Pasar al contenido principal

PROPIEDADES AVANZADAS EN MATERIALES FOTONICOS Y ELECTROCERAMICOS BASADOS EN PIROCLOROS

PID2020-116149GB-I00

•
Nombre agencia financiadora Agencia Estatal de Investigación
Acrónimo agencia financiadora AEI
Programa Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Convocatoria Proyectos de I+D+i (Generación de Conocimiento y Retos Investigación)
Año convocatoria 2020
Plan Estatal 2017-2020 Plan Estatal de Investigación Científica y Técnica y de Innovación
Centro beneficiario UNIVERSITAT JAUME I DE CASTELLO

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Non-Stoichiometric BaxMn0.7Cu0.3O3 Perovskites as Catalysts for CO Oxidation: Optimizing the Ba Content

  • Díaz Verde, Álvaro
  • Veiga, Emerson Luiz dos Santos
  • Beltrán-Mir, Héctor
  • Illán-Gómez, María José
  • Cordoncillo, Eloísa
  • Díaz Verde, Álvaro|||/items/cd6c7340-fb5a-431d-be4e-8bde8df84857
  • Illán-Gómez, María José|||/items/c60edb64-b18b-4119-bf4b-4dae3cc71c22
In this work, a series of BaxMn0.7Cu0.3O3 samples (x: 1, 0.9, 0.8, and 0.7, BxMC) was synthesized, characterized, and used as catalysts for CO oxidation reaction. All formulations were active for CO oxidation in the tested conditions. A correlation between the electrical conductivity, obtained by impedance spectroscopy, and the reducibility of the samples, obtained by H2-TPR, was observed. The Ba0.8Mn0.7Cu0.3O3 composition (B0.8MC) showed the best catalytic performance (comparable to that of the 1% Pt/Al2O3 reference sample) during tests conducted under conditions similar to those found in the exhaust gases of current gasoline engines. The characterization data suggest the simultaneous presence of a high Mn(IV)/Mn(III) surface ratio, oxygen vacancies, and reduced copper species, these two latter being key properties for ensuring a high CO conversion percentage as both are active sites for CO oxidation. The reaction temperature and the reactant atmosphere composition seem to be the most important factors for achieving a good catalytic performance, as they strongly determine the location and stability of the reduced copper species.
RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Evaluation of Pr2Zr2-xCexO7±δ pyrochlores as a potential Cu support catalysts for CO oxidation in simulated GDI conditions

  • Veiga, Emerson Luiz dos Santos
  • Díaz Verde, Álvaro
  • Illán-Gómez, María José
  • Beltrán-Mir, Héctor
  • Cordoncillo, Eloísa
  • Díaz Verde, Álvaro|||/items/cd6c7340-fb5a-431d-be4e-8bde8df84857
  • Illán-Gómez, María José|||/items/c60edb64-b18b-4119-bf4b-4dae3cc71c22
This study evaluates the catalytic activity, both as bulk catalysts and as supports for copper catalysts for CO oxidation in a simulated Gasoline Direct Injection Engine (GDI) of two pyrochlores: Pr2Zr2O7 (PZ) and Pr2Zr1.9Ce0.1O7±δ (PZC). These pyrochlores were synthesized by the solvothermal method. XRD, FE-SEM, HR-TEM, XPS, H2-TPR, and O2-TPD characterization techniques were employed to determine the structural, microstructural, and redox properties of the samples. All materials exhibited high catalytic activity for CO oxidation, with Cu-PZC showing the best performance, which is comparable to that of a 1% Pt/Al2O3 commercial catalyst used as a reference. Thus, the synthesized solids could be a promising and cost-effective alternative to noble metal-based catalysts used to control GDI exhaust gas composition.