Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 9
Encontrada(s) 1 página(s)

Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Artículo científico (JournalArticle)

Comprehensive characterisation of a low-frequency-vibration energy harvester

  • Plaza Puértolas, Aitor
  • Iriarte Goñi, Xabier
  • Castellano Aldave, Jesús Carlos
  • Carlosena García, Alfonso
In this paper, we describe a measurement procedure to fully characterise a novel vibration energy harvester operating in the ultra-low-frequency range. The procedure, which is more thorough than those usually found in the literature, comprises three main stages: modelling, experimental characterisation and parameter identification. Modelling is accomplished in two alternative ways, a physical model (white box) and a mixed one (black box), which model the magnetic interaction via Fourier series. The experimental measurements include not only the input (acceleration)–output (energy) response but also the (internal) dynamic behaviour of the system, making use of a synchronised image processing and signal acquisition system. The identification procedure, based on maximum likelihood, estimates all the relevant parameters to characterise the system to simulate its behaviour and helps to optimise its performance. While the method is custom-designed for a particular harvester, the comprehensive approach and most of its procedures can be applied to similar harvesters., This work has been supported by the Spanish Research Agency, and the EU/PTR Next Generation Funds under grants PID2019-107258RB-C32 and TED2021-131052B-C21, and also by the Government of Spain (Plan Estatal de Investigación Científica, Técnica y de Innovación 2021–2023) under grants PID2022-138491OB-C32 and PDC 2023-145876-C22.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Artículo científico (JournalArticle)

Power converter for ultra low-frequency and low-voltage energy harvesters

  • Hualde Otamendi, Mikel
  • Cruz Blas, Carlos Aristóteles de la
  • Castellano Aldave, Jesús Carlos
  • Carlosena García, Alfonso
Energy conversion mechanisms present in some harvesters are only able to provide very low voltage (mV) and fre‑ quency (few Hz) electrical signals, which may also have a bipolar nature (AC). These characteristics make unusable most conventional power converters to extract from them a DC voltage. This letter describes an autonomous selfstarting ultra-low voltage and frequency AC-DC converter that can start the operation for AC signals around 25 mV, and below 10 Hz. The converter has been designed with ultra-low vibration harvesters in mind, but is also of appli‑ cation to, for instance, thermoelectric generators (TEG). The circuit is basically an oscillator driven by the harvester output, which therefore converts a low-frequency and low-voltage signal into large signal oscillation amenable for further DC conversion. The proposed circuit is based on the classical Hartley oscillator, which is modifed in a non‑ trivial confguration, and optimized to be able to operate with bipolar, low frequency and voltage driving signals. This is achieved with a minimum number of passive components and a single JFET transistor. A practical prototype has been fabricated, and measurement results are obtained, demonstrating the feasibility of the approach. Moreover, a vibration harvester with the power converter proposed has been tested in real conditions in a wind turbine., This work was supported by Spanish Research Agency, the EU/PTR Next Generation Funds and European Social Fund Plus (ESF+), under Grant TED2021-131052B-C21, Grant PID2022-138491OB-C32 and Grant PID2022-138510OB-C21.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Artículo científico (JournalArticle)

Low-power capacitively coupled AC amplifiers with tunable ultra low-frequency operation

  • Martincorena Arraiza, Maite
  • Cruz Blas, Carlos Aristóteles de la
  • Carlosena García, Alfonso
This paper proposes two novel and compact low-power tunable AC amplifiers with ultra-low high-pass corner frequency. The circuits are based on alternative AC capacitively coupled feedback topologies using novel implementations leading to better performance in terms of area, power and noise efficiency. This is accomplished by a combination of actively boosting the resistive value of a pseudo-resistor (allowing more than two decades of tuning) and an optimization of the active devices required. Measurement results from a fabricated prototype using a 0.18µm technology are provided to demonstrate the technique. The proposed amplifiers can provide tunable high-pass corner frequencies ranging from 31 mHz to 7 Hz, with power consumption as low as 0.425 µW, CMRR of 84 dB, 0.1 mm2 area, 39.7 dB gain, and integrated IRN of 2.42 µVrms., This work was supported in part by the Spanish Research Agency and the EU under Grant AEI/FEDER PID2019-107258RB-C32 and in part by the European Union/Pland de Recuperación, Transformación y Resiliencia (EU/PRTR) Next Generation Funds under Grant TED2021-131052B-C21.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Artículo científico (JournalArticle)

