Skip to main content

DESARROLLO Y APLICACION DE ENSAYOS NO DESTRUCTIVOS BASADOS EN ONDAS MECANICAS PARA LA EVALUACION Y MONITORIZACION DE REOLOGIA Y AUTOSANACION EN MATERIALES CEMENTANTES

BIA2017-87573-C2-1-P

•
Funding agency name Agencia Estatal de Investigación
Funding agency acronym AEI
Program Programa Estatal de Fomento de la Investigación Científica y Técnica de Excelencia
Subprogram Subprograma Estatal de Generación de Conocimiento
Call Proyectos de I+D (Excelencia / Generación de Conocimiento)
Call year 2017
State Plan 2017-2020 Plan Estatal de Investigación Científica y Técnica y de Innovación
Beneficiary centre UNIVERSITAT POLITÈCNICA DE VALÈNCIA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 1
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Contribución de congreso (ConferenceOutput)

Airborne ultrasounds for damaged cementitious characterization

  • Gosálbez Castillo, Jorge|||0000-0001-6520-9014
  • CARRIÓN GARCÍA, ALICIA|||0000-0002-0630-6065
  • Paya Bernabeu, Jorge Juan|||0000-0001-7425-5311
  • Gallardo, C.
  • Vázquez, S.
  • Genovés, V.
[EN] The scope of this paper is to demonstrate the capability of airborne non-contact ultrasound (ANC-US) to assess thermal damage on normalized Portland cement mortar specimens. For this purpose, contact ultrasound (C-US) and ANC-US are compared. A normalized dosage mortar was carried out to obtain standardized mortar specimens of 4 x 4 x 16 cm. Then, they were measured by ANC-US and C-US. Afterwards, they were thermal damaged (400º C) and measured again. Ultrasound velocity and frequency attenuation were estimated. As expected, damaged samples show lower velocities and higher attenuations than sound samples. It is remarkable how the attenuation keeps constant for frequencies below 100 kHz and increases due to the sensitivity of higher frequencies to the size of thermal microcracking. Although ANC-US does not require any coupling media as C-US does, it requires additional calibration to compensate propagation through the air and material boundaries. Considering these terms, both techniques offer consistent results and the capability of ANC-US technique for damage characterization in cementitious systems is proved., The authors acknowledge the support from T. Gomez Álvarez-Arenas (Institute for Physical and Information Technologies ITEFI-CSIC) and Spanish Administration under grant BIA2017- 87573.