RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación
Artículo científico (JournalArticle)
Inter-laboratory study on the influence of 3D concrete printing set-ups on the bond behaviour of various reinforcements
[EN] This study investigates the influence of different printing set-ups and materials on the bond strength of reinforcement manually placed between 3D printed concrete layers. An identical experimental campaign was performed at two institutes in Switzerland and Italy. Each institute used its own printing process, which consisted either of a set on-demand mix or a high yield stress material. Two types of reinforcement (reinforcing bar Ø8 mm and a high strength steel wire Ø1 mm) and three production configurations (casting and printing with the reinforcement parallel or perpendicular to the printing direction) were investigated. The results showed high bond strength with only a limited influence of the fabrication method for the reinforcing bars. An increased bond was observed for the set on-demand approach compared to the high yield strength material. The comparison with existing models showed that the reinforcing bar bond strength of printed concrete varies slightly from conventional concrete. The high strength wires exhibited poor bond. Based on the gathered experiences, insights into the standardisation of testing for 3D concrete printing are discussed., The authors would like to thank the team of Etesias (Napoli, Italy) and Ana Anton (Digital Building Technologies, ETH Zurich) and Lex Reiter (Chair of Physical Chemistry of Building Materials, ETH Zurich) for their support in the printing laboratory. Furthermore, the authors are grateful for the support of the two teams of the structural labs at both institutes. At ETH Zurich, the experimental campaign was funded, and the exchange was supported by the Swiss National Science Foundation, within the National Centre for Competence in Research in Digital Fabrication (project number 51NF40-141853) . At UniNa, the experi-mental activities were supported by Italcementi Heidelberg CementGroup (industrial partner of the PhD program) and by the Italian Ministry of University and Research (MIUR) under program PON 2014-2020 (CCI 2014IT16M2OP005) . A special thanks for enabling the exchange and supporting the research goes to Prof. Dr. Walter Kaufmann (ETH Zurich).