Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

Arias Montano. Repositorio Institucional de la Universidad de Huelva
Publicación Artículo científico (JournalArticle)

Tribological behaviour of novel chemically modified biopolymer-thickened lubricating greases investigated in a steel–steel rotating ball-on-three plates tribology cell

  • Gallego Calvo, Rocío|||0000-0002-5490-7359
  • Cidade, T.
  • Sánchez Martínez, Rubén|||0000-0002-2515-6883
  • Valencia Barragán, Concepción|||0000-0002-9197-4606
  • Franco Gómez, José María|||0000-0002-3165-394X
In this work, model renewable and biodegradable lubricating greases based on castor oil and chemically modified biopolymers (methylcellulose, chitin and cellulosic pulp) were tribologically characterized in a steel–steel ball-on-plates tribological cell coupled to a controlled-stress rheometer, and the results were compared to those provided by conventional lithium and calcium soap-based greases. Viscous flow, sliding velocity sweep and transient friction tests were carried out and resulting wear scars in the steel plates were evaluated by means of scanning electron microscopy (SEM). Different frictional responses were found depending on the thickener, especially at high temperature. Excepting for most severe conditions, wear is negligible when using chemically modified chitin and methylcellulose-based greases as lubricants.
Arias Montano. Repositorio Institucional de la Universidad de Huelva
Publicación Artículo científico (JournalArticle)

AFM and SEM assessment of lubricating grease microstructures : influence of sample preparation protocol, frictional working conditions and composition

  • Roman Fercheluc, Claudia
  • Valencia Barragán, Concepción|||0000-0002-9197-4606
  • Franco Gómez, José María|||0000-0002-3165-394X
  • Roman Fercheluc, Claudia|||0000-0002-7960-5832
The microstructure of lubricating greases greatly conditions their in-service performance. In that sense, optimal testing protocols are required in order to accomplish their correct morphological characterization. This study explores and compares the suitability of atomic force microscopy (AFM) and scanning electron microscopy (SEM) techniques for imaging six different commercial metallic soap-based greases and two novel biopolymer-based formulations. Pros and cons of both techniques and the effect of sample preparation protocol were analysed. The results revealed a wide variety of morphological characteristics depending on composition. Thus, the four anhydrous calcium-based greases demonstrated two clearly distinct microstructures (fibrous and granular) determined by the type of base oil employed. With regard to the lithium complex greases, the typically reported microstructure characterized by well-defined entangled and fibrous network was observed in both AFM and SEM techniques. As for the two biopolymer-based greases, fibre networks were also encountered. Besides this, selected greases were subjected to different tribological tests, and the effect of high-shear frictional working treatments on their microstructure was also analysed. As a result of the friction and internal wear, the AFM results evidenced microstructural changes which depended on grease composition. Overall, the combined use of AFM and SEM techniques was demonstrated to be a powerful approach to microstructurally characterize lubricating greases.