Seasonality in synthetic average wind speed

  • Zivanovic, Miroslav
  • Runacres, Mark
There is a growing demand for computer-generated realistic high-fidelity wind speed data for various applications in the wind industry. Such data should capture the non-stationary dynamics of real-world wind time series, as well as be consistent with the statistical descriptors - the probability density function and power spectral density - of the observed wind speed. However, complying with the statistical descriptors is not a guarantee that the seasonality will be correctly reproduced in synthetic data. The seasonality, characterized by the average diurnal and seasonal variations, is driven by the periodicities embedded in diurnal and annual harmonic series respectively. Those periodicities are determined by the long-term orbital forcing components, which establish the insolation for a given latitude and longitude. We show that average diurnal and seasonal variations can be visualized as the output of comb filters, whose fundamental frequencies match the diurnal and annual fundamental frequency respectively. The aforementioned theoretical findings are readily reproduced in synthetic wind speed, generated by a non-parametric data-driven statistical model, based on the phase-randomized Fourier transform. The model, tested on both 10-min and 1-min resolution real-world datasets, yields average non-stationarities in synthetic wind speed with the accuracy close to the computing precision., Funding text 1: This work has been supported by the Spanish Research Agency, and the EU/PTR Next Generation Funds under grants TED2021-131052B-C21, and PID2022-138491OB-C32.; Funding text 2: This work has been supported by the Spanish Research Agency, and the EU/PTR Next Generation Funds under grants TED2021-131052B-C21, and PID2022-138491OB-C32.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Artículo científico (JournalArticle)

Hybrid modelling and identification of mechanical systems using Physics-Enhanced Machine Learning

  • Merino Olagüe, Mikel
  • Iriarte Goñi, Xabier
  • Castellano Aldave, Jesús Carlos
  • Plaza Puértolas, Aitor
Obtaining mathematical models for mechanical systems is a key subject in engineering. These models are essential for calculation, simulation and design tasks, and they are usually obtained from physical principles or by fitting a black-box parametric input-output model to experimental data. However, both methodologies have some limitations: physics based models may not take some phenomena into account and black-box models are complicated to interpretate. In this work, we develop a novel methodology based on discrepancy modelling, which combines physical principles with neural networks to model mechanical systems with partially unknown or unmodelled physics. Two different mechanical systems with partially unknown dynamics are successfully modelled and the values of their physical parameters are obtained. Furthermore, the obtained models enable numerical integration for future state prediction, linearization and the possibility of varying the values of the physical parameters. The results show how a hybrid methodology provides accurate and interpretable models for mechanical systems when some physical information is missing. In essence, the presented methodology is a tool to obtain better mathematical models, which could be used for analysis, simulation and design tasks., This paper has been supported by the Public University of Navarre under grant PJUPNA2024-11690, and also by the Spanish Research Agency under grants PDC2023-145876-C22, PID2022-138510OB-C21, TED2021-131052B-C21. Open access funding provided by Universidad Pública de Navarra.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Artículo científico (JournalArticle)

Low-frequency electromagnetic harvester for wind turbine vibrations

  • Castellano Aldave, Jesús Carlos
  • Plaza Puértolas, Aitor
  • Iriarte Goñi, Xabier
  • Carlosena García, Alfonso
In this paper we describe and fully characterize a novel vibration harvester intended to harness energy from the vibration of a wind turbine (WT), to potentially supply power to sensing nodes oriented to structural health monitoring (SHM). The harvester is based on electromagnetic conversion (EM) and can work with vibrations of ultra-low frequencies in any direction of a plane. The harvester bases on a first prototype already disclosed by the authors, but in this paper, we develop an accurate model parameterized by a combination of physical parameters and others related to the geometry of the device. The model allows predicting not only the power generation capabilities, but also the kinematic behaviour of the harvester. Model parameters are estimated by an identification procedure and validated experimentally. Last, the harvester is tested in real conditions on a wind turbine., This paper has been supported by the Spanish Research Agency, and the EU/PTR Next Generation Funds under grants PID2019-107258RBC32, TED2021-131052B-C21, and PID2022-138491OB-C32. The Public University of Navarre has also partially supported this project under grant: PJUPNA2024-11690.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Artículo científico (JournalArticle)

