Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publication Artículo científico (JournalArticle)

±0.25 V Class-AB CMOS capacitance multiplier and precision rectifiers

  • Pourashraf, Shirin
  • Ramírez-Angulo, Jaime
  • Hinojo Montero, José María
  • González Carvajal, Ramón
  • López Martín, Antonio
Reduction of minimum supply requirements is a crucial aspect to decrease the power consumption in VLSI systems. A high performance capacitance multiplier able to operate with supplies as low as ±0.25 V is presented. It is based on adaptively biased class-AB current mirrors which provide high current efficiency. Measurement results of a factor 11 capacitance multiplier fabricated in 180 nm CMOS technology verify theoretical claims. Moreover, low-voltage precision rectifiers based on the same class-AB current mirrors are designed and fabricated in the same CMOS process. They generate output currents over 100 times larger than the quiescent current. Both proposed circuits have 300 nW static power dissipation when operating with ±0.25 V supplies., This work was supported by the Spanish National Research Agency under Grant TEC2016-80396-C2 (AEI/FEDER)
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publication Artículo científico (JournalArticle)

CMOS first-order all-pass filter with 2-Hz pole frequency

  • Paul, Anindita
  • Ramírez-Angulo, Jaime
  • López Martín, Antonio
  • González Carvajal, Ramón
A CMOS fully integrated all-pass filter with an extremely low pole frequency of 2 Hz is introduced in this paper. It has 0.08-dB passband ripple and 0.029-mm2 Si area. It has 0.38-mW power consumption in strong inversion with ±0.6-V power supplies. In subthreshold, it has 0.64-uW quiescent power and operates with ±200-mV dc supplies. Miller multiplication is used to obtain a large equivalent capacitor without excessive Si area. By varying the gain of the Miller amplifier, the pole frequency can be varied from 2 to 48 Hz. Experimental and simulation results of a test chip prototype in 130-nm CMOS technology validate the proposed circuit., This work was supported by AEI/FEDER under Grant TEC2016-80396-C2.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publication Artículo científico (JournalArticle)

A highly efficient composite class-AB–AB Miller op-amp with high gain and stable from 15 pF up to very large capacitive loads

  • Pourashraf, Shirin
  • Ramírez-Angulo, Jaime
  • López Martín, Antonio
  • González Carvajal, Ramón
In this paper, a highly power-efficient class-AB–AB Miller op-amp is discussed. The structure uses gm enhancement based on local common-mode feedback to provide class-AB operation with enhanced effective gm , open-loop gain, unity-gain frequency, and slew rate ( SR ) without significant increase in quiescent power consumption. Utilization of a nonlinear load leads to large symmetric positive and negative SRs . Stability over an extremely wide range of capacitive loads is achieved through a combination of Miller and phase-lead compensations. The unity-gain frequency does not show sensitivity to capacitive load values. A test chip prototype fabricated in 0.18- μm CMOS technology shows 90.8-dB open-loop gain, 12.5-MHz bandwidth for a 25-pF load capacitance, and a factor 60 SR enhancement with maximum output current close to 1-mA and 43- μA total static current., This work was supported by the Spanish National Research Agency under Grant TEC2016-80396-C2.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publication Artículo científico (JournalArticle)

Class AB amplifier with enhanced slew rate and GBW

  • Garde Luque, María Pilar
  • López Martín, Antonio
  • Algueta-Miguel, Jose M.
  • Ramírez-Angulo, Jaime
  • González Carvajal, Ramón
The design of a micropower class AB operational transconductance amplifier with large dynamic current to quiescent current ratio is addressed. It is based on a compact and power-efficient adaptive biasing circuit and a class AB current follower using the Quasi-Floating Gate (QFG) technique. The amplifier has been designed and fabricated in a 0.5 um CMOS process. Simulation and measurement results show a slew rate (SR) improvement factor versus the class A version larger than 4 for the same supply voltage and bias currents, as well as enhanced small-signal performance., Grant TEC2016‐80396‐C2‐1‐R (AEI/FEDER) and Obra Social La Caixa—Fundación Caja Navarra