Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 8
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

An efficient injection concept for CO2 geological storage

  • Silva, Orlando
  • Carrera, Jesús
  • Vilarrasa, Víctor
Trondheim CCS Conference, CO2 Capture, Transport and Storage. 14-16 June 2011, Trondheim, Norway., CO2 geological storage is based on the injection of supercritical CO2 into a deep permeable formation. Supercritical CO2 is less dense than the resident brine, so it will tend to float and escape from the aquifer. To prevent this, the storage sites require a suitable geological formation of very low permeability and high entry pressure to acts as a seal. One of the problems of the supercritical CO2 injection is the low storage capacity. Space to be occupied by the CO2 is obtained basically by: (1) compressing the fluids and expanding the pores of the aquifer, which increases fluid pressure and, thus, the energy cost of the injection and may impact the caprock stability; and (2) displacing the resident water of the aquifer, which in the mid-term could lead to the contamination of freshwater bodies (groundwater and/or surface waters) around the site. In the long-term the CO2 dissolves into the brine of the aquifer and the above risks vanish, but the time needed for this to occur is uncertain and may be too long. There are still several unresolved problems related to the conventional CO2 injection: large local pressures, displacement of the resident brine, caprock failure and risks of CO2 leakage to biosphere., This work is funded by the “Fundación Ciudad de la Energía” (CIUDEN), and by the European Union through the “European Energy Programme for Recovery” and MUSTANG project (contract nº 227286; www.co2mustang.eu)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

Characterization and working programme of Hontomín CO2 injection site (Spain). Monitoring, Hydrogeochemical Characterization and Injection Tests

  • Carrera, Jesús
  • Silva, Orlando
  • Rötting, Tobias
  • Carbonell, Ramón
  • Vilarrasa, Víctor
  • Pérez-Estaún, Andrés
  • CIUDEN's research group
6th TCCS conference, Trondheim, 14-16 June 2011, This work is funded by the Fundación Ciudad de la Energía (CIUDEN) and by the European Union through the European Energy Programme for Recovery and MUSTANG Project (contract number 227286; www.co2mustang.eu), Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

Effects of the initial stress satate on the geomechanical stability of the caprock during CO2 sequestration in deep saline aquifers

  • Vilarrasa, Víctor
  • Olivella, Sebastià
  • Carrera, Jesús
Coloquio franco-español de CO2. 22-24 noviembre 2010, Pau, Francia., Suitable saline aquifers should be capped by a low-permeability caprock. This caprock may undergo large pressure buildup because of CO2 injection. This will affect the stress field and may induce large deformations, which can eventually damage the caprock and open up new flow paths. Hydromechanical (HM) simulations capture phenomena that purely hydraulic (H) codes cannot predict. These include the initial pressure drop in the caprock as a response to CO2 injection (Fig. 1) (Vilarrasa et al., 2010). Furthermore, geomechanical behaviour of the rock strongly depends on the initial stress state (Rutqvist et al., 2008). The permeability of the caprock affects fluid pressure evolution, both in the aquifer and the caprock. Brine can leak through relatively permeable caprocks (k ≥10-18 m2), reducing the pressure buildup in the aquifer. In addition, the greater the permeability, the larger the volume of the caprock affected by pressure buildup., V.V. would like to acknowledge the Spanish Ministry of Science and Innovation (MIC) and the “Colegio de Ingenieros de Caminos, Canales y Puertos – Catalunya” for their financial support. This project has been funded by the Spanish Ministry of Science and Innovation through the project CIUDEN (Ref.: 030102080014), and through the MUSTANG project, from the European Community’s Seventh Framework Programme FP7/2007-2013 under grant agreement nº 227286., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

Geomechanical stability of the caprock during CO2 sequestration in deep saline aquifers

  • Vilarrasa, Víctor
  • Olivella, Sebastià
  • Carrera, Jesús
10th International Conference of Greenhouse Gas Technologies, 19-23 Septiembre 2010, Amsterdam (Holanda)., Suitable saline aquifers should be capped by a low-permebility caprock. This caprock may undergo large pressure buildup because of CO2 injection. This will affect the stress field and may induce large deformations, which can eventually damage the caprock and open up new flow paths. Hydromechanical (HM) simulations capture phenomena that purely hydraulic (H) codes cannot predict. These include the initial pressure drop in the caprock as a response to CO2 injection (Fig. 1) (Vilarrasa et al., 2010). Furthermore, failure mechanisms strongly depend on the initial stress state (Rutqvist et al., 2008). Unlike open aquifers, in which pressure buildup is limited because brine can migrate out laterally, semi-closed aquifers experience an additional pressure buildup. This additional overpressure depends on the caprock permeability. Relatively permeable caprocks (k<10-18 m2) diminish overpressure because brine can leak through them., V.V. would like to acknowledge the Spanish Ministry of Science and Innovation (MIC) and the “Colegio de Ingenieros de Caminos, Canales y Puertos – Catalunya” for their financial support. This project has been funded by the Spanish Ministry of Science and Innovation through the project CIUDEN (Ref.: 030102080014), and through the MUSTANG project, from the European Community’s Seventh Framework Programme FP7/2007-2013 under grant agreement nº 227286., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

Hydrogeochemical characterization and monitoring at the Hontomin site (Spain) for geological storage of CO2

