Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

Helvia. Repositorio Institucional de la Universidad de Córdoba
Publicación Artículo científico (JournalArticle)

Photochemical emission and fixation of NOX gases in soils

  • Barrón, Vidal
  • Méndez, José M.
  • Balbuena, José
  • Cruz-Yusta, Manuel
  • Sánchez Granados, Luis
  • Giménez, Carmen
  • Sacristán, Daniel
  • González-Guzmán, Adrián
  • Sánchez-Rodríguez, Antonio Rafael
  • Skiba, Ute M.
  • Inda, Alberto V.
  • Marques Jr., José
  • Recio, José M.
  • Delgado, Antonio
  • Campillo, María del Carmen del
  • Torrent, J.
Gaseous nitrogen oxides (NOx), which result from combustion of fossil fuels, volcanic eruptions, forest fires, and biological reactions in soils, not only affect air quality and the atmospheric concentration of ozone, but also contribute to global warming and acid rain. We provide evidence of gas exchange in soils involving emissions of NOx by effect of photochemical reactions, and their counterpart fixation through photocatalytic reactions under UV-Visible irradiation. The catalytic activity promoting NOx capture as nitrate varied widely amongst different soil types, from low in quartzitic sandy soils to high in iron oxide and TiO2 rich soils. Clay soils with significant amounts of smectite also exhibited high rates of NOx sequestration and fixed amounts of N comparable to NO (nitric oxide) losses through biotic reactions. This mechanism of N fixation provides a new insight into the nitrogen cycle and may inspire alternative strategies to reduce NO emissions from soils.
Helvia. Repositorio Institucional de la Universidad de Córdoba
Publicación Artículo científico (JournalArticle)

Chlorine-assisted synthesis of Mn-deficient LiMn2O4 spinel with ultra-high-rate capability and long-term cyclability in half and full Li ion cells

  • Luna Lama, Fernando
  • Barbosa, Lucía
  • Tesio, Álvaro Y.
  • Caballero, Álvaro
  • Morales, Julián
A different route is proposed to reduce the Mn3+ content in LiMn2O4 spinel. Manganese ions are responsible for both the Jahn–Teller distortion and the dissolution of Mn in the electrolyte, the main causes of low cycling stability and limited rate capability. For this, Cl2 was used as an oxidising agent to promote partial oxidation of Mn3+ without destroying the spinel structure. The X-ray diffraction (XRD) pattern recorded with Mo Kα1 confirmed the formation of a spinel defective in Mn, with Li1.06Mn1.94O4 stoichiometry. The Mn vacancies were occupied by excess Li together with the presence of a layered Li2MnO3 phase as an impurity. Combining SEM images and EDX spectra, it was possible to differentiate both components as independent phases with different morphology. The spinel has a remarkable rate capability in the half-cell configuration from 1C to 50C, delivering an average capacity of 130 to 96 mA h g−1, respectively. Also, it has excellent cycling stability, as revealed by the capacity retention values, between 98–96% from 0.5 (500 cycles) to 10C (1000 cycles), maintaining high capacity values, from 138 to 127 mA h g−1, respectively. Furthermore, it can deliver high power, 26 196 W kg−1, with a high energy of 322 W h kg−1. To our knowledge, our spinel delivers the highest specific energy for lower power values reported so far. These excellent properties can be attributed to both its Mn deficiency, which decreases Mn3+, and the good transport properties obtained from CV and EIS techniques. The first, together with the high crystallinity and micrometric particle size, would mitigate the dissolution of Mn and enhance the structure stability. On the other hand, the high rates that the electrode supports can be ascribed to the high values of Li+ diffusion coefficient averaged to the different stages of the process, around 4 × 10−10 cm2 s−1. Spinel also provides satisfactory performance in full cells using MCMB as an anode and a positive/negative ratio close to 1 without the need for a prelithiation process. Thus, for power values of 10 567 W kg−1, it supplied an energy of 196 W h kg−1.
Helvia. Repositorio Institucional de la Universidad de Córdoba
Publicación Artículo científico (JournalArticle)

Green biomass-derived hierarchically porous non-activated carbon from carob waste for high-performance lithium-sulfur batteries

