Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Electrochemically generated metal-doped 2D-cobalt(M)MOFs@C derivatives for boosting the electrocatalytic oxidation of glycerol to formate

  • Hernandez-Salvador, Sergio
  • Montiel, Miguel A.
  • Molina, M. Asuncion
  • Calvente, Juan Jose
  • Beale, Andrew M.
  • Solla-Gullon, Jose
  • Olloqui-Sariego, Jose Luis
  • Río-Rodríguez, José Luis del
  • Gutiérrez-Tarriño, Silvia
  • Oña-Burgos, Pascual|||0000-0002-2341-7867
[EN] Glycerol is an underutilized waste product that is abundantly available from the biodiesel industry. Electrocatalytic oxidation of glycerol (GOR) to formate offers an environmentally friendly and cost-effective approach to valorizing glycerol. In this study, we have developed new types of metal-doped cobalt metal-organic frameworks, which are grown directly on a carbon matrix via a one-pot synthesis as electrocatalyst precursors. In-depth structural analysis has revealed that, in the Ni-doped cobalt MOF, Ni substitutes a fraction of Co sites isomorphically, forming isolated Ni(II) centers, while Cu is present as a mixture of Cu(II) and metallic Cu, with the majority in the oxidized form as highly dispersed species and a small fraction forming nanoparticles. These materials were then subjected to a controlled potential-induced surface reconstruction to produce mixed-metal oxide/oxyhydroxide-like environments interconnected through M-O-M motifs, the extent of the reconstruction depending strongly on the dopant metal. The metal-doped derivatives were tested as electrocatalysts for the alkaline electrooxidation of glycerol using in-house designed electrochemical reactors with different cell configurations and operating modes. We demonstrated that metal-doped derivative phases exhibit improved electrocatalytic activity for GOR compared to the monometallic counterpart. These catalysts yield significant glycerol conversion rates under single-pass operation, with improved Faradaic efficiencies towards formate (up to 70%) and low energy consumption (< 320 kWh kmol(- 1)), while suppressing the complete oxidation of glycerol to carbonate or CO2. This work provides new insight into the rational design of metal-doped MOF derivatives as highly active and selective electrocatalysts for the practical glycerol valorization., The authors thank the financial support from the Spanish Govern-ment (PID2021-126799NB-I00, PID2022-140111OB-I00, PID2022-13 8491OB-C32, TED2021-130191B-C41, TED2021-130191B-C42 and RED2022-134120-T funded by MCIU/AEI/10.13039/501100011033 and European Union NextGenerationEU/PRTR) . This study forms part of the Advanced Materials program and was supported by MCIN with partial funding from the European Union Next Generation EU (PRTR-C17. I1) , by Generalitat Valenciana (MFA/2022/047, CIPROM/2022/10) . In addition, this work has received funding from the European Union's Horizon 2020 research and innovation program under grant agreement No 101022507. This work was also funded by "Ayuda a Primeros Proyectos de Investigacion (PAID-06-24) . J.L.R.-R. thanks the MCIU for his FPU PhD contract FPU21/02562. S.G.T. thanks the Uni-versitat Politecnica de Valencia for her postdoctoral contract PAID-10-23. M.A.M. acknowledges funding from the EPSRC InFUSE Prosperity Partnership (EP/V038044/1) . The authors acknowledge ALBA Syn-chrotron for access to the NOTOS beamline under Proposal 2023097780 and Diamond Light Source for access to Beamline B18 under Proposal SP45829-1. The authors also thank Eduardo Villalobos, Carlo Marini and the B18 beamline staff for their assistance during the XAS mea-surements. The Electron Microscopy Service of the UPV is acknowledged for their help in sample characterization. Financial support by Severo Ochoa Centre of Excellence program (CEX2021-001230-S) is gratefully acknowledged. Authors are also grateful to Ana Cristina Martinez Cantos (Institute of Electrochemistry, University of Alicante) for her work in the identification and determination of products in the glycerol electro-oxidation process.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publication Artículo científico (JournalArticle)

Comprehensive characterisation of a low-frequency-vibration energy harvester

  • Plaza Puértolas, Aitor
  • Iriarte Goñi, Xabier
  • Castellano Aldave, Jesús Carlos
  • Carlosena García, Alfonso
In this paper, we describe a measurement procedure to fully characterise a novel vibration energy harvester operating in the ultra-low-frequency range. The procedure, which is more thorough than those usually found in the literature, comprises three main stages: modelling, experimental characterisation and parameter identification. Modelling is accomplished in two alternative ways, a physical model (white box) and a mixed one (black box), which model the magnetic interaction via Fourier series. The experimental measurements include not only the input (acceleration)–output (energy) response but also the (internal) dynamic behaviour of the system, making use of a synchronised image processing and signal acquisition system. The identification procedure, based on maximum likelihood, estimates all the relevant parameters to characterise the system to simulate its behaviour and helps to optimise its performance. While the method is custom-designed for a particular harvester, the comprehensive approach and most of its procedures can be applied to similar harvesters., This work has been supported by the Spanish Research Agency, and the EU/PTR Next Generation Funds under grants PID2019-107258RB-C32 and TED2021-131052B-C21, and also by the Government of Spain (Plan Estatal de Investigación Científica, Técnica y de Innovación 2021–2023) under grants PID2022-138491OB-C32 and PDC 2023-145876-C22.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publication Artículo científico (JournalArticle)

