Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

BULERIA. Repositorio Institucional de la Universidad de León
Publicación Artículo científico (JournalArticle)

Ensiling Typha (Typha latifolia) Forage with Different Additives for Ruminant Feeding: In Vitro Studies

  • Evan, Trinidad de
  • Musa, Ahmad Rufai
  • Marcos, Carlos N.
  • Alao, Johnson Sunday
  • Iglesias, Eva
  • Escribano, Fernando
  • Carro Travieso, María Dolores
[EN] Typha is a wild plant with invasive growth that causes environmental problems in different areas worldwide. This study investigated the ensiling potential of typha (Typha latifolia) to be preserved and used for ruminant feeding. Four silage treatments were evaluated: typha with no additives (CON); with formic acid (FA; 4 mL/kg); with urea and molasses (UM; 19 and 24 g/kg, respectively); and with formic acid, urea, and molasses (FAUM; all at previous concentrations). Three bags of each silage were prepared and stored for 4 months before being analysed and fermented in vitro with ruminal fluid from sheep. All of the silages were well preserved, and their pH was greater (p < 0.05) for UM and FAUM (8.50 and 7.70, respectively) compared with CON and FA (5.39 and 4.75). The high concentrations of volatile fatty acid and ammonia−nitrogen in the UM and FAUM silages indicated undesirable fermentations and precluded their use in practice. However, neither CON nor FA silages improved the in vitro ruminal degradability of pre-ensiling typha (61.7, 58.2, and 65.2%, respectively), which was lower than that of a medium-quality triticale hay (68.0%). The results indicate that typha silage could replace low-quality forages in ruminant diets, being adequate especially for low-producing animals or for those under maintenance conditions. More studies with different doses of additives are needed to identify the optimal conditions for ensiling typha and increasing its nutritive value, SI, This research was funded by the Universidad Politécnica de Madrid (Plataforma Africa; Cooperation Funds), the Federal Ministry of Water Resources of Nigeria, and the World Bank (TRIMMING project: Transforming Irrigation Management in Nigeria). Funding from the Spanish State Research Agency (AEI) and the European Regional Development Fund (Project PID2021- 124648OB-C21) is also gratefully acknowledged
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Feed additives for methane mitigation: Recommendations for identification and selection of bioactive compounds to develop antimethanogenic feed additives

  • Durmic, Z.
  • Duin, E.C.
  • Bannink, A.
  • Belanche, A.
  • Carbone, V.
  • Carro, M.D.
  • Crüsemann, M.
  • Fievez, V.
  • García, F.
  • Hristov, A.
  • Joch, M.
  • Martínez-Fernández, Gonzalo
  • Muetzel, S.
  • Ungerfeld, E.M.
  • Wang, M.
  • Yáñez Ruiz, David R.
Despite the increasing interest in developing antimethanogenic additives to reduce enteric methane (CH) emissions and the extensive research conducted over the last decades, the global livestock industry has a very limited number of antimethanogenic feed additives (AMFA) available that can deliver substantial reduction, and they have generally not reached the market yet. This work provides technical recommendations and guidelines for conducting tests intended to screen the potential to reduce, directly or indirectly, enteric CH of compounds before they can be further assessed in in vivo conditions. The steps involved in this work cover the discovery, isolation, and identification of compounds capable of affecting CH production by rumen microbes, followed by in vitro laboratory testing of potential candidates. The finding of new bioactive compounds as AMFA can be based on 2 approaches: empirical and mechanistic. The empirical approach involves obtaining and screening compounds present in databases and repositories that potentially possess the desired effect but have not yet been tested, screening natural sources of secondary compounds such as plants, fungi, and algae for their antimethanogenic effects, or examining compounds with antimethanogenic effect on microbes in other research domains outside the rumen. In contrast, the mechanistic approach is the theoretical process of discovery new bioactive compounds based on existing knowledge of a biological target or process. The in vitro methodologies reviewed include examining effects at the subcellular level, in single pure cultures of methanogens and examining in more complex mixed rumen microbial populations. Simple in vitro methodologies (subcellular assessments and batch culture) allow testing a large number of compounds, whereas more complex systems simulating the rumen microbial ecosystem can test a limited number of candidates but provide better insight about the antimethanogenic efficacy. This work collated the main advantages, limitations, and technical recommendations associated with each step and methodology use during the identification and screening of AMFA candidates., The authors acknowledge the financial support of the Global Dairy Platform through its Pathways to Net Zero initiative. E. Duin is funded by the US Department of Agriculture (Washington, DC; USDA-NIFA-SAS 2024-68012-41582). A. Bannink was funded by the Dutch Ministry of Agriculture, Nature and Food Quality (Project Global Research Alliance; BO-43.10-001-001; The Hague, the Netherlands). A. Belanche is funded by the Spanish State Research Agency (AEI; Madrid, Spain) through a Ramón y Cajal research contract (RYC2019-027764-I) and the project PID2021-12306OB-100. M. D. Carro receives funding from the Spanish State Research Agency (AEI; Madrid, Spain) under project PID2021-124648OB-C21. F. Garcia was supported by the Global Dairy Platform (Rosemont, IL). A. N. Hristov was supported by the USDA (Washington, DC) National Institute of Food and Agriculture Federal Appropriations under Project PEN 04539 and Accession Number 1000803. E. M. Ungerfeld receives support from Agencia Nacional de Investigación y Desarrollo Proyectos Fondecyt (Santiago, Chile) 1190574 and 1240264. M. Wang was supported by National key research and development program of China (Beijing, China; Grant No. 2023YFD1300902). D. R. Yáñez-Ruiz was supported by the European Union's Horizon Europe research and innovation program under the grant agreement No. 01059609 (Re-Livestock project; Brussels, Belgium).
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Fermentation characteristics, chemical composition, microbial quality and in vitro ruminal fermentation of almond hulls silages treated with different additives

