Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 3
Encontrada(s) 1 página(s)

RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Origin of the Deactivation of Spinel CuxCo3−xO4/Ti Anodes Prepared by Thermal Decomposition

  • Berenguer Betrián, Raúl
  • La Rosa-Toro, Adolfo
  • Quijada Tomás, César
  • Morallon, Emilia
  • Berenguer Betrián, Raúl|||/items/660b8462-63ec-4910-98e0-ac425e6bd7a6
  • Morallon, Emilia|||/items/a15cf511-9365-4c40-afcb-ea29d4418244
Thin films of spinel CuxCo3−xO4 with nominal composition 0.0 ≤ x ≤ 1.0 were supported on Ti by the thermal decomposition method. The resulting electrodes were deactivated by prolonged anodic polarization in 1 M NaOH. The ensuing changes in the surface morphology, chemical composition, and crystalline properties were studied by means of scanning electron microscopy, energy dispersive X-ray microanalysis, X-ray diffraction, and X-ray photoelectron spectroscopy. The electrochemical response was inspected by cyclic voltammetry. Surface imaging shows grain sharpening and extensive loss of the oxide coating, which becomes more marked with the increasing proportion of lattice Cu2+ ions. Diffraction patterns show the rise in the relative intensity of the underlying Ti reflections and the loss of the cobalt spinel diffraction peaks. Lattice Cu2+ ions dissolve preferentially and are virtually absent in deactivated mixed oxide anodes. Photoelectron spectroscopy indicates the presence of a highly hydrated Co(II)-containing surface layer. The reduction of the spinel oxide surface layer into an inactive hydrated CoO or a Co(OH)2 layer after oxidative electrolysis is discussed.
RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Comparison among Chemical, Thermal, and Electrochemical Regeneration of Phenol-Saturated Activated Carbon

  • Berenguer Betrián, Raúl
  • Marco Lozar, Juan Pablo
  • Quijada Tomás, César
  • Cazorla-Amorós, Diego
  • Morallon, Emilia
  • Berenguer Betrián, Raúl|||/items/660b8462-63ec-4910-98e0-ac425e6bd7a6
  • Cazorla-Amorós, Diego|||/items/bab354fe-ec79-49e0-a4f3-5288ee396750
  • Morallon, Emilia|||/items/a15cf511-9365-4c40-afcb-ea29d4418244
The regeneration of phenol-saturated activated carbon (AC) by chemical, thermal, and electrochemical techniques has been studied and compared in this work. The influence of the solute (NaOH) concentration and the temperature on the conventional chemical and thermal regenerations, respectively, has been analyzed and compared to the optimal results achieved for the electrochemical method. Comparisons are based on the analysis of the remaining products after regeneration, the regeneration efficiency (RE), and the recovery of the textural properties of a commercial phenol-saturated granular AC. Results show that very low-porosity recoveries are achieved by chemical regeneration, independent of the NaOH concentration, and the optimal REs are 20% lower than those obtained by the thermal and electrochemical ones. REs obtained by thermal treatment in an inert atmosphere increase with the temperature up to 750 °C, reaching the highest REs (80−86%) and porosity recoveries at T > 600 °C. The cathodic regeneration in the NaOH medium in an undivided cell, where phenolate desorption is favored and surface blockage is minimized, yields similar RE values (80−85%) and slightly higher porosity than those obtained by thermal treatment. Temperature-programmed desorption (TPD) experiments show that, whereas phenol is almost completely removed electrochemically after 3 h, a temperature of at least 450−600 °C is required to achieve similar results by thermal regeneration.
RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Electrochemical regeneration and porosity recovery of phenol-saturated granular activated carbon in an alkaline medium

  • Berenguer Betrián, Raúl
  • Marco Lozar, Juan Pablo
  • Quijada Tomás, César
  • Cazorla-Amorós, Diego
  • Morallon, Emilia
  • Berenguer Betrián, Raúl|||/items/660b8462-63ec-4910-98e0-ac425e6bd7a6
  • Cazorla-Amorós, Diego|||/items/bab354fe-ec79-49e0-a4f3-5288ee396750
  • Morallon, Emilia|||/items/a15cf511-9365-4c40-afcb-ea29d4418244
The electrochemical regeneration of phenol-saturated activated carbon has been carried out in a filter-press electrochemical cell. The feasibility of the electrochemical regeneration has been assessed by monitoring the regeneration efficiency and the textural properties of a phenol-saturated granular activated carbon (GAC) electrolysed in NaOH medium. The influence of the following factors: (i) the electrolysis treatment (either anodic or cathodic); (ii) the separation of compartments; (iii) applied current and (iv) electrolysis time has been studied. Basing on the obtained results, an overall phenomenological mechanism for the electrochemical regeneration has been proposed. The general worse performance of anodic regenerations can be attributed to an important surface blockage of the GAC by reaction products such as quinones, phenolic oligomers and polymers coming from phenol electrooxidation. The cathodic regeneration in NaOH medium, where phenolate desorption is favoured, and in an undivided configuration, where surface blockage is minimized, produces a significant recovery of the porosity of the original GAC, in agreement with the highest RE values (close to 80%).