Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Tesis doctoral (DoctoralThesis)

Elaboration et caractérisation de couches minces de cuivre, indium, gallium et sélénium (CIGS) pour cellules solaires

  • Armel Ignace, N'Guessan
[ES] Este proyecto de investigación se centra en el campo de las energías renovables y más concretamente de la energía solar fotovoltaica. La tesis se ha focalizado en el desarrollo de películas delgadas de Cobre-Indio-GalioSelenio o Sulfuro (CuIn1-xGax(Se,S)2) con técnicas de bajo coste. La mayoría de las celdas basadas en CIGS utilizan el CdS como capa de búfer. En nuestro experimento, usaremos otra capa de tampón como SnS2 o ZnO1-xSx como alternativa a CdS para mejorar nuestra célula. El estudio se centrará en el contacto tampón/absorbedor para reducir la recombinación. En este trabajo, reportamos la investigación experimental del desarrollo y desarrollo de la caracterización de la calcopirita de cobre, indio, galio y selenio (CIGS) por la técnica de electrodeposición y pulverización. Además, nos hemos centrado en el contacto entre la capa generadora que es el absorbedor y el circuito externo. Las propiedades eléctricas de este contacto dependen principalmente del proceso de deposición de la capa absorbente en el contacto trasero utilizado. Por lo tanto, será necesario controlar el crecimiento de la capa interfacial de MoSe2 entre el absorbedor y el contacto posterior en el caso del molibdeno para obtener un rendimiento óptimo. Por supuesto, la eficiencia de la célula depende de un gran número de parámetros experimentales y varía según los métodos de fabricación, especialmente la capa absorbente CIGS. En nuestro caso, las técnicas utilizadas son la galvanoplastia y la pirólisis por pulverización para la deposición de películas CIGS. Estas técnicas son más baratas, prácticamente alcanzables en cualquier laboratorio y dan un buen rendimiento. Por lo tanto, mediante técnicas de deposición de bajo coste hemos estudiado el comportamiento de la célula solar con una capa de MoSe2 como capa interfacial y el efecto de la banda prohibida de la capa formada y la capa tampón utilizada sobre los parámetros de las células solares CIGS. Los resultados de este estudio podrían ayudar a mejorar el rendimiento de las células solares CIGS utilizando técnicas de bajo coste., [CA] Aquest projecte de recerca es centra en el camp de les energies renovables i més concretament en l'energia solar fotovoltaica. La tesi s'ha centrat en el desenvolupament de pel·lícules primes de Coure-Indi-Gali-Seleni o Sulfur (CuIn1-xGax(Se,S)2) amb tècniques de baix cost. La majoria de les cel·les basades en CIGS utilitzen el CdS com a capa de búfer. En el nostre experiment, farem servir una altra capa de tampó com ara SnS2 o ZnO1-xSx com a alternativa al CdS per millorar la nostra cel·la. L'estudi es centrarà en el contacte tampó/absorbidor per reduir la recombinació. En aquest treball, reportem la recerca experimental del desenvolupament i la caracterització de la calcopirita de coure, indi, gali i seleni (CIGS) mitjançant la tècnica d'electrodeposició i pulverització. A més, ens hem centrat en el contacte entre la capa generadora que és l'absorbidor i el circuit extern. Les propietats elèctriques d'aquest contacte depenen principalment del procés de deposició de la capa absorbent en el contacte posterior utilitzat. Per tant, serà necessari controlar el creixement de la capa interfacial de MoSe2 entre l'absorbidor i el contacte posterior en el cas del molibdè per obtenir un rendiment òptim. És clar que l'eficiència de la cel·la depèn d'un gran nombre de paràmetres experimentals i varia segons els mètodes de fabricació, especialment la capa absorbent CIGS. En el nostre cas, les tècniques utilitzades són la galvanoplàstia i la piròlisi per pulverització per a la deposició de pel·lícules CIGS. Aquestes tècniques són més econòmiques, pràcticament assolibles en qualsevol laboratori i proporcionen un bon rendiment. Per tant, mitjançant tècniques de deposició de baix cost hem estudiat el comportament de la cel·la solar amb una capa de MoSe2 com a capa interfacial i l'efecte de la banda prohibida de la capa formada i la capa tampó utilitzada sobre els paràmetres de les cel·les solars CIGS. Els resultats d'aquest estudi podrien ajudar