Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Contribución de congreso (ConferenceOutput)

Potential for Fault Reactivation Due to CO2 Injection in a Semi-Closed Saline Aquifer

  • Vilarrasa, Víctor
  • Makhnenko, Roman Y.
  • Laloui, Lyesse
CO2 injection in extensive saline aquifers that present no faults is unlikely to damage the caprock sealing capacity. In contrast, CO2 injection in closed reservoirs will induce a large pressure buildup that may reactivate the low-permeable faults that bound the reservoir. However, the vast majority of CO2 storage formations will be extensive saline aquifers bounded by a limited number of low-permeable faults. Such storage formations have received little attention and are the focus of this study. We model an extensive aquifer bounded by a heterogeneous low-permeable fault on one side and having open boundaries on the other sides. Simulation results show that the storage formation pressurizes between the injection well and the low-permeable fault, causing total stress changes and effective stress reduction around the fault. These changes lead to yielding of the fault core that is next to the lower half of the storage formation when injecting in the hanging wall. The yield of the fault core would induce a sequence of microseismic events with accumulated seismic moment equivalent to an earthquake of magnitude 1.7, which would not be felt on the ground surface and would not enhance permeability of the ductile clay-rich fault. © 2017 The Authors., V.V. acknowledges support from the ‘EPFL Fellows’ fellowship programme co-funded by Marie Curie, FP7 Grant agreement no. 291771. R.M. activities are sponsored by SCCER-SoE (Switzerland) grant KTI.2013.288 and Swiss Federal Office of Energy (SFOE) project CAPROCK #810008154., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Contribución de congreso (ConferenceOutput)

Hydromechanical Aspects of CO2 Breakthrough into Clay-rich Caprock

  • Makhnenko, Roman Y.
  • Vilarrasa, Víctor
  • Mylnikov, Danila
  • Laloui, Lyesse
Caprock formations are intended to prevent upwards carbon dioxide (CO2) migration to the surface during CO2 geological storage. Caprock interaction with CO2, as well as its potential consequences, requires to be predicted, and thus, need to be studied experimentally. Laboratory investigations of caprock behavior are complex due to its low permeability, and the scarcity of experimental studies involving high-pressure CO2 injection into caprock representatives puts this difficulty into manifest. In this study, we perform laboratory experiments in an oedometric cell on intact and remolded Opalinus clay (Jurassic shale), evaluating the breakthrough pressure and permeability for liquid and supercritical CO2. Intact and remolded shale specimens present intrinsic permeabilities of 10-21 m2 to 10-20 m2, respectively. Applied axial stress ranges from 27 MPa to 42 MPa and the pressure and temperature conditions are representative of a caprock at a depth of 800 m. We found that the microstructure of the caprock has a great effect on the material properties. The intrinsic permeability of a more tight material (intact Opalinus clay) is around two times lower than that of remolded shale, which has a more open microstructure. Additionally, the intact rock becomes 30 times less permeable to CO2 than the remolded shale, which implies that the CO2 relative permeability is 15 times smaller for intact rock than for remolded shale. On the other hand, CO2 breakthrough pressure for the tighter material is almost three times lower than for the more permeable remolded shale. Breakthrough pressure of the remolded shale ranges from 3.9 MPa to 5.0 MPa for liquid CO2 and from 2.8 MPa to 4.6 MPa for supercritical CO2. For the intact shale, breakthrough pressure is 0.9 MPa for liquid CO2 and 1.6 MPa for supercritical CO2. Thus, the breakthrough pressure cannot be correlated with the intrinsic permeability of the caprock. © 2017 The Authors., Opalinus clay cores were provided by Swisstopo in the framework of Mont Terri Project, CS-C experiment. R. Makhnenko activities are sponsored by SCCER-SoE (Switzerland) grant KTI.2013.288 and Swiss Federal Office of Energy (SFOE) project CAPROCK #810008154. V. Vilarrasa acknowledges support from the ‘EPFL Fellows’ fellowship programme co-funded by Marie Curie, FP7 Grant agreement no. 291771., Peer reviewed