Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

Biomass Chemical Looping Gasification (BCLG) using ilmenite as oxygen carrier

  • García Labiano, Francisco
  • Samprón, Iván
  • Condori, Óscar
  • Adánez Elorza, Juan
  • Diego Poza, Luis F. de
  • Izquierdo Pantoja, María Teresa
Talk delivered at the 6th Central European Biomass Conference, CEBC 2020, 22nd- 24th January 2020, in Graz (Austria)., This work has been supported by the projects ENE2017-89473-R (AEI/FEDER, UE), and CLARA (UE-H2020, No. 817841)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

Syngas production via Biomass Chemical Looping Gasification (BCLG) in a 50 kWth unit using ilmenite as oxygen carrier

  • Condori, Óscar
  • García Labiano, Francisco
  • Diego Poza, Luis F. de
  • Izquierdo Pantoja, María Teresa
  • Abad Secades, Alberto
  • Adánez Elorza, Juan
5 figures, 1 table.-- Talk delivered at the 24th International Conference on Fluidized Bed Conversion, FBC24, at Chalmers University of Technology, in Gothenburg (Sweden)., The use of liquid biofuels is considered one of the most relevant ways to achieve the reduction of greenhouse gas (GHG) emissions in the sector of transport, and more specifically in aviation. A possible route is the use of biogenic waste from the agriculture and forestry sector to obtain synthesis gas via gasification and then the Fischer-Tropsch synthesis to obtain liquid biofuels. Among the different technologies available for the gasification process, Biomass Chemical Looping Gasification (BCLG) represents an innovative process that allows the generation of non-nitrogen diluted synthesis gas under autothermic conditions and with low tars content. By using carbon-neutral biomass as fuel, even net negative emissions could be achieved if the BCLG process is combined with CO2 storage. This work presents an experimental campaign of 40 hours of continuous operation in a 50 kWth BCLG unit developed inside the EU H2020 CLARA Project. Wheat straw pellets with additives were used as fuel feedstock and ilmenite as solid oxygen carrier. This work aimed to investigate the effect of different operational variables such as the fuel reactor temperature, the mean residence time of solids in the fuel reactor, the oxygen-to-biomass ratio (controlled by the oxygen fed into the air reactor) and the gas velocity in the carbon stripper, on the process performance and the syngas yield. Unlike previous studies, effective oxygen-to-biomass ratios that consider the right amount of oxygen that reacts with the oxygen carrier both in the fuel and air reactors (λeff,FR and λeff,AR, respectively) were defined The main factor affecting the syngas yield and the cold gas efficiency was λeff,FR, since it represents the amount of lattice oxygen that actually reacts in the fuel reactor during syngas combustion. However, it showed a low impact on the production of light hydrocarbons (CH4 and C2-C3). The temperature and mean residence time in the fuel reactor showed a considerable effect on the char conversion in the fuel reactor, since an increase in those factors caused an increase in the reaction rates or in the contact time between the oxygen carrier and biomass in the fuel reactor, respectively. Finally, the carbon stripper did not show the ability to separate the solid oxygen carrier from the unconverted char entrained from the fuel reactor, as the char still retained its initial pellet form. Therefore, an increase in gas velocity of carbon stripper promoted the char by-pass to the air reactor, increasing both the biomass conversion in the unit and the fraction of carbon emitted in the air reactor., This work has been supported by the European Union’s Horizon 2020-Research and Innovation Framework Programme under grant agreement No 817841 (Chemical Looping gAsification foR sustainable production of biofuels - CLARA), and by the AEI/FEDER, UE-ENE2017-89473R., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

Investigating the chemical looping gasification of biomass for syngas production during continuous operation in 1.5 to 100 kWth units

