Mars

  • Rivas, Samuel
  • Ruiz Pérez, Javier
  • Romeo Briones, Ignacio
Elysium Fossae is a NW-SE, 350 km-long linear graben system located in the eastern flank of Elysium Mons, Mars. Graben widths, lengths, and topographic data were used to model the thicknesses, depths, heights, and excess pressures of a possible dike system underneath these grabens. Area balance on topographic profiles across the structures reveals dikes at depths of 241–2,330 m below the surface, with average thicknesses <60 m, and heights of 15–20 km. These heights are approximately three times larger than terrestrial dikes intruded in the shallow crust. The subsurface properties suggest a teardrop-shape geometry for the dikes, which has been observed in many theoretical and analog dike models. Additionally, the aspect ratios (thicknesses and lengths) of the inferred dikes are consistent with sublinear scaling, characteristic of fluid-induced fractures. The obtained critical stress intensity factors (Kic) are between 3.14 and 15.15 GPa·m1/2 and are slightly higher than those of terrestrial dikes intruded in similar lithologies. The maximum excess pressures calculated from stress intensity factors are between 31 and 276 MPa. These are also consistent with pressures calculated for terrestrial dikes despite the greater aperture and height of the Elysium dikes. Theoretical calculations of excess pressures for variable dike heights support both the values calculated from empirical observations, and that Martian dike heights may consistently be three times the heights of terrestrial dikes. In summary, this work supports: (1) the existence of a dike system underneath Elysium and (2) that dike heights in rocky planets may scale inversely with gravitational acceleration.
Docta Complutense
Publicación Artículo científico (JournalArticle)

Giant dikes and dike-induced seismicity in a weak crust underneath Cerberus Fossae, Mars

  • Rivas Dorado, Samuel
  • Ruiz Pérez, Javier
  • Romeo Briones, Ignacio
Cerberus Fossae is a long and narrow graben system located approximately 1000 km southeast of Elysium Mons, Mars. These structures have long been thought to be dike-induced, and are the focus of renewed attention due to the detection of seismic activity in this area by InSight. Here we report that structural modeling and linear elastic fracture mechanics provide strong evidence that the Cerberus Fossae grabens are dike-related structures, and that their intrusion may have released significant amounts of seismic energy. The modeled dike apertures are between ∼175 and 750 m, and their aspect ratios are consistent with fluid-induced fractures formed in a weakened host rock. We observe densely fractured terrains in high-resolution images of the graben walls, confirming the presence of a weakened crust underneath Cerberus. We used dike geometry and plausible mechanical properties to calculate the source moment released by dike opening and inflation in two scenarios; using the present-day dike dimensions (Md) and in dikes with downscaled sizes to represent smaller intrusions (md). These yielded values between 2.7⋅1016 and 1.3 1021 Nm. From these we estimate that the Cerberus diking events may have expressed seismically through a marsquake series with cumulative moment magnitudes (Mw) between 4.6 and 7.8. InSight has so far detected seismic events with Mw magnitudes as low as 1. Therefore, these results suggest that if the emplacement of even smaller dikes than those inferred below Cerberus is currently taking place, intrusion-induced seismicity could be detected by InSight.
Docta Complutense
Publicación Artículo científico (JournalArticle)

Lithospheric Contraction on Mars: A 3D Model of the Amenthes Thrust Fault System

  • Herrero Gil, Andrea
  • Ruiz Pérez, Javier
  • Romeo Briones, Ignacio
Amenthes Rupes is the topographic expression of a main fault belonging to a thrust fault system located parallel to the martian dichotomy boundary. A 3D forward model has been applied to the Amenthes thrust fault system, constraining fault geometries at depth, variations of slip along strike, and structural parameters controlling the formation of fault propagation folds. Our results provide a complex 3D view of the tectonic framework of the area, with implications for tectonic evolution, regional shortening distribution, and the main mechanical discontinuities in the lithosphere. The modeled fault surfaces show planar morphologies combined with listric geometries at depth. The obtained depths of faulting for the major faults of this fault system suggest a depth of the brittle‐ductile transition (at the time of formation) of 20–24 km, somewhat shallower than previous estimates for this area. A possible mechanical discontinuity located at 10.5–13 km deep can be deduced from the faulting depths of the secondary faults. The listric geometries at depth imply that slip is transmitted from the decollement, which, together with the inclusion in the model of secondary and subsidiary faults, allow us to estimate the horizontal shortening recorded in this area ranging from 2–3 km up to ~5.5 km in the southeastern part of the fault system. This range increases the previous shortening estimates in this area between ~60% and ~200%. Consequently, global shortening estimates based on global fault maps are biased by the detail of mapping, and shortening would substantially increase if secondary faults were included.
Docta Complutense
Publicación Artículo científico (JournalArticle)