Power converter for ultra low-frequency and low-voltage energy harvesters

  • Hualde Otamendi, Mikel
  • Cruz Blas, Carlos Aristóteles de la
  • Castellano Aldave, Jesús Carlos
  • Carlosena García, Alfonso
Energy conversion mechanisms present in some harvesters are only able to provide very low voltage (mV) and fre‑ quency (few Hz) electrical signals, which may also have a bipolar nature (AC). These characteristics make unusable most conventional power converters to extract from them a DC voltage. This letter describes an autonomous selfstarting ultra-low voltage and frequency AC-DC converter that can start the operation for AC signals around 25 mV, and below 10 Hz. The converter has been designed with ultra-low vibration harvesters in mind, but is also of appli‑ cation to, for instance, thermoelectric generators (TEG). The circuit is basically an oscillator driven by the harvester output, which therefore converts a low-frequency and low-voltage signal into large signal oscillation amenable for further DC conversion. The proposed circuit is based on the classical Hartley oscillator, which is modifed in a non‑ trivial confguration, and optimized to be able to operate with bipolar, low frequency and voltage driving signals. This is achieved with a minimum number of passive components and a single JFET transistor. A practical prototype has been fabricated, and measurement results are obtained, demonstrating the feasibility of the approach. Moreover, a vibration harvester with the power converter proposed has been tested in real conditions in a wind turbine., This work was supported by Spanish Research Agency, the EU/PTR Next Generation Funds and European Social Fund Plus (ESF+), under Grant TED2021-131052B-C21, Grant PID2022-138491OB-C32 and Grant PID2022-138510OB-C21.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publication Artículo científico (JournalArticle)

Seasonality in synthetic average wind speed

  • Zivanovic, Miroslav
  • Runacres, Mark
There is a growing demand for computer-generated realistic high-fidelity wind speed data for various applications in the wind industry. Such data should capture the non-stationary dynamics of real-world wind time series, as well as be consistent with the statistical descriptors - the probability density function and power spectral density - of the observed wind speed. However, complying with the statistical descriptors is not a guarantee that the seasonality will be correctly reproduced in synthetic data. The seasonality, characterized by the average diurnal and seasonal variations, is driven by the periodicities embedded in diurnal and annual harmonic series respectively. Those periodicities are determined by the long-term orbital forcing components, which establish the insolation for a given latitude and longitude. We show that average diurnal and seasonal variations can be visualized as the output of comb filters, whose fundamental frequencies match the diurnal and annual fundamental frequency respectively. The aforementioned theoretical findings are readily reproduced in synthetic wind speed, generated by a non-parametric data-driven statistical model, based on the phase-randomized Fourier transform. The model, tested on both 10-min and 1-min resolution real-world datasets, yields average non-stationarities in synthetic wind speed with the accuracy close to the computing precision., Funding text 1: This work has been supported by the Spanish Research Agency, and the EU/PTR Next Generation Funds under grants TED2021-131052B-C21, and PID2022-138491OB-C32.; Funding text 2: This work has been supported by the Spanish Research Agency, and the EU/PTR Next Generation Funds under grants TED2021-131052B-C21, and PID2022-138491OB-C32.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publication Artículo científico (JournalArticle)

Low-frequency electromagnetic harvester for wind turbine vibrations

  • Castellano Aldave, Jesús Carlos
  • Plaza Puértolas, Aitor
  • Iriarte Goñi, Xabier
  • Carlosena García, Alfonso
In this paper we describe and fully characterize a novel vibration harvester intended to harness energy from the vibration of a wind turbine (WT), to potentially supply power to sensing nodes oriented to structural health monitoring (SHM). The harvester is based on electromagnetic conversion (EM) and can work with vibrations of ultra-low frequencies in any direction of a plane. The harvester bases on a first prototype already disclosed by the authors, but in this paper, we develop an accurate model parameterized by a combination of physical parameters and others related to the geometry of the device. The model allows predicting not only the power generation capabilities, but also the kinematic behaviour of the harvester. Model parameters are estimated by an identification procedure and validated experimentally. Last, the harvester is tested in real conditions on a wind turbine., This paper has been supported by the Spanish Research Agency, and the EU/PTR Next Generation Funds under grants PID2019-107258RBC32, TED2021-131052B-C21, and PID2022-138491OB-C32. The Public University of Navarre has also partially supported this project under grant: PJUPNA2024-11690.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publication Artículo científico (JournalArticle)

A novel ultra-low input voltage and frequency self astarting AC-DC boost converter for micro energy harvesting

  • Castellano Aldave, Jesús Carlos
  • Cruz Blas, Carlos Aristóteles de la
  • Carlosena García, Alfonso
In this letter, a novel low-voltage junction field-effect transistor (JFET) oscillator with self-starting capability to implement an ac-dc boost converter is introduced. The circuit is transformer free and can operate with very low-voltage and low-frequency signals. In order to operate with positive and negative input signals, a coupled topology of JFETs has been used. The circuit has been built using off the shelf components, and can be used with electromagnetic harvesters, thermoelectric modules, and/or wearable devices. Experimental results with a practical harvester are provided in order to demonstrate the proposed ac-dc boost converter., This work was supported by Spanish Research Agency and the EU/PTR Next Generation Funds, under Grant TED2021-131052B-C21, Grant PID2019-107258RB-C32, and Grant PID2022-138491OB-C32.