Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 3
Encontrada(s) 1 página(s)

Recercat. Dipósit de la Recerca de Catalunya
Publicación Artículo científico (JournalArticle)

Inter-comparison of commercial continuous radon monitors responses

  • Radulescu, Ileana
  • Calin, M. R.
  • Luca, A.
  • Röttger, Annette
  • Grossi, Claudia
  • Done, Laurentiu
  • Ioan, M. R.
Indoor and outdoor (atmospheric) radon activity concentrations need to be measured as accurate as possible for radiation protection and for climate applications. Particularly radon concentrations below 100 Bq m -3, useful for the retrieval of radon prone areas and for atmospheric studies, still need a robust metrological chain to ensure their quality. Ones of the most common used commercial continuous radon monitors were compared here under slightly different environmental conditions. The measured data set were divided into two groups (< 100 Bq m -3 and 100 Bq m -3) to assess the monitors responses and their associated uncertainties. Nevertheless, these results should also to point out if commercial monitors are suitable for monitoring low atmospheric radon concentrations with an associated uncertainty of 10% (k=1). This work, carried out within the EMPIR 19ENV01 traceRadon project, aims to offer a starting point for the development of a future radon monitor as transfer standard to increase the metrological capabilities of atmospheric radon monitoring., Peer Reviewed, Postprint (published version)
Recercat. Dipósit de la Recerca de Catalunya
Publicación Artículo científico (JournalArticle)

A self-calibrating and multiplexed electrochemical lab-on-a-chip for cell culture analysis and high-resolution imaging

  • Giménez-Gómez, Pablo
  • Rodríguez-Rodríguez, Rosalía
  • Ríos, Juan Manuel
  • Pérez-Montero, Marta
  • González, Estrella
  • Gutiérrez-Capitán, Manuel
  • Plaza, Jose Antonio
  • Muñoz-Berbel, Xavier
  • Jiménez-Jorquera, Cecilia
This work was supported by the Spanish R & D National Program (MEC Project TEC2014-54449-C3-1-R and RTI2018-100773-B-C31)., In vitro analysis requires cell proliferation in conditions close to physiological ones. Lab-on-a-chip (LoC) devices simplify, miniaturize and automate traditional protocols, with the advantages of being less expensive and faster due to their shorter diffusion distances. The main limitation of current LoCs is still the control of the culture conditions. Most LoCs employ off-chip equipment to determine cell culture activity, which confers limited monitoring capacity. The few systems integrating transducers on-chip present important functional problems mostly associated with the attachment of biomolecules to the transducer surface (i.e., biofouling) and the impossibility of re-calibrating the sensors during cell culturing. This limitation is addressed in the present LoC containing a network of micro-channels and micro-chambers, which allows (i) cell seeding and cultivation, avoiding biofouling risk, (ii) multiplexed analysis of cell culture, reactivation and recalibration of the (bio)sensors without compromising cell viability, (iii) cell imaging and (iv) reference electrode compartmentalization to guarantee stability. The activity of the culture is monitored with four independent electrochemical micro-electrodes for glucose, hydrogen peroxide, conductivity and oxidation reduction potential. Electrochemical analysis is complemented with high-resolution confocal microscopy analysis. This paper demonstrates the suitability of the current configuration for cell culture monitoring and future applications in drug screening or organ-on-a-chip development., info:eu-repo/semantics/acceptedVersion
Recercat. Dipósit de la Recerca de Catalunya
Publicación Artículo científico (JournalArticle)

Herramientas para la docencia de control digital en grados de ingeniería, Tools for teaching digital control in engineering degrees

  • Lerma Macaya, Eneko
  • Costa Castelló, Ramon
  • Griñó Cubero, Robert
  • Sanchis, Carlos
En este trabajo se describen un conjunto de materiales pedagógicos que han sido desarrollados para dar soporte a la docencia del control digital. En particular, se presentan un conjunto de herramientas interactivas y el proyecto Duino-Based Learning (DBL) pensado para desarrollar prácticas experimentales de control digital utilizando Arduino. Además, se describe el contenido de un curso de control digital, que  se imparte en el marco de una titulación de ingeniería industrial, y como se utilizan las diferentes herramientas desarrolladas en su docencia., Peer Reviewed, Postprint (published version)