3D modeling of planetary lobate scarps: The case of Ogygis Rupes, Mars

  • Herrero Gil, Andrea
  • Ruiz Pérez, Javier
  • Romeo Briones, Ignacio
Lobate scarps are the topographic expression of the largest thrust faults observed on the surfaces of terrestrial planets and their study provides information on the mechanical characteristics of the lithosphere at the time of formation. Here we show the results of 3D modeling of Ogygis Rupes, located in Aonia Terra, which is one of the most topographically pronounced lobate scarps described in the cratered martian highlands. The observed relief of Ogygis Rupes has been modeled by a combination of Trishear and Fault Parallel Flow algorithms, providing a successful reproduction of the observed topography through a 3D modeling that includes the main thrust fault, forming the lobate scarp relief, and two subsidiary backthrusts. This recreation allows us to interpret Ogygis Rupes relief, modeling the fault propagation folding, and constraining fault parameters and their variations along strike. The detailed slip distribution along the three faults reflects a general decay from the center to the edges for each fault, with the maximum slip value (2850 m) located approximately at the center of the main fault. The fault surfaces obtained for the main thrust fault and the two backthrusts show listric geometries at depth. The decollement where the main fault roots is set at ∼17–18 km deep, related to a main rheological threshold that on Mars is interpreted to be the depth of the Brittle-Ductile Transition at the time of the lobate scarp formation (Late Noachian/Early Hesperian). The listric morphology of the main fault implies that the total slip associated with this thrust fault is transmitted from the decollement, being representative of the regional shortening associated with the lobate scarp formation. Otherwise, the modeled backthrusts are subsidiary listric faults rooting at shallower depths (2.3–5.6 km), probably indicating the presence of mechanical discontinuities in the brittle domain of the martian lithosphere.
RODIN. Repositorio de Objetos de Docencia e Investigación de la Universidad de Cádiz
Publicación Artículo científico (JournalArticle)

Lithospheric contraction concentric to Tharsis: 3D structural modeling of large thrust faults between Thaumasia highlands and Aonia Terra, Mars

  • Herrero Gil, Andrea
  • Egea González, María Isabel
  • Jiménez Díaz, Alberto
  • Rivas Dorado, Samuel
  • Parro, Laura
  • Fernández, Carlos
  • Ruiz, Javier
  • Romeo, Ignacio
Large thrust faults on Mars are caused by lithospheric planetary contraction. The geometry of these faults is linked with the mechanical behavior of the lithosphere. Tharsis, the largest volcano-tectonic province on Mars, controls the global tectonic pattern of the planet. Here, we present a study of five large thrust faults concentric to Tharsis, located between the Thaumasia Highlands and the Argyre impact basin. We applied a 3D structural modeling, using a combination of fault-parallel flow and trishear algorithms to estimate the geometry and kinematics of the faults at depth. The modeled faults show an upper planar part dipping 33◦ to 40◦, rooting with a listric geometry into horizontal levels at 13–27 km depth, with fault slips of 801–3366 m. The general out-ofTharsis vergence, the listric fault geometries and the deepening of the depth of faulting toward Thaumasia outline an incipient thrust wedge architecture. Assuming that the largest faults rooted at the Brittle-Ductile Transition, we calculate a heat flow at the time of faulting of 24–54 mW m− 2. The obtained strength envelopes for dry and wet conditions show that all the strength of the lithosphere was located in the upper half of the crust.
RODIN. Repositorio de Objetos de Docencia e Investigación de la Universidad de Cádiz
Publicación Artículo científico (JournalArticle)

The stability of a liquid-water body below the south polar cap of Mars

  • Egea González, María Isabel
  • Lois, Paula
  • Jiménez Díaz, Alberto
  • Bramson, Ali
  • Sori, Michael
  • Tendero Ventanas, Juan Ángel
  • Ruiz, Javier
Radar data from the Mars Express spacecraft show bright subsurface reflections in the Planum Australe area that could be due to liquid water located at a depth of 1.5 km (Orosei et al., 2018). If this interpretation of the data is correct, the presence of such water would have important implications for the present-day thermal state of the region. In this article, we recalculate the depth of the liquid water and we analyze the influence of the regional thermal properties in the surface heat flow and the subsurface temperatures. We have obtained a new depth to the bright reflector between 1.3 and 1.5 km by using a temperature dependent relative permittivity for the water ice and taking into account the dust content in the area. We show that regional properties in the SPLD moderately influence the thermal state of the area where the liquid water is located. A better knowledge of the porosity profile in the studied area is necessary to constrain surface heat flow and subsurface temperatures accurately. Our findings are in agreement with previous work that shows anomalously high local heat flows would be required to sustain liquid water at this location.