Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Reuse of coal mining waste to lengthen the service life of cementitious matrices

  • Caneda-Martínez, Laura
  • Frías, Moisés
  • Sánchez-Montero, Javier
  • Medina, César
  • Sánchez de Rojas, María Isabel
A chloride-induced accelerated corrosion test was conducted on steel bars embedded in mortar specimensprepared with thermally activated coal mining waste (ACMW). ACMW was observed to prompt two oppositeeffects: a delay in chloride ion penetration and a reduction in the critical chloride content needed to initiatecorrosion. Service life predictions based on thefindings revealed that adding 20% or 50% ACMW to cementimproved reinforcement corrosion resistance. Optimal results were observed for 20% replacement, in which themean reinforcement section loss was 21% lower than in OPC, Funding for this research was provided by the Spanish Ministry of the Economy and Competitiveness (MINECO) and the European Regional Development Fund (ERDF) [ref. BIA-2015-65558-C3-1,2,3-R], as well as by the Spanish Training Programme (MINECO) and the European Social Fund (ESF) [ref. BES-2016-078454]. The support received from Sociedad Anónima Hullera Vasco-Leonesa, SIKA (Madrid, Spain) and the Instituto Español del Cemento y sus Aplicaciones (IECA, Spanish cement institute) is gratefully acknowledged., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Water transport in binary eco-cements containing coal mining waste

  • Caneda-Martínez, Laura
  • Medina, César
  • Sánchez de Rojas, María Isabel
  • Frías, Moisés
This study explores certain indirect, water transport-related durability indicators for mortars made with cement in which 20% or 50% of the ordinary portland cement (OPC) is replaced by thermally activated coal mining waste (ACMW). The valorisation of ACMW is triply beneficial, environmentally speaking, for it reduces waste stockpiling and its processing emits less CO2 and requires less fossil fuel-based energy than OPC manufacture. Its addition was observed to generate a finer pore structure and a larger volume of pores accessible to water. In mortars with 50% ACMW, pore volume rose by approximately 30%, lowering density and consequently mechanical strength. Total water absorption declined by 13% and capillary absorption by 24% in mortars with 20% ACMW, whilst no significant variations in either parameter relative to the OPC reference were found in the materials with 50% replacement ratios. Permeability to water penetration under pressure rose substantially in both blended mortars, although as the maximum and mean depth values lay within the limits specified in Spain's structural concrete code, the materials would be classified as impermeable. The mortars with 20% replacement exhibited no greater drying shrinkage than the OPC materials, whereas the mortars bearing 50% ACMW shrank by approximately 50% more than the reference., Funding for this research was provided by the Spanish Ministry of the Economy and Competitiveness (MINECO) and the European Regional Development Fund [ref. BIA-2015-65558-C3-1,2,3-R], as well as by the Spanish Training Programme (MINECO) and the European Social Fund [ref. BES-2016-078454]. The support received from the Instituto Español del Cemento y sus Aplicaciones (IECA, Spanish cement institute), SIKA (Madrid, Spain) and Sociedad Anónima Hullera Vasco-Leonesa is gratefully acknowledged., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Exploring sulphate resistance of coal mining waste blended cements through experiments and thermodynamic modelling

  • Caneda-Martínez, Laura
  • Kunther, Wolfgang
  • Medina, César
  • Sánchez de Rojas, María Isabel
  • Frías, Moisés
This study evaluates the sulphate resistance of blended cement derived from the addition of thermally activated coal waste as pozzolan, at replacement levels of 0%, 20% (CMW20) and 50% (CMW50) with a multi-method approach. The pastes were prepared at a w/b ratio of 0.5, using a water-reducing admixture in the blended pastes to compensate for their high water demand. Sulphate resistance is reduced in CMW20 pastes, while longterm benefits are observed for CMW50 pastes, although moderate signs of deterioration are observed at the beginning of the exposure. The initial damage in CMW50 pastes is attributable to the precipitation of products (mainly ettringite and monosulphoaluminate) in the small capillary pores (<0.01 ¿m). This is prevented in OPC and CMW20 pastes since their microstructure allow the precipitation in the macropores (>0.05 ¿m). The greater long-term resistance of CMW50 pastes was explained by thermodynamic calculations, which suggests that the lower calcium leachability of these cements prevented gypsum formation. This, together with the higher content of carboaluminate phases, leads to lower supersaturation levels in the pore solution with respect to ettringite, reducing stresses derived from sulphate exposure., This work was supported by the Spanish Ministry of Economy and Competitiveness and the European Regional Development Fund (MINECO/FEDER) [grant number BIA-2015-65558-C3-1,2,3-R] and as well as by the Spanish Training Program, and the European Social Fund (MINECO/FSE) [grant number BES-2016-078454]. The authors are also grateful to the Sociedad An´onima Hullera Vasco-Leonesa, SIKA (Madrid, Spain), the Spanish Cement Institute (IECA) and the Scientific Research Support Services of the University of A Coru˜na for their assistance. The sample preparation of the SEM samples by A. M. Rzepkiewicz-Hansen is gratefully acknowledged.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Influence of the fiber treatment and matrix modification on the durability of eucalyptus fiber reinforced composites

  • Mejia-Ballesteros, Julian Eduardo
  • Rodier, L.
  • Filomeno, R.
  • Savastano, H.
  • Frías, Moisés
  • Fiorelli, Juliano
It is well known that the most important issue of cement-based composites is the durability of the natural fibers. The present study evaluates the effect of activated coal mining residues on the physical-mechanical properties of fiber cement composites reinforced by thermally treated eucalyptus pulp, before and after accelerated aging. The results showed that the partial substitution of cement by activated coal mining residues and the use of thermally treated fibers contribute to the improvement of the mechanical properties of the composites. Indeed, an increase of the values of the modulus of rupture (MOR) and the specific energy (SE) of the composites is observed under four-point bending flexural tests. Moreover, after accelerated aging tests, both fiber treatment and matrix modification contribute to mitigate the degradation of the fibers and increase the mechanical properties of the composites. According to the results of the study, the use of activated coal mining residues as partial substitution of cement and hornification treatment of the pulp, can lead to the improvement of the mechanical performanceand durability of fiber cement composites., The authors were supported by grants offered by Susano PapelCelulose S.A., Brazil. The authors are also grateful to Coordination of Improvement of Higher Education Personnel – CAPES (Cod. 001) and the Framework Partnering Agreement between IETcc/CSIC (Spain) and FZEA/USP (Brazil) (BDC 20195707/ACAM 2019040029). This research was funded by the Spanish Ministry of Economy and Competitiveness (BIA2015-65558-C3-1-2-3R) (MINECO/FEDER)) and the National Research Council’s I–COOP Programme (ref: COOPA20089- 2015).