Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Capítulo o parte de un libro (BookPart)

Behavior of innovative T-shaped multi-partition steel-concrete composite columns under concentric and eccentric compressive loadings

  • Chen, Jie
  • Zhang, Sumei
  • Huang, Zhenfeng
  • Zhang, Xiongxiong
  • Guo, Lanhui
[EN] T-shaped multi-partition steel-concrete composite column, composed of several concrete-filled rectangular steel hollow sections, is considered as an innovative composite member with the ability to accommodate neighboring wall thickness with great easiness. This paper intends to study the behavior of this innovative composite member under concentric and eccentric compressive loadings. A finite element (FE) analysis model accounting for the influences of confinement effects, geometric and material nonlinearities is developed using the program ABAQUS. The ultimate strength and load-strain responses predicted from the analysis are validated against the test results in the experiments conducted by the authors. The comparisons indicate that the FE model reasonably estimates the responses of the concentrically and eccentrically loaded T-shaped multi-partition steel-concrete composite columns. The verified model is then utilized to numerically investigate the working mechanism of the columns. The load distribution between the infilled concrete and the steel tubes and the stress distribution of the concrete during the loading process are analyzed. Moreover, parametric studies are performed to investigate the behavior of T-shaped multi-partition steel-concrete composite columns under different loadings. The studied parameters include steel to concrete area ratio, concrete compressive strength, steel yield strength and load eccentricity. Combined with the experimental results, FE analysis and parametric studies, the design recommendations for T-shaped multi-partition steel-concrete composite columns under different loadings are proposed., The research work reported in this paper were supported by National Key Research and Development Program (2016YFC0701201), and National Natural Science Foundation of China (Grant No. 51578187); their financial supports are highly appreciated.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Capítulo o parte de un libro (BookPart)

Flexural behavior of steel-concrete composite beams with U-shaped steel girders

  • Liu, Yong
  • Guo, Lanhui
  • Li, Zhiguo
[EN] This paper focuses on a new type of steel-concrete composite beams consisting of U-shaped steel girders and angle connectors. Compared with conventional composite beams consisting of wide flange girders and headed stud connectors (or short channel connectors), the composite beams considered in this study have favorable flexural performance while reducing the excessive costs and potential construction challenges due to installation of the stud and/or channel shear connectors. Through four-point bending tests on five specimens, this research team experimentally investigated flexural behavior of such new composite beams. The five specimens were varied to have different angle connector intervals and installation locations. Test results showed that composite beams with angle connectors welded to the webs of U-shaped steel girder failed in brittle failure modes while composite beams with angle connectors welded on the top flange of U-shaped steel girder failed in ductile failure mode. Moreover, finite element analysis were performed and the results were verified by the experimental results. According to the parametric analysis results, concrete strength has little effect on flexural behavior of composite beams while increasing yield stress of steel girder could significantly increase the flexural resistance but could not change the initial stiffness. Increasing the height of steel girder, the thickness and width of bottom flange are recommended to improve the flexural behavior of composite beams., This research was financially supported by the Jilin Provincial Science & Technology Development Project Agreement (20180201031SF) and the National Natural Science Foundation of China under Awards No. 51578187.