  • Zoubir, Otmane
  • Lallaoui, Abdelfettah
  • Edfouf, Zineb
  • Caballero, Álvaro
  • Tesio, Álvaro Y.
To expedite the development of lithium-sulfur (Li–S) battery technology, it is necessary to address the inherent technological hurdles surrounding sulfur-based cathodes, including mitigating the shuttle effect and enhancing the electrical conductivity of sulfur. The use of biomass-derived carbonaceous materials offers a promising avenue to alleviate these challenges and help reduce the carbon footprint associated with battery technologies. Herein, we report the green synthesis of carob-derived carbonaceous material without additional physical/chemical activation steps, making the process sustainable, affordable, and eco-friendly. The obtained carob-derived carbon (CC) offers a hierarchical micro/meso/macroporous structure with a high surface area of 633 m2 g−1. The electrochemical performance with a sulfur content of 70% (CC@S70) in the composite and a sulfur mass loading of 1 mg cm−2 delivers an initial discharge capacity of 1405 mAh g−1, reducing to 798 mAh g−1 after 260 cycles. Increasing the sulfur content to 90% in the cathode (CC@S90) yields a high capacity in Li–S cells, reaching a discharge capacity of 937 mAh g−1 with a sulfur loading of 2 mg cm−2 at 0.3C (1C = 1675 mA g−1) after 100 cycles. The improved performance can be attributed to the well-preserved interconnected pores within the carbon material, serving as an efficient framework to accommodate high sulfur content.
Helvia. Repositorio Institucional de la Universidad de Córdoba
Publicación Artículo científico (JournalArticle)

Understanding the role played by Cu nanoparticles embedded in situ in a carbonaceous matrix as sulfur host for lithium-sulfur batteries

  • Soler-Piña, Francisco Javier
  • Morales, Julián
  • Caballero, Álvaro
  • Rodríguez-Castellón, Enrique
Embargado hasta 10/12/2026, The lithium-sulfur (Li-S) battery is a promising alternative to Li-ion batteries as an energy storage system, owing to its higher capacity and specific energy values. To tackle its intrinsic problems, the element copper (Cu) is an attractive option given both its excellent conductivity and its ability to interact with highly reactive polysulfides. Here, we propose the use of a carbon/copper composite (90.5:9.5 wt ratio) obtained by thermal decomposition of a single precursor based on a Cu(II) oleate/oleic acid complex and eliminating the use of H2 as a reducing agent as commonly reported. Cu nanoparticles (mean particle size around 15 nm in diameter) which are highly dispersed on an amorphous carbon matrix derived from an organic framework, enhance both the conductivity and the ability for the chemical adsorption of lithium polysulfides (LiPSs), and thus increasing the reaction efficiency. Poor cycling stability, less specific capacity, and diminished rate capability were observed when the Cu content was reduced to around 70 % through treatment with concentrated nitric acid. This confirms the electrocatalytic role of the metal.
Helvia. Repositorio Institucional de la Universidad de Córdoba
Publicación Artículo científico (JournalArticle)

Dynamic polarization control unlocks long-life, high-efficiency Lithium-Sulfur batteries

  • González-Jiménez, José R.
  • Jiménez Romero, Francisco Javier
  • López Luna, Mª del Carmen
  • Bonilla, Álvaro
  • Caballero, Álvaro
Lithium‑sulfur (Lisingle bondS) batteries offer exceptional theoretical capacity and energy density but are hindered in practice by sluggish reaction kinetics and severe polarization effects. Here, we introduce a pioneering Polarization-Controlled Charging Protocol (PPC) that dynamically adjusts the charging current in real time by maintaining a constant polarization threshold. This strategy accelerates charging in kinetically favorable regimes while suppressing current in polarization-prone regions, thereby preserving electrode structure and extending cycle life. The PPC yields a linear voltage-time charging profile, enabling direct state-of-charge (SOC) estimation and accurate charging time prediction. Average long-term cycling demonstrates that PPC can double battery lifespan. Compared to constant-current charging (CC), PPC achieves over 800 stable cycles at selected C-rates, while CC leads to faster capacity fading. The found average Li diffusion coefficient in PPC is seven times higher than that of the CC conditions, supporting hasted reaction kinetics. Overall, PPC reduces degradation by ∼69 % under equivalent average kinetics conditions, and offers a non-chemical, kinetics-responsive strategy to enhance durability, efficiency, and control in Lisingle bondS batteries, with strong relevance for high-demand applications such as electric mobility.