Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Laboratory-Scale Assessment of CO2 Sealing Potential of Heterogeneous Caprock

  • Kim, Hyunbin
  • Vilarrasa, Víctor
  • Makhnenko, Roman Y.
Geologic carbon storage is widely recognized as a critical strategy for mitigating atmospheric carbon dioxide (CO2) levels, yet its effectiveness is contingent upon the integrity of caprock formations that prevent CO2 leakage. This study investigates the sealing potential of three representative caprock formations—Eau Claire Shale, Maquoketa Shale, and Opalinus Clay—by employing a comprehensive set of experimental approaches. Laboratory assessments include permeability tests, stepwise CO2 injection, imbibition experiments, and porosimetry-based estimation to evaluate the sealing potential of heterogeneous geomaterials. It appears that within each formation, sand-rich specimens exhibit significantly higher permeability and lower breakthrough pressures compared to their clay-rich counterparts, underscoring the influence of the lithological variation. An indirect method based on pore structure analysis tends to underestimate the sealing capacity, highlighting discrepancies caused by the confinement, pore structure anisotropy, and variations in geochemical interactions. A statistical analysis based on the data set from this study and the literature reveals that CO2 breakthrough pressure is positively correlated with the clay content, negatively correlated with the permeability and dominant pore size, and independent of its porosity. The sealing number is introduced to provide a quantitative framework for evaluating the sealing integrity of the tested caprock formations to withstand buoyant forces. This study highlights the critical role of heterogeneities in determining caprock sealing potential and emphasizes the importance of direct measurements, particularly the use of the stepwise method, for accurate assessment. Advanced imaging and geophysical monitoring, coupled with multi-scale experiments, are recommended to enhance the reliability of heterogeneous caprock integrity assessments., H.K. and R.M. acknowledge support from the U.S. National Science Foundation Faculty Early Career Development Program CMMI-2239630. The caprock cores are provided by the Illinois State Geological Survey and swisstopo. V.V. acknowledges funding from the European Union's Horizon Europe Research and Innovation Programme through the Doctoral Network of the Marie Sklodowska-Curie Actions SMILE (https://smile-msca-dn.eu/), under Grant 101073281. IMEDEA is an accredited “Maria de Maeztu Excellence Unit” (Grant CEX2021-001198, funded by MICIU/AEI/10.13039/501100011033)., With funding from the Spanish government through the "Maria de Maeztu Centre of Excellence" accreditation (CEX2021-001198)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Hydro-mechanical-chemical effects on flow properties of Opalinus Clay in CO2LPIE project

  • Kim, Hyunbin
  • Vilarrasa, Víctor
  • Makhnenko, Roman Y.
This study investigates the coupled hydro-mechanical-chemcial behavior and multiphase flow properties of Opalinus Clay – a potential caprock candidate for geologic carbon storage. A comprehensive series of laboratory tests is conducted to support the CO2 Long-term Periodic Injection Experiment (CO2LPIE) project at the Mont Terri Underground Rock Laboratory, providing essential parameters for caprock characterization. Facies-dependent poroviscoelastic and transport properties are quantified: the sandy facies exhibit higher drained and unjacketed bulk moduli and permeability than the shaly facies, yet both facies display favorable long-term sealing potential with intrinsic permeability on the order of ∼10−20 m2 and breakthrough pressure of 2–4 MPa. Particular attention is given to the flow properties of the sandy facies under different testing scenarios including the experimental duration, pore pressure difference, fluid types, and saturation history. Long-term injection experiments highlight exponential permeability reduction driven by time-dependent compaction, which is effectively described by a poroviscoelastic model coupled with a power-law porosity-permeability relationship. In contrast, CO2-rich water injection yields relatively stable permeability with only minor irreversible changes likely controlled by fluid-rock interactions, fluid affinity, and electrokinetic effects. Two-phase flow tests further reveal that CO2 displaces water more effectively in the sandy facies, while CO2 relative permeability is insensitive to lithological differences. These findings demonstrate that heterogeneous Opalinus Clay retains strong sealing integrity under coupled hydro-mechanical-chemical conditions and provide critical laboratory insights that complement ongoing in-situ monitoring within CO2LPIE., H.K. and R.M. acknowledge support from the U.S. National Science Foundation Faculty Early Career Development Program CMMI-2239630 and swisstopo for providing the Opalinus Clay cores. V.V. acknowledges support from the EU Horizon Europe Research and Innovation Program through the Doctoral Network of the Marie Skłodowska-Curie Actions SMILE (https://smile-msca-dn.eu) under grant agreement 101073281; and from the Spanish Ministry of Science, Innovation, and Universities through project HydroPoreII (PID2022-137652NB-C44). IMEDEA is an accredited “Maria de Maeztu Excellence Unit” (Grant CEX2021-001198, funded by MICIU/AEI/10.13039/501100011033)., With funding from the Spanish government through the "Maria de Maeztu Centre of Excellence" accreditation (CEX2021-001198)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Constraints on stress tensor from microseismicity at Decatur

