Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 3
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

Defining magnetic properties required for rare earth element free permanent magnets for electric vehicles.

  • Eriksson, S.
  • Silva, M.D.
  • Eklund, P.
The use of novel permanent magnets in motors is evaluated by finding the lower limits for magnetic properties, through optimization considering torque density and permanent demagnetization. An electrical machine optimization methodology is combined with a new design paradigm of accepting some degree of permanent demagnetization to achieve higher performance. Different number of poles is compared and a sensitivity study regarding allowed demagnetization is performed. Results show an expected increase in torque when the remanence is increasing. However, for low intrinsic coercivity, the torque decreases substantially as the magnet is not optimally shaped. The results demonstrate that magnets with a remanence as low as 0.6 T can be used in a competitive electric car motor with a torque density comparable to conventional motors. It can also be concluded that the knee point of the demagnetization curve should be in the third quadrant to utilize the magnets properly. In addition, from a demagnetization point of view, a high remanence can be negative for a magnet with low intrinsic coercivity. Experimental results from an electric vehicle motor with commercially available ferrite magnets are presented, both to demonstrate the use of ferrites in electric motors and to experimentally verify the finite element method simulations. © The Institution of Engineering & Technology 2025., BEETHOVEN has received funding from the European Union's Horizon Europe programme under grant agreement 101129912. Views and opinions are however those of the authors and do not necessarily reflect those of the European Union or the European Health and Digital Executive Agency (HADEA). Neither the European Union nor the granting authority can be held responsible for them., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

Structural and magnetic properties of Fe11Mn2Ga3: an off-stoichiometric Heusler alloy

  • Morales, Oswaldo
  • Plazaola, Fernando
  • Marco, J.F.
  • Peña, Víctor A.
  • Rojo, Víctor
  • Prieto, J. E.
  • de la Figuera, Juan
  • Dávalos, J.Z.
16 pages, 9 figures, 1 table . -- Conference Proceedings, This work investigates the structural and magnetic properties of the off-stoichiometric Heusler alloy Fe₁₁Mn₂Ga₃. X-ray diffraction confirms a face-centered cubic L2₁ structure with significant chemical disorder. Magnetic characterization reveals a complex phase diagram with two distinct transitions: a Curie temperature at T<inf>m2</inf> =309 K and a magnetic reorientation at T<inf>m1</inf> =167 K, below which antiferromagnetic interactions dominate, evidenced by a reentrant decrease in magnetization. This behavior yields a bifunctional magnetocaloric response, with a direct effect near T<inf>m1</inf> and an inverse effect near T<inf>m2</inf>. Mössbauer spectroscopy confirms a ferrimagnetic state at room temperature and provides microscopic evidence for the development of non-collinear magnetism at low temperatures. The novelty of these results lies in the consequences of the strong Fe-rich off-stoichiometry, which stabilizes chemical disorder and shifts the balance beteween competing ferromagnetic and antiferromagnetic interactions to unusually high temperatures. The results demonstrate that strategic off-stoichiometry is a powerful tool for stabilizing disordered states and engineering novel magnetic functionality in Heusler alloys., This work is supported by grants PID2022-138108OB-C33, PID2021-124585NB-C31 funded by MCIN/AEI/https://doi.org/10.13039/501100011033 and “ERDF A way of making Europe”; the Basque Government under grant IT-1500-22; the “Comunidad de Madrid” funded TEC-2024/TEC-380 program under grant Mag4TIC-CM and by the BEETHOVEN project funded by the European Commission under grant agreement 101129912. Views and opinions expressed are however those of the author(s) only and do not necessarily reflect those of the European Union or the European Education and Culture Executive Agency (EACEA). Neither the European Union nor EACEA or the granting authorities can be held responsible for them. In addition, O.M. thanks Dr. E.M.B. Saitovitch (CNRB-R.J.-Brazil) for the opportunity to research with her group. Open Access funding provided thanks to the CRUE-CSIC agreement with Springer Nature., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

Inspection of steel elements using electromagnetic induction: A finite elements study

  • García García-Tuñón, Miguel Ángel
This study presents a finite element method (FEM) analysis aimed at detecting inhomogeneities in steel components using electromagnetic induction techniques. The results obtained are consistent with previous experimental studies and analytical models, while also providing significant complementary insights. Notably, the application of FEM enables detailed mapping of the electromagnetic field distributions involved in the induction process, even in complex geometries, an advantage not afforded by conventional analytical models. The findings demonstrate the method's capability to detect stress levels well below the material's elastic limit, as well as the presence of microcracks. This early detection capability is crucial for preventing mechanical failure in the analyzed components. © 2025 IEEE., This work has been funded by the Spanish Ministry of Science and Innovation via Project No. PID2023-153398OB-I00 and BEETHOVEN project funded by the European Comission under grant agreement 101129912. Views and opinions expressed are however those of the author(s) only and do not necessarily reflect those of the European Union or the European Education and Culture Executive Agency (EACEA). Neither the European Union nor EACEA can be held responsible for them., Peer reviewed