Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 1
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Datos de investigación Set de datos (Dataset)

Appendix A. Supplementary material for Laser-induced tuning of carbon nanosensitizers to maximize nitrogen doping and reactive oxygen species production in the visible range [Dataset]

  • Madrid, Ainhoa
  • Martínez, Gema
  • Hornos, Felipe
  • Bonet-Aleta, Javier
  • Calvo, Esteban
  • Lozano Fantoba, Antonio
  • Hueso, José L.
Characterization techniques: Transmission electron microscopy images were acquired in a FEI Tecnai T20, operating at 200 kV, a Titan (FEI TITAN3, operated at 300 kV and equipped with a Gatan Image Filter (GIF Tridiem 863)). Additional Scanning Transmission Electron Microscopy (STEM) was performed with a FEI Titan Low-Base 60-300 operating at 80 KeV (fitted with an X-FEG® gun and Cs-probe corrector (CESCOR from CEOS GmbH)). The surface chemical composition was analyzed by X-ray photoelectron spectroscopy (XPS) with an Axis Ultra DLD (Kratos Tech.) The binding energies were calibrated to the internal C1s (284.3 eV) standard. A monochromatic Al Kα source (1486.6 eV) was employed with multiple runs at 12 kV, 10 mA and pass energy of 20 eV. Steady-state fluorescence emission spectra and photoluminescence were collected on a JASCO FP-6500 spectrofluorometer equipped with a 450 W xenon lamp for excitation, with temperature controller ETC-273T at 25 °C, using 5x10 mm cuvettes and a LS55 Fluorescence Spectrometer (PerkinElmer) equipped with a xenon arc lamp as the light source and a quartz cell (10 x 10 mm). Raman characterization was carried out using a Raman Spectrometer WiTec alpha 300. A Helium-Neon 532 nm laser was used for excitation of the Raman signal and the laser power for each sample was 1 mW. A 50x optical aperture was used resulting in a 1.2 μm diameter spot. Acquisition times of 0.5 second and a single spectrum accumulation per spectrum were typically required.-- Under a Creative Commons license Attribution-NonCommercial-NoDerivatives 4.0 International (CC BY-NC-ND 4.0), Characterization techniques. Figure S1: Fitted X-ray photoemission spectra corresponding to the: a-c) C1s region; d-f) O1s region; g-i) S2p region of the different N-CNDs. Percentages correspond to the relative weight of the specific fitted contribution for the region. Table T1: Atomic surface composition determined by XPS analysis. Figure S2: Evolution of the methyl orange absorption spectra upon different irradiation times with white LED at pH=4: a) Photolysis in the absence of catalyst; b) Photocatalysis with P25 NPs; c) N-CNDpy@P25; d)N-CNDpyNH3@P25; e) N-CNDpyph@P25., Financial support from the European Research Council (ERC-Advanced Grant CADENCE number 742684), the FP7 People Program (NANOLIGHT-294094) and the Spanish Research Agency (LAERTES- PID2020-114926RB-I00) are acknowledged. [...]. J.B-A. acknowledges the Spanish Government for an FPU predoctoral contract. F.H. acknowledges the Generalitat Valenciana and the European Social Fund for an APOSTD fellowship (APOSTD/2021/196)., Peer reviewed