  • Recalde, A.
  • Arroyo, J. M.
  • De Evan, T.
  • Alcamí-Aguado, A.
  • Díaz, A.
  • Carro, M. D.
13 páginas, 5 tablas, 3 figuras., Almond hulls (AH) are the main by-product of almond production and are currently used as ruminant feed after field drying. This study evaluated the feasibility of ensiling AH as an alternative preservation method and assessed the effects of different silage additives on fermentation characteristics, chemical composition, microbiological quality and in vitro ruminal fermentation of AH silages. Four silage treatments were studied: control (CON; without any additive), formic acid (FA; 4 mL/kg AH), a mixture of acetic and lactic acids (ALA; 2 mL of each acid/kg AH), and Lentilactobacillus buchneri (LB; 5 × 10⁹ colony forming units/kg AH). Almond hulls were ensiled in vacuum-bags at 530–550 g dry matter/kg and stored for 90 d at room temperature. Compared with CON, all additives reduced (P < 0.05) silage pH to reach below 4.60. Both FA and ALA silages showed the lowest (P < 0.05) dry matter losses (< 25 g/kg AH), whereas LB treatment promoted stronger heterofermentative activity and resulted in the greatest (P < 0.05) concentrations of lactic and acetic acids. No pathogenic bacteria (Escherichia coli, Salmonella spp., Listeria spp., Clostridium perfringens and Staphylococcus coagulase+) were detected in any silage, and all additives decreased (P < 0.05) the growth of yeast and molds compared to CON silages. In vitro 24-h incubations with sheep ruminal fluid showed that LB silages had faster (P < 0.05) fermentation rates and lower (P < 0.05) acetic to propionic ratios than CON silages, but FA treatment decreased (P < 0.05) the production of volatile fatty acids indicating reduced fermentation. A secondary objective of this study was to assess the changes in fermentation characteristics and chemical composition of AH silages over the storage period, and therefore additional silage bags were opened at 0, 4 and 21 d. Compared with CON silage, all additives produced a faster and greater pH decline and resulted in lower concentrations of NH<inf>3</inf>-N at both 4 and 21 days of storage. Except for FA silages, concentrations of lactic acid increased gradually with storage time for all other treatments. Propionic acid was not detected in any silage at any time and acetic concentrations increased with storage time in all silages except FA silage. Concentrations of butyric acid were lower than 0.30 g/kg DM in all silages at all sampling times except for LB silages at 90 d (2.22 g/kg DM). The most marked change in chemical composition over storage was the reduction in the concentration of water-soluble carbohydrates, being the reduction more pronounced for ALA and LB treatments (32.5 and 53.9%, respectively) than for CON and FA (10.2 and 8.0%) silages. The results indicate that ensiling could be a feasible alternative for preserving almond hulls in areas where weather conditions compromise their optimal drying., This research was funded by the Spanish State Research Agency (AEI) and the European Regional Development Fund (Project PID2021–124648OB-C21). T. de Evan received a Margarita Salas grant from the Ministerio de Universidades of the Spanish Government funded by the European Union Next Generation EU (UP2021–035). A. Alcamí-Aguado received ‘Doctorados Industriales’ grant (DIN2024–013451) funded by the MICIU/AEI /10.13039/501100011033., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Effects of feeding agroindustrial byproducts on rumen fermentation and microbiome of sheep