a millorar el rendiment de les cel·les solars CIGS utilitzant tècniques de baix cost., [EN] Our research project aims at the field of renewable energies and more specifically, photovoltaic solar energy, i.e. solar cells, our study focuses on the elaboration of Copper-Indium-Gallium-Selenium or Sulfide (CuIn1-xGax(Se,S)2 thin films for solar cells with low-cost techniques also to develop the performance of the typical solar cell structure: n-ZnO/i-ZnO/n-tampon/p-CIGS/p+-MoSe2/back contact. Most of the CIGS based cells use CdS as a buffer layer. In our experiment, we will make use of another buffer layer such as SnS2 or ZnO1-xSx as an alternative to CdS to improve our cell. The investigation will be carried out on the buffer/absorber contact to reduce recombination. In addition, we will focus on the contact between the generating layer which is the absorber and the external circuit. The electrical properties of this contact depend essentially on the deposition process of the absorber layer on the back contact used. It will thus be necessary to control the growth of the MoSe2 interfacial layer between the absorber and the back contact in the case of Molybdenum in order to obtain an optimal yield. Obviously, the yield of the cell depends on a large number of experimental parameters and varies according to the fabrication methods, especially of the CIGS absorber layer. In our case the techniques used are electrodeposition and spray pyrolysis for the deposition of CIGS films, there techniques are cheaper, practically feasible in the laboratory and give good performance. Therefore, we will investigate, using low-cost deposition techniques, the performance of the cell with a MoSe2 layer as an interfacial layer and the effect of the bandgap of the formed layer and the buffer layer used on the parameters of the CIGS solar cells. The results of this study could help to improve the performance of the CIGS solar cell using low-cost techniques.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Tesis doctoral (DoctoralThesis)

Use of nitrate as a metabolic modulator in ammonium-fed leafy vegetable production

  • Calleja Satrustegui, Aitziber
Global agriculture's dependence on nitrogen-based fertilizers and high soil nitrification rates causes excessive nitrate accumulation in soil and plants, leading to environmental and health problems. Nitrate accumulation in plans is especially notable in nitratepreferring leafy vegetables, frequently exceeding European Union (EU) food safety limits. Ammonium-based fertilization is a promising alternative to lower nitrate content in edible tissues. However, ammonium as the sole nitrogen source is toxic to most crops, particularly to nitrate-preferring species like spinach (Spinacia oleracea L.) and other leafy vegetables. This toxicity, among other, is linked to disruptions in central carbon metabolism, promoting the synthesis of methylglyoxal (MG), a toxic compound. It is known that millimolar levels of nitrate can alleviate ammonium toxicity. However, the mechanisms by which alleviation also could occur at non-nutritive doses (i.e., micromolar range) remain poorly explored. Furthermore, the specific function of micromolar nitrate in regulating ammonium-induced carbon overflow in primary metabolism is not yet fully elucidated. This thesis hypothesized that the co-supply of small, micromolar concentrations of nitrate could alleviate ammonium toxicity while maintaining the Benefit of low nitrate content in edible tissues. We further proposed that this alleviation is driven by a specific regulatory action on carbon metabolism, likely mediated by nitric oxide (NO) derivatives (like GSNO) through redox-based post-translational modifications (PTMs), preventing MG synthesis. The general aim of this thesis was to bridge the gap between fundamental knowledge of the nitrate-ammonium interaction and its practical application in agriculture. We sought to gain mechanistic insights into how nitrate regulates carbon metabolism to inform the formulation of improved, ammonium-dominant nutrient solutions for the comercial production of leafy vegetables with reduced nitrate content. Our findings confirm that at micromolar concentrations, nitrate is rapidly translocated to the leaves where it exerts a regulatory