  • Soleimani Salim, Amir H.
  • Linderholm, Carl
  • Condori, Óscar
  • Samprón, Iván
  • Diego Poza, Luis F. de
  • García Labiano, Francisco
  • Abad Secades, Alberto
  • Adánez Elorza, Juan
  • Mattisson, Tobias
13 figures, 2 tables.-- Talk delivered at the 2nd International Conference on Negative CO2 Emissions, June 14-17, 2022, Göteborg, (Sweden)., The principle of chemical looping has by now mainly been used for the combustion of fuels, i.e. chemical looping combustion (CLC). However, limited work has been done with respect to chemical looping gasification (CLG) of biomass in continuous operation, especially at a large scale. The main advantage of CLG compared to the most common oxygen-driven gasification technologies is the avoidance of an expensive and energy-consuming Air Separation Unit (ASU), which significantly reduces the total investment and the electricity consumption of converting biomass to syngas. In CLG, the produced CO2 is obtained in the concentrated form together with the syngas leaving the fuel reactor, meaning that CO2 can be removed with low energy penalty and subsequently stored in geological formations. When using biomass, storage of CO2 could result in the removal of CO2 from the atmosphere, thus leading to net negative CO2 emissions of the entire process chain for biofuel production. In addition, in comparison to normal indirect gasification, no fuel is used in the air/combustion reactor, meaning that high-temperature corrosion should be avoided to a large extent. Finally, oxygen carrier particles may provide catalytic sites for hydrocarbons, thus enhancing syngas production and suppressing tar formation. The objectives of the EU-financed H2020 project “CLARA” are to develop and test a concept for the gasification of biomass residues with the production of FT-diesel. CLG is the gasification technology which is utilized for syngas production. The main research with respect to CLG development is carried out at Chalmers University of Technology (CTH), Sweden and Consejo Superior de Investigaciones Científicas (CSIC), Spain. The work combines studies in small fixed and fluidized bed units where important results can be reached, with moderate efforts and larger units providing additional key results of industrial relevance. As the final aim is to use CLG at a commercial scale for the production of syngas, it is expected that oxygen carriers at multi-ton scale will be needed. This means that likely only natural or waste materials can be used as oxygen carriers, for instance, Mn- and Fe-ores. An extensive effort has been made to source materials that are available at a large scale. Evaluation of preselected oxygen carriers, using viable fuels, has been carried out in pilot plants in 1.5 kWth, 10 kWth, , 50 kWth, and 100 kWth. The selected oxygen carriers from pre-screening step were (a) Ilmenite, an iron-titanium ore, (b) Tierga iron ore, (c) LD slag, a by-product from steel making industry, and two manganese ores (d) Elwaleed B, and (e) Moanda. For evaluation of these selected oxygen carriers, a total of 650 hours of continuous CLG operation has been accomplished in the mentioned units, with very interesting and promising results, which are reported in the current paper. We here demonstrate that CLG has a positive effect on the gasification of biomass by reducing tar formation, increasing syngas yield, biomass conversion and H2/CO ratio compared to conventional steam gasification using sand as bed material. Also, it has been confirmed that the CO2 in the exit stream from FR is in concentrated form, which can be removed with low energy penalty and could result in the removal of CO2 from the atmosphere, thus leading to net negative CO2 emissions. The effect of the main operating parameters in CLG, such as the temperature, the steam-to-biomass ratio, and the oxygen-to-biomass ratio, was fully investigated. Among the tested oxygen carriers, Ilmenite and LD slag showed a better biomass gasification performance compared to Mn ores (Elwaleed B and Moanda) and Tierga ore. LD slag has a lower lifetime than ilmenite and needs heat pre-treatment, but a higher syngas yield and higher H2/CO ratio were achieved with this material., This work has been supported by the European Union’s Horizon 2020-Research and Innovation Framework Programme under grant agreement No 817841 (Chemical Looping gAsification foR sustainable production of biofuels - CLARA)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

Syngas production via Biomass Chemical Looping Gasification (BCLG) in a 50 kWth unit using ilmenite as oxygen carrier

  • Condori, Óscar
  • Abad Secades, Alberto
  • Izquierdo Pantoja, María Teresa
  • Diego Poza, Luis F. de
  • García Labiano, Francisco
  • Adánez Elorza, Juan
8 figures, 1 table.--Talk delivered at the 6th International Conference on Chemical Looping, 19-22 September 2022, Zaragoza, Spain., Biomass Chemical Looping Gasification (BCLG) is an innovative process that uses lattice oxygen from a solid oxygen carrier to produce high-quality synthesis gas without CO2 emissions. It is well known that one of the main targets for the reduction of greenhouse gas emissions (GHG) is to replace the use of fossil fuels in the transport sector with renewable sources. In this work, the BCLG technology is used to obtain clean synthesis gas from biomass for the production of liquid biofuels through Fischer Tropsch (FT) synthesis. The BCLG process is based on the circulation of a solid oxygen carrier between two interconnected fluidized bed reactors, the fuel and air reactors, providing the oxygen needed for the partial oxidation of the biomass to generate a non-nitrogen diluted syngas with low tar content. Also, the oxygen carrier is responsible for transporting the heat required for the endothermic reactions occurring in the fuel reactor from the heat generated in the exothermic reactions occurring in the air reactor, thus reaching autothermal conditions. In addition, negative emissions could be achieved by combining this technology with CO2 storage since biomass is a carbon-neutral fuel. The experimental campaign of this work was carried out in a BCLG unit at 18 kWth power during 60 hours of continuous operation with ilmenite as oxygen carrier and wheat straw pellets as fuel. The main factors affecting the syngas production was the oxygen-to-biomass ratio and char conversion. Increasing temperature showed a considerable effect on the char conversion in the fuel reactor since caused an increase in the gasification rate; also, the char conversion was affected by the mean residence time in the fuel reactor. The existing carbon stripper in the CLG unit did not show the ability to separate the unconverted char entrained from the fuel reactor since char still retained its initial pellet form. However, carbon stripper behaves as a secondary gasifier when using steam as fluidizing agent increasing char conversion, syngas yield and carbon capture efficiency. Finally, low tar generation was found during continuous operation, reaching values below 3.5 g/kg of dry biomass., This work has been supported by the European Union’s Horizon 2020-Research and Innovation Framework Programme under grant agreement No 817841 (Chemical Looping gAsification foR sustainable production of biofuels - CLARA), and by the AEI/FEDER, UE-ENE2017-89473-R., Peer reviewed