Very-low frequency capacitively coupled AC amplifier with a current feedback operational amplifier

  • Beloso Legarra, Javier
  • Cruz Blas, Carlos Aristóteles de la
  • Carlosena García, Alfonso
  • Martincorena Arraiza, Maite
In this paper, we propose the idea of using transimpedance amplifiers, in lieu of operational amplifiers (OAs) or transconductance amplifiers (OTAs) to design capacitively coupled AC amplifiers. The idea is demonstrated with a current feedback operational amplifier (CFOA) as an active element, which is actually an architecture consisting of voltage buffers and current copiers (mirrors). This last characteristic is further exploited to make the corner frequency of the AC amplifier tunable by means of bootstrapping low-valued resistors with the output buffer. It is particularly suited to achieve very-low corner frequencies as needed in applications such as bio- or seismic signals. The idea is demonstrated with simulations and experimental results with a discrete implementation., This work has been supported by theSpanish Research Agency, under grantAEI/FEDER PID2019-107258RB-C32, andby the Spanish Research Agency and theEU/PTR Next Generation Funds, undergrant TED2021-131052B-C21, AgenciaEstatal de Investigaci on, Ministerio deCiencia e Innovaci on, Open accessfunding provided by Universidad Públicade Navarra.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Artículo científico (JournalArticle)

A novel ultra-low input voltage and frequency self astarting AC-DC boost converter for micro energy harvesting

  • Castellano Aldave, Jesús Carlos
  • Cruz Blas, Carlos Aristóteles de la
  • Carlosena García, Alfonso
In this letter, a novel low-voltage junction field-effect transistor (JFET) oscillator with self-starting capability to implement an ac-dc boost converter is introduced. The circuit is transformer free and can operate with very low-voltage and low-frequency signals. In order to operate with positive and negative input signals, a coupled topology of JFETs has been used. The circuit has been built using off the shelf components, and can be used with electromagnetic harvesters, thermoelectric modules, and/or wearable devices. Experimental results with a practical harvester are provided in order to demonstrate the proposed ac-dc boost converter., This work was supported by Spanish Research Agency and the EU/PTR Next Generation Funds, under Grant TED2021-131052B-C21, Grant PID2019-107258RB-C32, and Grant PID2022-138491OB-C32.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Artículo científico (JournalArticle)

Main shaft instantaneous azimuth estimation for wind turbines

  • Zivanovic, Miroslav
  • Vilella San Martín, Íñigo
  • Iriarte Goñi, Xabier
  • Plaza Puértolas, Aitor
  • Gainza González, Gorka
  • Carlosena García, Alfonso
We present a novel approach to estimating the instantaneous main shaft angular position in the context of wind turbine structural health monitoring. We show that only two IMU channels - gyroscope axial and accelerometer tangential - contain enough information to build an acceleration state-space model that properly captures the rotational dynamics of a wind turbine. The kernel of the model is an in-phase and quadrature time-varying sinusoid whose argument is driven by the integral of the gyroscope output. This approach clearly stands in contrast to most state-of-the-art methods, where the gyroscope output is explicitly modeled. The model equation describes the states dynamics, which simultaneously assesses the instantaneous amplitude and initial phase of the angular displacement through a first-order autoregressive process. Such a state-space model features only two states per time instant; furthermore, it is linear-in-states and therefore straightforwardly estimated by the linear Kalman filter. It is shown that the instantaneous azimuth estimates obtained from the state-space model, linearly combined with the gyroscope output, effectively cancel out the long-term drift in the estimate. The benchmark results suggest that the proposed method outperforms a state-of-the-art method, in terms of robustness against noise and adaptability to changing operating regimes in a wind turbine., This work has been supported by the Spanish Research Agency, under grant AEI/FEDER PID2019-107258RB-C32, the EU/PTR Next Generation Funds, under grant TED2021-131052B-C21, and the Government of Navarre under grant 0011-1365-2021-000199.