Pasar al contenido principal

DESARROLLO Y APLICACION DE ENSAYOS NO DESTRUCTIVOS BASADOS EN ONDAS MECANICAS PARA LA EVALUACION Y MONITORIZACION DE REOLOGIA Y AUTOSANACION EN MATERIALES CEMENTANTES

BIA2017-87573-C2-2-P

•
Nombre agencia financiadora Agencia Estatal de Investigación
Acrónimo agencia financiadora AEI
Programa Programa Estatal de Fomento de la Investigación Científica y Técnica de Excelencia
Subprograma Subprograma Estatal de Generación de Conocimiento
Convocatoria Proyectos de I+D (Excelencia / Generación de Conocimiento)
Año convocatoria 2017
Plan Estatal 2017-2020 Plan Estatal de Investigación Científica y Técnica y de Innovación
Centro beneficiario UNIVERSITAT POLITÈCNICA DE VALÈNCIA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Contribución de congreso (ConferenceOutput)

Airborne ultrasounds for damaged cementitious characterization

  • Gosálbez Castillo, Jorge|||0000-0001-6520-9014
  • CARRIÓN GARCÍA, ALICIA|||0000-0002-0630-6065
  • Paya Bernabeu, Jorge Juan|||0000-0001-7425-5311
  • Gallardo, C.
  • Vázquez, S.
  • Genovés, V.
[EN] The scope of this paper is to demonstrate the capability of airborne non-contact ultrasound (ANC-US) to assess thermal damage on normalized Portland cement mortar specimens. For this purpose, contact ultrasound (C-US) and ANC-US are compared. A normalized dosage mortar was carried out to obtain standardized mortar specimens of 4 x 4 x 16 cm. Then, they were measured by ANC-US and C-US. Afterwards, they were thermal damaged (400º C) and measured again. Ultrasound velocity and frequency attenuation were estimated. As expected, damaged samples show lower velocities and higher attenuations than sound samples. It is remarkable how the attenuation keeps constant for frequencies below 100 kHz and increases due to the sensitivity of higher frequencies to the size of thermal microcracking. Although ANC-US does not require any coupling media as C-US does, it requires additional calibration to compensate propagation through the air and material boundaries. Considering these terms, both techniques offer consistent results and the capability of ANC-US technique for damage characterization in cementitious systems is proved., The authors acknowledge the support from T. Gomez Álvarez-Arenas (Institute for Physical and Information Technologies ITEFI-CSIC) and Spanish Administration under grant BIA2017- 87573.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Contribución de congreso (ConferenceOutput)

Airborne ultrasonic technique to measure leaky Lamb waves with narrowband and low-frequency excitation

  • Vázquez, S.
  • Wright, W. M. D.
  • Gallardo, C.
  • Gosálbez Castillo, Jorge|||0000-0001-6520-9014
  • Bosch Roig, Ignacio|||0000-0003-3190-3635
  • CARRIÓN GARCÍA, ALICIA|||0000-0002-0630-6065
Air-coupled non-destructive testing has become very valuable because eliminates the use of liquid couplants and enables a contactless fast inspection of structures. Multimodal leaky Lamb waves can be excited and sensed with this technology in plate-like specimens varying the excitation frequency and the inclination of the transducers. To reduce undesired effects, as the existence of unwanted modes, narrowband and low-frequency excitation signals can be used. In this paper, the generation and detection of ultrasonic leaky Lamb waves in a metallic plate with capacitive air-coupled transducers have been performed. Theoretical and experimental data have been matched, showing good correlation., The authors acknowledge the support from University College Cork (Ireland), Universitat Politècnica de València and the Spanish Administration under grants BIA2017-87573 and Salvador Madariaga's Programme (PR2017-00658).