DIGITAL.CSIC. Repositorio Institucional del CSIC
Research data
Set de datos (Dataset)
Supplementary material for Techno-economic analysis of a chemical looping combustion process for biogas generated from livestock farming and agro-industrial waste [Dataset]
Both fuel and air reactors were considered fluidized beds in a turbulent or rapid fluidization regime, according to the terminology developed by Kunii and Levenspiel. For their modeling, the fluid-dynamic model presented by Pallarès and Johnsson was adapted to the specific conditions of CH4 combustion by CLC. The fluid dynamic model can be considered 1.5D. The axial direction was the main dimensional parameter, but the existence of gas and solid diffusion in the radial direction was also considered. Both reactors were divided into two regions in the axial direction, each one with different characteristics regarding the distribution and mixing of the oxygen carrier particles. A dense zone was considered in the lower part, with an approximately constant concentration of solids, and a diluted zone above it with a decay of the solids concentration with the height of the reactor. The mass balance in each reactor was carried out considering the main reactions that take place between the oxygen carriers and the reacting gas. The model included the corresponding reaction kinetics as well as the relevant gas phase reactions. The mass balance was developed for every reacting compound in each phase described in the fluid dynamic model. A detailed description of the model along with the equations that govern the fluid dynamic and the mass balance modules are included in previous works. The model was solved using Fortran® code as a high-level programming language. The used algorithm solved simultaneously the air and fuel reactors until the convergence of the solids conversion was reached. This implied that the following essential requirement had to be met at steady state: the amount of oxygen that reacted in the air reactor was the same as that transferred in the fuel reactor. The calculation was done for a given value of the solids circulation rate and, consequently, the oxygen carrier-to-fuel ratio (Φ parameter).
For the design of the CLC unit, it was considered the inlet gas velocity at the inlet of every reactor. The gas velocity at the inlet of the air reactor, Ug,AR, was set at 6 m/s to reduce the cross sectional area of the reactor and to allow a high solids entrainment rate in the fast fluidization regime. Likewise, the fuel reactor operated in the turbulent fluidization regime and it was assumed that the gas velocity at the inlet of the reactor, Ug,FR, was equal to the terminal velocity, Ut, of the oxygen carrier particles. This parameter was different for each oxygen carrier since it depended on the operating temperature of the reactor and the density of the material. Figure S1 graphically illustrates the fluidization regime of the fuel reactor and the air reactor in the flow regime map.-- Under a Creative Commons license BY-NC-ND 4.0, S.1. Brief description of the CLC model: Figure S1. Fluidization regime for the fuel reactor and air reactor in the flow regime map., This work was supported by the SWINELOOP (PID2019-106441RB-I00/AEI/10.13039/501100011033) and CSIC 202180I016 projects. A. Cabello is also grateful for Grant IJC2019-038908-I funded by MCIN/AEI/10.13039/501100011033., Peer reviewed