Pasar al contenido principal

CATALIZADORES AVANZADOS DE BASE BIOMASICA PARA LA SINTESIS DE DIMETIL ETER EN UNA ETAPA

CTQ2015-68654-R

•
Nombre agencia financiadora Ministerio de Economía y Competitividad
Acrónimo agencia financiadora MINECO
Programa Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Convocatoria Proyectos I+D+i Retos de Investigación
Año convocatoria 2015
Plan Estatal 2013-2016 Plan Estatal de Investigación Científica y Técnica y de Innovación
Unidad de gestión Dirección General de Investigación Científica y Técnica
Centro beneficiario UNIVERSIDAD DE MALAGA
Identificador persistente http://dx.doi.org/10.13039/501100003329

Resultados relacionados

Resultados totales (Incluyendo duplicados): 3
Encontrada(s) 1 página(s)

RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Kinetic study of SO2 removal over lignin-based activated carbon

  • Rosas, Juana M.
  • Ruiz-Rosas, Ramiro
  • Rodríguez-Mirasol, José
  • Cordero, Tomás
Adsorption of SO2 on an activated carbon obtained by chemical activation of kraft lignin with zinc chloride was studied in a laboratory column. The presence of oxygen and water vapor in the inlet stream increases the SO2 adsorption capacity of the carbon, due to the surface oxidation of the SO2 to SO3 and the subsequent hydration to H2SO4. Desorption of the SO2 chemisorbed at temperatures in the range of 150–300 °C produces carbon gasification, forming oxygen surface groups that decompose mainly as CO at higher temperatures (>−500 °C). The presence of CO2 in the inlet gas decreases the SO2 adsorption capacity of the carbon. However, the presence of NO does not produce any significant change in the adsorption of SO2, at the studied conditions. The breakthrough curves of the SO2 adsorption are predicted adequately by a rigorous mathematical model that takes into account the catalytic oxidation of SO2 by an Eley-Rideal mechanism and the reaction between adsorbed SO3 and water vapor to produce H2SO4, followed by the elution of the adsorbed H2SO4 that releases the active sites.
RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Lignin-derived Pt supported carbon (submicron)fiber electrocatalysts for alcohol electro-oxidation

  • García-Mateos, Francisco J.
  • Cordero-Lanzac, Tomás
  • Berenguer Betrián, Raúl
  • Morallon, Emilia
  • Cazorla-Amorós, Diego
  • Rodríguez-Mirasol, José
  • Cordero, Tomás
  • Berenguer Betrián, Raúl|||/items/660b8462-63ec-4910-98e0-ac425e6bd7a6
  • Cazorla-Amorós, Diego|||/items/bab354fe-ec79-49e0-a4f3-5288ee396750
  • Morallon, Emilia|||/items/a15cf511-9365-4c40-afcb-ea29d4418244
Lignin fibers, with and without phosphorus, and loaded with platinum have been prepared in a single step by electrospinning of lignin/ethanol/phosphoric acid/platinum acetylacetonate precursor solutions. Thermochemical treatments have been carried out to obtain lignin-based carbon fiber electrocatalysts. The electrospun lignin fibers were thermostabilized in air and carbonized at 900 °C. The effect of phosphorus and platinum content on the porous texture, the surface chemistry and the oxidation/electro-oxidation resistance have been studied. Phosphorus-containing carbon fibers develop a higher surface area (c.a. 1200 m2 g−1), exhibit a lower Pt particle size (2.1 nm) and a better particle distribution than their counterpart without phosphorus (c.a. 750 m2 g−1 of surface area and 9.6 nm Pt particle size). It has been proved that phosphorus improves the oxidation and electro-oxidation resistance of the fibers, avoiding their oxidation during the preparation thermal stages and is responsible of the generation of a microporous material with an unusual wide operational potential window (1.9 V). An important Pt–P synergy has been observed in the oxygen transfer during the oxidation and electro-oxidation of the fibers. The obtained carbon fibers can act directly as electrodes without any binder or conductivity promoter. The fibers with platinum have shown outstanding catalyst performance in the electro-oxidation of methanol and ethanol.
RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Phosphorus functionalization for the rapid preparation of highly nanoporous submicron-diameter carbon fibers by electrospinning of lignin solutions

  • García-Mateos, Francisco J.
  • Berenguer Betrián, Raúl
  • Valero-Romero, María José
  • Rodríguez-Mirasol, José
  • Cordero, Tomás
  • Berenguer Betrián, Raúl|||/items/660b8462-63ec-4910-98e0-ac425e6bd7a6
This work presents a fast and versatile method to prepare carbon fibers from lignin. It involves the production of submicron-sized phosphorus-functionalized lignin fibers in only one step by electrospinning of lignin/H3PO4 solutions. The phosphorus functionalities enable shortening of the conventional stabilization process from more than 90 h to only 2 h thus avoiding fiber fusion or even stabilizing the lignin fibers in an inert atmosphere. The incorporation of H3PO4 into the initial lignin solution produces more oxidized spun lignin fibers, due to the reaction of phosphoric acid with the dissolved lignin, generating phosphate (and/or polyphosphate) esters throughout the structure of lignin fibers. These phosphate groups seem to be responsible for the production of cross-linking reactions during the stabilization step that are, in this case, very active and effective in increasing the glass transition temperature of the lignin fibers, reducing the time needed for the stabilization step and improving this process. Moreover, they promote the chemical activation of lignin fibers and greatly increase their oxidation resistance, avoiding their complete combustion during carbonization under a low concentration of O2 at temperatures as high as 900 °C. The resulting carbon fibers gather different interesting properties, such as sub-micron diameters (≤1 μm), large surface area (≈2000 m2 g−1), relatively high performance in relation to their mechanical properties for functional applications and a rich variety of uniformly distributed O and P surface functionalities, which make them very attractive for heterogeneous catalysis, adsorption and electrochemical applications.