Pasar al contenido principal

THE VARIABILITY CHALLENGE IN NANO-CMOS: FROM DEVICE MODELING TO IC DESIGN FOR MITIGATION AND EXPLOITATION (VIGILANT-IMSE)

PID2019-103869RB-C31

•
Nombre agencia financiadora Agencia Estatal de Investigación
Acrónimo agencia financiadora AEI
Programa Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Convocatoria Proyectos de I+D+i (Generación de Conocimiento y Retos Investigación)
Año convocatoria 2019
Plan Estatal 2017-2020 Plan Estatal de Investigación Científica y Técnica y de Innovación
Centro beneficiario UNIVERSIDAD DE SEVILLA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Otros (Other)

Characterizing BTI and HCD in 1.2V 65nm CMOS Oscillators made from Combinational Standard Cells and Processor Logic Paths

  • Van Santen, Victor M.
  • Gata-Romero, José M.
  • Núñez, Juan
  • Castro-López, Rafael
  • Roca, Elisenda
  • Amrouch, Hussam
Trabajo presentado en el 2023 IEEE International Reliability Physics Symposium (IRPS), 26-30 March 2023, Monterey, CA, USA ., Bias Temperature Instability (BTI) and Hot-Carrier Degradation (HCD) are key aging mechanisms, frequently studied with transistor measurements or inverter-based (INV) Ring Oscillators (RO) measurements. However, large-scale digital circuits are typically manufactured with standard cells (such as logic gates). In a reliability simulation flow (e.g., SPICE-based standard cell characterization with degraded transistors), many assumptions about the standard cells have to be made (such as load capacitance, signal slews, uncertainty in aging models, etc.) and can lead to high simulation uncertainty. In this work, we propose to verify this standard cell characterization with standard cell oscillator measurements in silicon. For this purpose, we present the following novel contributions: 1) The first work with BTI and HCD measurements of heterogeneous oscillators (multiple different cell types in one RO) based on logic paths extracted from processors. 2) The first work exploring the impact of BTI and HCD on oscillators containing combinational standard cells, i.e. single cells incorporating multiple logic gates (such as And-Or-Inverter (AOI) cells and Or-And-Inverter (OAI)) and cells performing complex actions such as full-adders., This work was supported in part by the German Research Foundation (DFG) “ACCROSS: Approximate Computing aCROss the System Stack” and in part by MCIN/AEI/10.13039/501100011033 under Grant PID2019-103869RBC31., Peer reviewed
Dipòsit Digital de Documents de la UAB
Publicación Capítulo o parte de un libro (BookPart)

Challenges and solutions to the defect-centric modeling and circuit simulation of time-dependent variability

  • Martin-Martinez, J.|||0000-0001-5938-5898
  • Diaz-Fortuny, Javier|||0000-0002-8186-071X
  • Saraza-Canflanca, Pablo|||0000-0003-2155-8305
  • Rodriguez, R.|||0000-0002-4565-6703
  • Castro-Lopez, Rafael|||0000-0002-6247-3124
  • Roca, Elisenda|||0000-0001-6260-6495
  • Fernandez, Francisco V.|||0000-0001-8682-2280
  • Nafria, Montserrat|||0000-0002-9549-2890
Time-Dependent Variability (TDV) phenomena represent a serious concern for device and circuit reliability. To address the TDV impact at circuit level, Reliability-Aware Design (RAD) tools can be used by circuit designers to achieve more reliable circuits. However, this is not a straightforward task, since the development of RAD tools comprises several steps such as the characterization, modeling and simulation of TDV phenomena. Furthermore, in deeply-scaled CMOS technologies, TDV reveals a stochastic nature that can complicate those steps. In this invited paper, we review some of the main challenges that appear in each step of the flow towards the development of RAD tools, providing our solutions to them.
Dipòsit Digital de Documents de la UAB
Publicación Capítulo o parte de un libro (BookPart)

Strategies for parameter extraction of the time constant distribution of time-dependent variability models for nanometer-scale devices

  • Fernandez, F. V.
  • Roca, E.
  • Saraza, P.
  • Martin-Martinez, J.|||0000-0001-5938-5898
  • Rodriguez, R.|||0000-0002-4565-6703
  • Nafria, Montserrat|||0000-0002-9549-2890
  • Castro-Lopez, Rafael|||0000-0002-6247-3124
Time-dependent variability phenomena are stochastic and discrete for nanometer-scale technologies, and, hence, must be statistically characterized. These phenomena are attributed to the emission and capture of charges in device defects. This paper explores two different strategies to extract, from experimental data, the distribution parameters of the time constants of the defects. It delves into the accuracy of each strategy, showing how the extraction strategy can have a huge impact on the accuracy and the amount of characterization data required, and, therefore, on the amount of (expensive) characterization time in the lab.
Dipòsit Digital de Documents de la UAB
Publicación Capítulo o parte de un libro (BookPart)

A systematic approach to RTN parameter fitting based on the Maximum Current Fluctuation

  • Saraza-Canflanca, P.
  • Martin-Martinez, J.|||0000-0001-5938-5898
  • Roca, E.
  • Castro-Lopez, Rafael|||0000-0002-6247-3124
  • Rodriguez, R.|||0000-0002-4565-6703
  • Nafria, Montserrat|||0000-0002-9549-2890
  • Fernandez, F. V.
This paper addresses the automated parameter extraction of Random Telegraph Noise (RTN) models in nanoscale field-effect transistors. Unlike conventional approaches based on complex extraction of current levels and timing of trapping/de-Trapping events from individual defects in current traces, the proposed approach performs a simple processing of current traces. A smart optimization problem formulation allows getting distribution functions of the amplitude of the current shifts and of the number of active defects vs.Time.