function. This micromolar supply triggers a reorganization of carbon flow, effectively redirect carbon to different metabolic pathways, avoiding the spontaneous synthesis of toxic MG. A key target of this regulatory action was identified as the photosynthetic enzyme ABtype glyceraldehyde-3-phosphate dehydrogenase (AB-GAPDH), a crucial component of central carbon metabolism. Our data established that this regulatory mechanism is posttranslational, as no changes in AB-GAPDH transcript or protein abundance were detected. Instead, the enzyme’s activity is modulated through redox-dependent PTMs. Consistent with our initial hypothesis, we observed that the levels of GSNO were significantly higher in ammonium-fed plants supplemented with micromolar nitrate compared to those without, strongly suggesting that S-nitrosation is the likely (though yet to be definitively confirmed) mechanism of this redox-based regulation. While the micromolar nitrate supply provided an important mechanistic insight, we found it was insufficient to sustain agronomically acceptable yields in advanced-stage leafy vegetables on its own. This demonstrated that a higher, albeit still minimized, nitrate content is required for practical cultivation. We therefore explored different nitrate-to-ammonium ratios to balance yield, stress tolerance, and nitrate accumulation. For some leafy vegetables like rocket (Eruca sativa Mill.) and borage (Borago officinalis L.), a 3.33:6.66 (mM) nitrate-to-ammonium ratio emerged as the optimal solution. For the highly ammonium-sensitive spinach, however, none of the tested ratios simultaneously achieved the dual objective of lowering nitrate accumulation while maintaining acceptable yields. This emphasises the importance of tailoring fertilisation strategies to the specific physiology of each crop. This thesis provides a novel knowledge on nitrate’s function as a post-translational regulator of central carbon metabolism in the context of ammonium nutrition. This discovery opens new perspectives for applied agriculture. It provides a fundamental scientific basis for the formulation of ammonium-dominant fertilizers that incorporate low levels of nitrate not just as a nutrient, but as a critical regulator. This approach paves the way for the commercial production of leafy vegetables that are high-yield, high-quality and compliant with EU food safety standard for nitrate content., This thesis was funded by the following grants: NITROSYM. Re-evaluation of organic and inorganic nitrogen fertilizer application on symbiotic nitrogen fixation in legumes: sustainable agriculture and circular economy, funded by the Spanish Ministry of Science and Innovation, State Investigation Agency (AEI) and European Union NextGenerationEU/PRTR. Project reference: TED2021-130111B-I00. Project date: 01/12/2022-31/05/2025; BIOESTIMULAN. Design and study of the use of natural biostimulants of metabolic or microbial origin products to improve nitrogen use efficiency in plant species with agronomic interest, funded by the Government of Navarre. Project reference: PC108-019 BIOESTIMULAN. Project date: 01/12/2021-30/11/2024; MODULATransProt. Improved ammonium nutrition in leafy vegetables by modulation of ammonium transport proteins under nitrogen-sufficient conditions, funded by the Spanish Ministry of Science and Innovation. Project reference: PID2019-107463RJ-I00. Project date: 01/10/2020-30/09/2023; HORTA 0,0. Diseño y manejo de moduladores del metabolismo nitrogenado vegetal para la reducción del contenido de nitrato en hortalizas, funded by the Government of Navarre. Project reference: PC106-107 HORTA 0,0. Project date: 01/12/2019-30/11/2022; Aitziber Calleja Satrustegui was awarded a predoctoral grant funded by the Public University of Navarre (UPNA) and Santander Bank during the thesis performance. Grant resolution: 2659/2021. Grant date:15/01/2022-14/01/2026; The research stay at the University of Bolonia (UniBo, date: 01/09/2023-15/12/2023) was funded by European Union with Erasmus+ grant (grant resolution: 1212/2022) and the Public University of Navarre with a predoctoral mobility grant (grant resolution: 972/2023)., Programa de Doctorado en Agrobiología Ambiental (RD 99/2011), Ingurumen Agrobiologiako Doktoretza Programa (ED 99/2011)