Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Novel utility-scale photovoltaic plant electroluminescence maintenance technique by means of bidirectional power inverter controller

  • Ballestín-Fuertes, Javier
  • Muñoz-Cruzado-Alba, J.
  • Sanz-Osorio, José F.
  • Hernández-Callejo, L.
  • Alonso-Gómez, V.
  • Morales-Aragones, J.I.
  • Gallardo-Saavedra, S.
  • Martínez-Sacristan, O.
  • Moretón-Fernández, A.
Nowadays, photovoltaic (PV) silicon plants dominate the growth in renewable energies generation. Utility-scale photovoltaic plants (USPVPs) have increased exponentially in size and power in the last decade and, therefore, it is crucial to develop optimum maintenance techniques. One of the most promising maintenance techniques is the study of electroluminescence (EL) images as a complement of infrared thermography (IRT) analysis. However, its high cost has prevented its use regularly up to date. This paper proposes a maintenance methodology to perform on-site EL inspections as efficiently as possible. First, current USPVP characteristics and the requirements to apply EL on them are studied. Next, an increase over the automation level by means of adding automatic elements in the current PV plant design is studied. The new elements and their configuration are explained, and a control strategy for applying this technique on large photovoltaic plants is developed. With the aim of getting on-site EL images on a real plant, a PV inverter has been developed to validate the proposed methodology on a small-scale solar plant. Both the electrical parameters measured during the tests and the images taken have been analysed. Finally, the implementation cost of the solution has been calculated and optimised. The results conclude the technical viability to perform on-site EL inspections on PV plants without the need to measure and analyse the panel defects out of the PV installation.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Analysis of the European energy innovation system: contribution of the framework programmes to the EU policy objectives

  • Calvo-Gallardo, E.
  • Arranz, N.
  • Fernández de Arroyabe, J.C.
This study analyses the properties of the networks constructed by the funded energy-related research consortia to assess their support to the objectives of the European Union’s energy technologies and research policies. By developing research consortia, partners and projects are linked to form a network that generates relationship networks (innovation systems). Although many authors assessed this innovation system from different perspectives, few studies aim to identify the properties of its networks. From the innovation systems perspective, this study fills this gap in the literature by applying Social Network Analysis to determine the network cohesion properties and the centrality measures of its nodes, thereby enlarging the innovation systems literature in the field of modelling and performance assessment. The results indicate that the effectiveness of the innovation systems depends on the geographical distribution of the consortia and the diversity of the participants, revealing significant performance differences in each of the research fields within the energy programme. Based on these conclusions, this paper provides recommendations for policymakers and participants in these European research programmes.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Contribution of the Horizon2020 Program to the research and innovation strategies for smart specialization in coal regions in transition: the Spanish case

  • Calvo Gallardo, Elena
  • Arranz, Nieves
  • Fernández de Arroyabe, Juan Carlos
This work aims to assess how regional innovation systems support research and innovation smart specialization strategies (RIS3) in coal intensive regions. Although many authors have analyzed energy transition paths for the European coal regions, no study has assessed how the network properties of their innovation systems are aligned with the priorities identified in their RIS3. This work fills this gap, relying on social network analysis (SNA) to assess innovation systems’ underlying networks, considering the active role of their nodes, thus, contributing to the innovation systems literature in the areas of modelling, simulation and performance evaluation. Within this work, regional innovation systems are modelled as research networks. These networks are pro-moted by the consortia funded by the European H2020 program. The assessment of the topology and properties of these networks enables the evaluation of the functioning of the innovation system, its technological strengths, as well as the key players involved. Based on these results, the characteristics of the innovation systems are compared to the priorities established by the RIS3. Three Spanish coal intensive regions (Aragón, Asturias and Castilla y León) are considered as use cases in this study. The obtained results indicate that, in some cases, the technological strengths of the regional innovation systems are not considered in the identification of the RIS3 priorities, while some RIS3 priorities are not supported by the innovation system. Considering these results, this paper proposes recommendations for regional and European policymakers, as well as for participants in the European research programs.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Massive Parallel Current Power Amplifier Concept for Power Hardware in the Loop Applications

  • García-Martínez, E.
  • Sanz-Osorio, J.
  • Muñoz-Cruzado-alba, J.
  • Perié, J. M.
The development of the smartgrid increases the complexity of the current electric grid. To verify and validate the operation of the systems involved in it, Power Hardware-In-theLoop (PHIL) technique allows to test the complete system in an exhaustive way. But the reduced bandwidth of the overall test system can cause inaccuracies and instabilities, which can be harmful for the Hardware Under Test (HUT) or the people who are performing the test. To increase PHIL performance and tackle these problems, this paper proposes a new concept of high bandwidth current amplifier. It is based on a topology of massive parallel interleaved buck-boost converter, which distribute in an equal manner the total current in all the branches. This current reduction allows to use transistors with better switching behaviour, which increase the bandwidth of the converter. Furthermore, a Discontinuous Conduction Mode (DCM) is used, obtaining the nominal output current in only one switching cycle. Description of the concept and the design parameters are provided. Finally, the behaviour of the proposed Power Amplifier (PA) at high frequency setpoint currents is shown in a Matlab/Simulink simulation. © 2022, European Association for the Development of Renewable Energy, Environment and Power Quality (EA4EPQ). All rights reserved.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Role of wide bandgap materials in power electronics for smart grids applications

  • Ballestín Fuertes, Javier
  • Muñoz-Cruzado Alba, Jesus
  • Sanz Osorio, José Francisco
  • Laporta-Puyal, Erika
At present, the energy transition is leading to the replacement of large thermal power plants by distributed renewable generation and the introduction of different assets. Consequently, a massive deployment of power electronics is expected. A particular case will be the devices destined for urban environments and smart grids. Indeed, such applications have some features that make wide bandgap (WBG) materials particularly relevant. This paper analyzes the most important features expected by future smart applications from which the characteristics that their power semiconductors must perform can be deduced. Following, not only the characteristics and theoretical limits of wide bandgap materials already available on the market (SiC and GaN) have been analyzed, but also those currently being researched as promising future alternatives (Ga2O3, AlN, etc.). Finally, wide bandgap materials are compared under the needs determined by the smart applications, determining the best suited to them. We conclude that, although SiC and GaN are currently the only WBG materials available on the semiconductor portfolio, they may be displaced by others such as Ga2O3 in the near future