Pasar al contenido principal

DEMOSTRADORES TECNOLOGICOS DE FILTROS Y MULTIPLEXORES CON RESPUESTAS SELECTIVAS Y SINTONIZABLES EN NUEVAS GUIAS COMPACTAS PARA APLICACIONES ESPACIALES

TEC2016-75934-C4-1-R

•
Nombre agencia financiadora Agencia Estatal de Investigación
Acrónimo agencia financiadora AEI
Programa Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Convocatoria Proyectos I+D+i Retos de Investigación
Año convocatoria 2016
Plan Estatal 2013-2016 Plan Estatal de Investigación Científica y Técnica y de Innovación
Centro beneficiario UNIVERSITAT POLITÈCNICA DE VALÈNCIA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Contribución de congreso (ConferenceOutput)

A Wideband Diplexer for Ka-Band Passive Intermodulation Measurement

  • Smacchia, D.
  • Carceller, C.
  • Guglielmi, M.
  • González-Santatecla, Pablo
  • Soto Pacheco, Pablo|||0000-0002-2734-620X
  • Boria Esbert, Vicente Enrique|||0000-0001-7150-9785
  • Ruiz-Garnica, Jesús|||0000-0002-2361-2806
In this paper we propose a novel Ka-band waveguide diplexer for passive intermodulation (PIM) measurements. Due to the higher operating frequency, this type of measurement setup usually requires wideband filters. In addition, due to the very large separation between satellite uplink and downlink bands, the PIM measurement diplexer unit must operate over a very wide frequency band. To satisfy such wide bandwidth requirements, the proposed topology is based on a band-reject filter for the downlink frequency band which is designed to provide, at the same time, the optimal passband performance for the downlink, and the optimal equiripple rejection over the PIM band. For the PIM channel, a band-pass filter combined with a high-pass section has been used. To validate the design, a prototype has been designed and manufactured. Very good agreement is shown between simulations and measurements, thereby fully validating the proposed solution.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Contribución de congreso (ConferenceOutput)

Systematic procedure for the efficient design of folded waveguide comb-line filters

  • San-Blas, A. A.
  • Pérez-Guijarro, J.
  • Guglielmi, M.
  • Boria Esbert, Vicente Enrique|||0000-0001-7150-9785
[EN] A systematic procedure for the efficient design of folded waveguide comb-line filters is presented. The proposed strategy is based on dividing the design process in more simple stages, in order to reduce the number of variables to be optimized in each step of the design process. The electrical response of an equivalent circuit model of the waveguide component considered in each step is used as a target response. Moreover, a method for obtaining an initial value for some key dimensions of the filter is also addressed. Finally, an S-band 6-pole folded comb-line filter has been successfully designed following the proposed design strategy.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Contribución de congreso (ConferenceOutput)

Design of Miniaturized Substrate Integrated Filters Using Aggressive Space Mapping

  • Martínez Pérez, Jorge Daniel|||0000-0002-7119-3714
  • Boria Esbert, Vicente Enrique|||0000-0001-7150-9785
  • Sirci, Stefano
[EN] An optimization procedure for the design of miniaturized substrate integrated quasi-lumped filters based on aggressive space mapping techniques is presented in this paper. A gradient-descent approach based on a lossy coarse model is employed. Thus, a 3-pole bandpass filter response centered at 10 GHz is designed, manufactured and measured, showing the validity of the technique even if strong dependencies between the different electrical and physical parameters are present.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Contribución de congreso (ConferenceOutput)

Optimized Design of Combline Filters with Transmission Zeros

  • Vague Cardona, José Joaquín|||0000-0001-5935-3116
  • Cogollos, Santiago|||0000-0002-4189-2952
  • Boria Esbert, Vicente Enrique|||0000-0001-7150-9785
  • Ossorio García, Javier
  • Guglielmi, Marco
[EN] The objective of this paper is to demonstrate how inline combline filters can be designed to implement transmission zeros in the filter transfer function. Following the design procedure described in this paper, up to N-1 transmission zeros can be implemented with a filter of order N. In addition to theory, comparisons between simulated and measured results are also presented. The agreement between simulation and measurements is indeed good, thereby fully validating the new combline filter topology, and the proposed design technique.