DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación
Artículo científico (JournalArticle)
High-temperature solar-selective coatings based on Cr(Al)N. Part 2: Design, spectral properties and thermal stability of multilayer stacks
Two multilayer solar selective absorber coatings [Al/CrN0.95/Cr0.96Al0.04N1.08/Cr0.53Al0.47N1.12/Al2O3
(stack #1) and Cr0.96Al0.04N0.89/Cr0.62Al0.38N1.00/Cr0.53Al0.47N1.12/Al2O3 (stack #2)] were deposited on
316L steel by combining direct current (DC) and high power impulse magnetron sputtering
(HiPIMS) technologies with the aim of increasing the working limit temperature. The
composition and thickness of the constituent layers were optimized using CODE software to
achieve a high solar absorptance (α) and low values of thermal emittance (ɛ) in the infrared
region. The deposited multilayered stacks were heated during 2 hours in air at 600, 700 and 800
ºC to study their thermal stability and optical performance. Compositional, structural and optical
characterization of the stacks (as-prepared and after thermal treatment) was performed. Both
stacks presented a good solar selectivity with > 95% and 25 ºC < 15%, were stable up to 600 ºC
and fulfilled the performance criterion PC < 5% after 600 and 700 ºC treatments. Despite the
stacks suffered chemical transformations above 600 ºC, partial oxidation (stack #1) and Cr2N
formation (stack #1 and #2), the optical properties were optimum up to 700 ºC for stack #1 (α =
94%, ε(25 ºC) =12%) and 600 ºC for stack #2 (α = 93%, ε25 ºC =13%).The solar-to-mechanical energy
conversion efficiencies () of the as-deposited and annealed (600 and 700 ºC) samples were up
to 20 percentage points higher than the absorber paint commercially used (Pyromark). At 800
ºC, they underwent a further structural transformation, provoked by the oxidation of the inner
layers, and they consequently lost their solar selectivity., Peer reviewed