DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación
Contribución de congreso (ConferenceOutput)
Structural and magnetic properties of L10 FePt/{MgO, W, or Pt }/L10 FePt trilayers
Trabajo presentado en el XXXII Panhellenic Conference on Solid State Physics and Materials Science, celebrado en Ioannina (Grecia), del 18 al 21 de septiembre de 2016, Nowadays there is an urgent need for enhancing data storage capacity of hard disk drives due to
the rapid increase of digital data volume produced worldwide. New effective approaches are required to push
the recording areal density beyond the limit of 1 Tbit/in2 of state-of-art hard disk drives. A promising
alternative is 3D-magnetic recording, where stacking magnetic layers with different magnetic properties are
used [1].
In this work we report on the morpho-structural and magnetic properties of FePt/interlayer (MgO, Pt or W)
/FePt magnetron sputtered trilayers, as a base structure towards 3D magnetic recording systems. The stack
is grown on an MgO (100) substrate and consists of two magnetically hard FePt layers with a thickness of 20
and 10 nm separated by an interlayer of variable thickness (5 up to 50 nm). Fig 1a summarizes the coercivity
for all MgO, W or Pt interlayer samples; the layers seem to be coupled even at 20 nm of MgO or W interlayer
thickness. However, at 5 nm interlayer thickness, hysteresis loops for W or MgO interlayers are those of a
film stack of partially coupled ferromagnetic layers( Figure 1b), whereas a fully decoupled magnetic trilayer is
obtained for a Pt interlayer, in agreement to previous reports [2] and also supported by magnetic force
microscopy imaging. Finally, electron diffraction patterns and dark field images analysis indicate that most of
FePt grains grow in the L10 phase with the (001) planes parallel to the substrate and the MgO interlayer
grows oriented as the substrate., Funding from the E.C. is acknowledged (Grant No. 318144 and 280670) & MINECO (MAT2014-59772-C2-1-P), Peer reviewed