  • Navarro Marcos, Carlos
  • Evan, Trinidad de
  • González Recio, Oscar
  • Gutiérrez-Rivas, Mónica
  • Carro, María Dolores
The use of agroindustrial byproducts in ruminant nutrition is gaining increased attention because of economic and environmental benefits and their potential to enhance ruminal function and animal performance. However, the effect of these byproducts on ruminal microbiome and fermentation has been scarcely investigated. This study aimed to evaluate the effects of replacing conventional feeds with agroindustrial byproducts (18:18:8 mixture of corn dried distillers grains with solubles, dry citrus pulp, and exhausted olive cake) on the ruminal microbiome and fermentation parameters of sheep. Four rumen-fistulated Lacaune sheep were used in 2 experimental periods, receiving mixed diets composed of 50% alfalfa hay and 50% of either a control concentrate (CON diet) or a concentrate with agroindustrial byproducts (BYP diet). Ruminal samples were collected at 0, 3, and 6 h postfeeding to assess microbial composition and fermentation parameters. Diet significantly influenced the ruminal microbiome, but the effect of individual sheep was more pronounced than that of the diet. Sampling time also influenced the ruminal microbiome. The inclusion of agroindustrial byproducts in the concentrate did not significantly alter ruminal fermentation parameters. However, the BYP diet led to more steady ruminal fermentation, preventing large fluctuations in total VFA and ammonia concentrations, likely the result of a broader range of fermentable substrates present in the BYP concentrate and changes in ruminal microbiome. These results may indicate improved synchronization of nutrient availability for ruminal microorganisms. Overall, replacing conventional feed ingredients with agroindustrial byproducts promoted microbial diversity and improved ruminal fermentation, potentially leading to increased dairy ruminant performance., This research was funded by the Spanish State Research Agency (AEI; Madrid, Spain) and the European Regional Development Fund (Projects AGL2016-75322-C2-1-R and PID2021-124648OB-C21; Madrid, Spain)., Peer reviewed
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Feed additives for methane mitigation: Recommendations for identification and selection of bioactive compounds to develop antimethanogenic feed additives

  • Durmic, Zoey
  • Duin, Evert C.
  • Bannink, André
  • Belanche, Alejandro
  • Carbone, Vincenzo
  • Carro, M. Dolores
  • Crüsemann, Max
  • Fievez, Veerle
  • Garcia, Florencia
  • Hristov, Alex
  • Joch, Miroslav
  • Martinez-Fernandez, Gonzalo
  • Muetzel, Stefan
  • Ungerfeld, Emilio M.
  • Wang, Min
  • Yáñez-Ruiz, David R.
Despite the increasing interest in developing antimethanogenic additives to reduce enteric methane (CH4) emissions and the extensive research conducted over the last decades, the global livestock industry has a very limited number of antimethanogenic feed additives (AMFA) available that can deliver substantial reduction, and they have generally not reached the market yet. This work provides technical recommendations and guidelines for conducting tests intended to screen the potential to reduce, directly or indirectly, enteric CH4 of compounds before they can be further assessed in in vivo conditions. The steps involved in this work cover the discovery, isolation, and identification of compounds capable of affecting CH4 production by rumen microbes, followed by in vitro laboratory testing of potential candidates. The finding of new bioactive compounds as AMFA can be based on 2 approaches: empirical and mechanistic. The empirical approach involves obtaining and screening compounds present in databases and repositories that potentially possess the desired effect but have not yet been tested, screening natural sources of secondary compounds such as plants, fungi, and algae for their antimethanogenic effects, or examining compounds with antimethanogenic effect on microbes in other research domains outside the rumen. In contrast, the mechanistic approach is the theoretical process of discovery new bioactive compounds based on existing knowledge of a biological target or process. The in vitro methodologies reviewed include examining effects at the subcellular level, in single pure cultures of methanogens and examining in more complex mixed rumen microbial populations. Simple in vitro methodologies (subcellular assessments and batch culture) allow testing a large number of compounds, whereas more complex systems simulating the rumen microbial ecosystem can test a limited number of candidates but provide better insight about the antimethanogenic efficacy. This work collated the main advantages, limitations, and technical recommendations associated with each step and methodology use during the identification and screening of AMFA candidates.