Resultados de investigación

Data reported in a scientific article 10.1002/adom.202400161 Files 4-5 and files 6-9 belong to same set of measurements, Excel/Origin

Fid of NMR structures can be analyzed with MestReNova software. MS-ESI and FT-IR data can be seen with a pdf reader or with OriginPro software. X-Ray Structures (.cif) can be analyzed through Mercury software. Elemental Analysis can be seen with a pdf reader.

Oscilloscope measurements of the time response of a MoS2 microdrum resonator actuated electrically with a burst signal. The videos shows different actuation frequency response graphed as a phase space portrait time-dependent. File list: 15MHz.mp4, 18_2MHz.mp4 and 19_6MHz.mp4 Relationship between files: Different actuation frequencies of the same microdrum called J30-Op.9-T3B, Format MP4

IMDEA Nanociencia STM laboratories

Files can be opened with any film visualisation programme, such as VLC Media Player.

Data_Fig 4-6 y S4 Data Fig. 3, Formats: For Figure 3 A-C, OriginPro statistical analysis software is required. For Figures 4 -6 and S4 Microsoft Excel software is required.

(i) Multiplet calculations for DPBP+Dy and DPBP+Er; (ii) Point charges for multiplet calculations for DPBP+Dy and DPBP+Er; (iii) STM images for DPBP+Dy and DPBP+Er; (iv) STS data for DPBP+Dy and DPBP+Er; (v) XAS, XMCD and XLD data for DPBP+Dy and DPBP+Er

Description of methods used for collection/generation of data: 2D x-ray scattering patterns were recorded using area detectors: Dectris Pilatus 1M 3S (SAXS) and a Rayonix LX255-HS (WAXS) Methods for processing the data: data reduction was performed using by using Pyton procedures (PyFy) Software- or Instrument-specific information needed to interpret the data, including software and hardware version numbers: Standards and calibration information, if appropriate: calibration files for WAXS and SAXS measurements included Environmental/experimental conditions: a setup including a microfluidic cell was implemented at the BL11 NCD-SWEET beamline of the ALBA synchrotron, File list: Calibrants Figure 1 Figure 2 Figure 3 Relationship between files: Each file contains the data and information used to generate the corresponding figures, including raw data and Pyton procedures employed for data reduction Formats and version Autodesk Fusion 360 files (.f3d): Autodesk Fusion 360 2.0.20476 x86_64 (Older versions will work). Stereolithography files (.stl): Can be opened with any 3D design programs (e.g. Windows’ Visor 3D, Blender…). Image files (.tif, .jpg): Any image reader programs should open these files (Authors recommend ImageJ-Fiji for .tif files). Data files (.txt, .dat): Can be seen with Origin, Excel or Notepad. Scattering data files (.edf): Specific X-ray Scattering programs (e.g. Fit2D) or Python scripts can read these files. Python scripts files (.py): Python: Anaconda Distribution – Spyder IDE 5.5.1 – Python 3.11.9 Specific Libraries: - Numpy 1.26.4 - Pandas 2.1.4 - Seaborn 0.13.2 - Matplotlib 3.8.0 - Os - Fabio 2024.4.0 - Scikit-learn 1.5.0

Python 3.11 custom written software.