Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Contribución de congreso (ConferenceOutput)

Single-stage class-AB non-linear current mirror OTA

  • Beloso Legarra, Javier
  • Cruz Blas, Carlos Aristóteles de la
  • López Martín, Antonio
The analysis, design and experimental characterization of a single-stage class-AB operational transconductance amplifier (OTA) with enhanced large- and small-signal performance is presented. The OTA is biased in weak inversion to save power and employs a non-linear current mirror as active load, leading a boosting current directly at the output branch. As a result, the amplifier's performance is improved without additional circuit elements and/or power consumption. A chip prototype has been fabricated in a 180-nm CMOS process, consuming a quiescent power of 2.5 µW from a supply voltage of ±0.5 V and a silicon area of 0.0013 mm 2 . For a load of 160 pF, it exhibits an average slew rate of 0.94 V/µs and a gain-bandwidth product of 22.1 kHz., This work has been supported by Grant PID2019-107258RB-C32 funded by MCIN/AEI/10.13039/501100011033.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Contribución de congreso (ConferenceOutput)

Low-voltage CMOS bulk-driven buffer with bootstrapping technique for gain enhancement and THD-noise reduction

  • Cruz Blas, Carlos Aristóteles de la
  • Carrillo, Juan M.
In this paper, a bootstrapping technique is applied to a bulk-driven voltage buffer for canceling the gate-source transconductance in order to improve the cell gain, the linearity and reduce the input-referred noise. The bootstrapped circuitry is conveniently implemented by only using a capacitor and a pseudo resistor. The suitability of the technique is demonstrated by simulation results using a flipped voltage follower, even though it is general and can be applied to other structures. A 1-V buffer is designed in 0.18 µm CMOS technology, showing a 4.3 times improvement in the voltage gain (conventional 0.21 V/V, bootstrapped 0.90 V/V), increasing 5 times the input voltage range for a 1% THD (conventional 50 mV, bootstrapped 250 mV) and reducing the input equivalent noise around a 16% (conventional 180 nV/-√Hz, bootstrapped 155 nV/√Hz at 10 kHz)., This work has been funded by projects RTI2018-095994-B-I00 and PID2019-107258RB-C32 from MCIN/AEI/10.13039/501100011033, and by Fondo Europeo de Desarrollo Regional (FEDER).