Pasar al contenido principal

EVALUACION DE LA CAPACIDAD RESISTENTE FRENTE A ESFUERZOS TANGENTES DE ESTRUCTURAS DE HORMIGON MEDIANTE MODELOS MECANICOS PARA LA EXTENSION DE SU VIDA UTIL

BIA2015-64672-C4-1-R

•
Nombre agencia financiadora Ministerio de Economía y Competitividad
Acrónimo agencia financiadora MINECO
Programa Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Convocatoria Proyectos I+D+i Retos de Investigación
Año convocatoria 2015
Plan Estatal 2013-2016 Plan Estatal de Investigación Científica y Técnica y de Innovación
Unidad de gestión Dirección General de Investigación Científica y Técnica
Centro beneficiario UNIVERSITAT POLITECNICA DE CATALUNYA
Identificador persistente http://dx.doi.org/10.13039/501100003329

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Application of the Compression Chord Capacity Model to predict the fatigue shear strength of reinforced concrete members without stirrups

  • Cladera, Antoni
  • Ribas, Carlos
  • Oller, Eva
  • Marí, Antonio
The Compression Chord Capacity Model (CCCM), previously developed by the authors with other colleagues, is a simplified model for the shear strength prediction of reinforced and prestressed concrete members with and without transverse reinforcement, with I, T or rectangular cross-section, which represents a useful tool for structural design and assessment in engineering practice. The principal advantage of the application of a mechanical model is the possibility to extend it to different cases, without the need of empirical calibrations. According to the CCCM, the shear strength depends on the concrete tensile strength. In this communication, the CCCM is extended to assess the fatigue shear strength of RC members just incorporating the equation proposed in Model Code 2010 for the concrete tensile fatigue strength. A good performance of the model was observed when analysing the ratio Vtest/Vpred through a previously published database, showing a low scatter (COV 14.7 %).
RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Effects of tensile stresses on punching shear strength of RC slabs

  • Fernández, Pablo G.
  • Marí, Antonio
  • Oller, Eva
  • Domingo, Magí
RC slabs can be subjected to transverse loads and tensile in-plane forces, as it occurs in top slabs of continuous bridges under negative moments. Tensile forces can reduce the shear or punching capacity of the slab, aspect not yet studied. A theoretical and experimental investigation has been carried out, in which 10 slabs have been tested under a point load and different degrees of tensile force. The results of five axisymmetrically supported slabs of 1.65x1.65x0.12m are presented. Numerical predictions were made with FEA software ABAQUS and, in addition, the Compression Chord Capacity Mechanical Model CCCM, was extended to account for the effect of in-plane tensile forces. The experimental results showed that the ultimate punching load diminished linearly with the applied tensile force applied and that, after yielding of longitudinal reinforcement such reduction was higher.