Pasar al contenido principal

NUEVOS MATERIALES Y PROCESOS PARA EL ALMACENAMIENTO, PURIFICACION Y DETECCION DE HIDROGENO

CTQ2009-10813

•
Nombre agencia financiadora Ministerio de Ciencia e Innovación
Acrónimo agencia financiadora MICINN
Programa Programa Nacional de Proyectos de Investigación Fundamental
Subprograma Subprograma de Proyectos de Investigación Fundamental no Orientada
Convocatoria Proyectos I+D
Año convocatoria 2009
Plan Estatal 2008-2011 Plan Nacional de Investigación Científica, Desarrollo e Innovación Tecnológica
Unidad de gestión Subdirección General de Proyectos de Investigación
Centro beneficiario UNIVERSIDAD DE ALICANTE
Identificador persistente http://dx.doi.org/10.13039/501100004837

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Spherical activated carbons for low concentration toluene adsorption

  • Romero Anaya, Aroldo José
  • Lillo-Rodenas, Maria Angeles
  • Linares-Solano, Angel
  • Lillo-Rodenas, Maria Angeles|||/items/d56418ee-38bb-491e-a494-7f14757d264f
The activation process of a spherical activated carbon (SAC) from Kureha Carbon was analysed and the behaviour of these materials to adsorb low concentration volatile organic compounds was studied. Two series of activated carbons were prepared using CO2 or steam as activating atmospheres at 880 and 840 °C, respectively. Activation times between 45 min and 24 h were selected, leading to burn-offs between 21 and 60%. The results show, for similar burn-off percentages, that the porosity development is similar for the two activating gases at moderate burn-off percentages, and larger for CO2 than for steam at high burn-off percentages. For similar burn-offs, steam leads to SACs with slightly larger bed densities than CO2. In general, a low and similar increase in the total surface oxygen groups’ content is noted after activation with both activating agents. Toluene adsorption capacities as large as 46 g toluene/100 g SAC can be achieved with some of these spherical activated carbons in a continuous flow-through SAC bed, when influent air-phase toluene was 200 ppmv. Considering that these SACs have quite high bed densities, their toluene adsorption capacities per unit of volume reach remarkably high values.
RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Comparison among Chemical, Thermal, and Electrochemical Regeneration of Phenol-Saturated Activated Carbon

  • Berenguer Betrián, Raúl
  • Marco Lozar, Juan Pablo
  • Quijada Tomás, César
  • Cazorla-Amorós, Diego
  • Morallon, Emilia
  • Berenguer Betrián, Raúl|||/items/660b8462-63ec-4910-98e0-ac425e6bd7a6
  • Cazorla-Amorós, Diego|||/items/bab354fe-ec79-49e0-a4f3-5288ee396750
  • Morallon, Emilia|||/items/a15cf511-9365-4c40-afcb-ea29d4418244
The regeneration of phenol-saturated activated carbon (AC) by chemical, thermal, and electrochemical techniques has been studied and compared in this work. The influence of the solute (NaOH) concentration and the temperature on the conventional chemical and thermal regenerations, respectively, has been analyzed and compared to the optimal results achieved for the electrochemical method. Comparisons are based on the analysis of the remaining products after regeneration, the regeneration efficiency (RE), and the recovery of the textural properties of a commercial phenol-saturated granular AC. Results show that very low-porosity recoveries are achieved by chemical regeneration, independent of the NaOH concentration, and the optimal REs are 20% lower than those obtained by the thermal and electrochemical ones. REs obtained by thermal treatment in an inert atmosphere increase with the temperature up to 750 °C, reaching the highest REs (80−86%) and porosity recoveries at T > 600 °C. The cathodic regeneration in the NaOH medium in an undivided cell, where phenolate desorption is favored and surface blockage is minimized, yields similar RE values (80−85%) and slightly higher porosity than those obtained by thermal treatment. Temperature-programmed desorption (TPD) experiments show that, whereas phenol is almost completely removed electrochemically after 3 h, a temperature of at least 450−600 °C is required to achieve similar results by thermal regeneration.