  • Roetting, Tobias
  • Carrera, Jesús
  • Silva, Orlando
EGU General Assembly 2011, 3-8 Abril 2011, Viena (Austria), This abstract describes the monitoring equipment and characterization tests planned at the Hontomin site, Northern Spain, where the Energy City Foundation (CIUDEN) of the Spanish Government CO2 Geological Storage Programme is installing a technological demonstration plant for geological CO2 storage. The Hontomin storage structure is located in formations of lower Jurassic age: marls as the upper seal, calcites and dolomites as the storage formation, and anhydrites as lower seal. The borehole setup at Hontomin will consist of three wells: One injection well, one geophysical monitoring well, and one multilevel fluid monitoring well, in a triangular setting. The geophysical monitoring well will be located 100 m from the injection well, and the multilevel fluid monitoring well 40 m from the injection well. The injection well will be equipped with ERT electrodes, a fiber optic Distributed Temperature Sensing (DTS) system with a heating element, extensometers, and fluid pressure sensors. The geophysical monitoring well will be equipped with the same sensors plus an array of geophones. The multilevel fluid sampling well will be equipped with sampling ports for multiphase fluid sampling, a DTS with heating element, extensometers and fluid pressure sensors. The DTS will be used to measure temperature profiles, and, in combination with the heating element, to determine changes in heat conductivity and heat capacity induced by CO2 injection. The extensometers will measure deformation of the storage and seal formations. Hydrogeochemical characterization will comprise the following tests: • Several injection and pumping tests using water and acid in combination with conservative and reactive tracers in order to measure the transport parameters and chemical properties of the porous medium. • Injection and recovery of supercritical CO2 in combination with conservative and reactive gaseous tracers, in order to study the trapping mechanisms for CO2. After the characterization phase, up to 100.000 tons of supercritical CO2 will be injected into the storage formation. Continuous and intermittent injection regimes will be applied to optimize injectivity and CO2 dissolution in the brine. Before, during and after these tests, fluid sampling, pressure and deformation measurements, geophysical logs, ERT and passive and active seismic monitoring will determine how the storage and sealing formations react to the stimulations. Drilling of the wells will start in mid-2011, and hydrogeochemical characterization will start in early 2012. The experiments are funded by the Spanish Government through the CUIDEN foundation, and by the European Commission through the FP7 project MUSTANG ("A multiple space and time scale approach for the quantification of deep saline formations for CO2 storage"; contract number 227286)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

CO2 injection in deep saline sloping aquifers through a vertical well

  • Vilarrasa, Víctor
  • Olivella, Sebastià
  • Carrera, Jesús
3rd Workshop of CODE-BRIGHT Users. 2011, Barcelona., Anthropogenic CO2 emissions are expected to continue to increase worldwide in the next decades. This could dramatically increase CO2 concentrations in the atmosphere. One potential mitigation action is CO2 permanent storage in deep saline aquifers. CO2 is injected as a supercritical fluid (temperature and pressure higher than 31.1 ºC and 7.38 MPa, respectively) so as to obtain a relatively high density that minimizes the volume occupied by this greenhouse gas. CO2 density is highly dependent on temperature and pressure because of its high compressibility (Vilarrasa et al., 2010a), adopting a wide range of values (450-800 kg/m3). Since CO2 is lighter than brine, flow is affected by buoyancy. Buoyancy produces an upslope migration of the CO2 bubble in sloping aquifers. The post-injection fate of CO2 in sloping aquifers has been investigated (e.g. Hesse et al., 2008; Elenius et al., 2010) but without considering the actual shape of the CO2 bubble at the end of injection. However, the shape of the CO2 bubble at the end of injection affects its posterior evolution (McMinn & Juanes, 2009). Gasda et al. (2008) studied the effect of a slope up to 1º during the injection period using a 2D model, which represents injection through a horizontal well. However, CO2 injection through a vertical well, which implies a 3D geometry, has not yet been investigated.CO2 will be injected in the Hontomín CO2 pilot storage site, Burgos (Spain). Hontomín is the site for the CO2 storage Technology Demonstration Plant (TDP) of the Compostilla OXYCFB300 project, operated by Energy City Foundation (CIUDEN). CO2 will be injected through a vertical well in a flank of a dome-like structure with a slope close to 20º at a depth around 1450 m. CO2 injection tests are aimed to gain knowledge on trapping mechanisms and CO2 bubble and pressure evolution. Pressure evolution is important for assessing the caprock integrity and to avoid the open up of preferential paths for CO2 leakage (Vilarrasa et al., 2010b, 2011). These processes are relatively well known in horizontal aquifers, but a high uncertainty still exists in sloping aquifers., V.V. wishes to acknowledge the Spanish Ministry of Science and Innovation (MCI), through the “Formación de Profesorado Universitario”, and the “Colegio de Ingenieros de Caminos, Canales y Puertos – Catalunya” for their financial support. Additionally, we would like to acknowledge the Spanish Government (Ministry of Industry, Tourism and Trade) through the CUIDEN foundation (project ALM/09/18; www.ciuden.es) and the ‘MUSTANG’ project (from the European Community’s Seventh Framework Programme FP7/2007-2013 under grant agreement nº227286 ; www.co2mustang.eu) for their financial support., Peer reviewed
UPCommons. Portal del coneixement obert de la UPC
Publicación Contribución de congreso (ConferenceOutput)

CO2 injection in deep saline sloping aquifers through a vertical well

  • Vilarrasa Riaño, Víctor|||0000-0003-1169-4469
  • Olivella Pastallé, Sebastià|||0000-0003-3976-4027
  • Carrera Ramírez, Jesús|||0000-0002-8054-4352
Recercat. Dipósit de la Recerca de Catalunya
Publicación Contribución de congreso (ConferenceOutput)

CO2 injection in deep saline sloping aquifers through a vertical well