  • Guo, Tian
  • Alexandrov, Dmitry
  • Eisner, Leo
  • Jechumtalova, Zuzana
  • Williams-Stroud, Sherilyn Coretta
  • Bin Waheed, Umair
  • Vilarrasa, Víctor
Induced microseismicity has been detected in the Decatur CO2 sequestration area, providing critical constraints on the stress state at the reservoir. We invert the full stress tensor with two subsets of source mechanisms from the induced microseismic events. To achieve this, we incorporate additional information on the vertical stress gradient and instantaneous shut-in pressure (ISIP) measured in the area. Additionally, our results demonstrate that constraining the intermediate stress tensor to a vertical orientation is essential to achieve a consistent stress inversion. The inverted stress is then used to estimate the minimum activation pressure required to trigger seismicity on fault planes identified by the source mechanisms. The comparison of the minimum activation pressure with injection pressure indicates one of three possibilities: the ISIP pressures are significantly lower than predicted (approximately 28–29 MPa), the maximum horizontal principal stress is extremely high (exceeding 120 MPa), or the coefficient of friction is significantly lower than 0.6 on a large number of activated faults. Our analysis also shows that poorly constrained source mechanisms do not lead to reasonable stress constraint estimates, even when considering alternative input parameters such as ISIP and vertical stress. We conclude that induced microseismicity can effectively be used to estimate the stress field when source mechanisms are also well constrained. For future CO2 sequestration projects, measuring and constraining ISIP pressure and maximum horizontal stress in the reservoir will ensure that more accurate estimates of stress state from moment tensor inversions can be obtained for improved prediction of the long-term reservoir response to injection., This research has been supported by the Horizon Europe Marie Skłodowska-Curie Actions (grant no. 101073281). The article processing charges for this open-access publication were covered by the CSIC Open Access Publication Support Initiative through its Unit of Information Resources for Research (URICI)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Datos de investigación Set de datos (Dataset)

Datasets, software, and figure-source files for injection-induced ground deformation prediction using deep learning

  • Guo, Tian
  • Wu, Haiqing
  • Vilarrasa, Víctor
[Description of methods used for collection/generation of data] Synthetic data are generated from an analytical solution for ground displacement due to reservoir pressurization in a faulted half-space. The independent test dataset was derived from CODE_BRIGHT numerical simulations. Figure-source data were assembled from parameter-sweep test cases and DNN predictions., [Methods for processing the data] Preprocessing includes feature transformation, filtering, standardization using StandardScaler, Pearson correlation analysis, PCA, and assembly of curated figure-source spreadsheets., [Link to other publicly accessible locations of the data] https://github.com/Tiinnaa/DNN-ground-deformation, Data are released under the Creative Commons Attribution 4.0 International License (CC BY 4.0)., The authors acknowledge funding from the EU Horizon Europe Research and Innovation Program through the Doctoral Network of the Marie Sklodowska-Curie Actions SMILE (https://smile-msca-dn.eu/), under grant agreement 101073281. IMEDEA is an accredited Maria de Maeztu Excellence Unit (Grant CEX2021-001198, funded by MICIU/AEI/10.13039/501100011033)., With funding from the Spanish government through the "Maria de Maeztu Centre of Excellence" accreditation (CEX2021-001198)., File List: - data/test/final_combined_test_dataset.csv: Independent CODE_BRIGHT test dataset. - data/comparison_data/dp_dis_1_5_10.csv: Dataset used by legacy exploratory evaluation scripts. - results/figure_data/disxpred1111.xlsx: Curated figure-source data for Figure 9, horizontal displacement Ux. - results/figure_data/disypred1113.xlsx: Curated figure-source data for Figure 10, vertical displacement Uy. - results/training_logs/training_metrics_x.csv: DNN training metrics for Ux. - results/training_logs/training_metrics_y.csv: DNN training metrics for Uy. - results/training_logs/learning_curve_results_Ux.csv: Learning-curve data for the available Ux model run. - results/inference_speed/prediction_time_results.csv: Prediction time results. - results/inference_speed/final_speed_report.csv: Selected benchmark speed report. - results/summary_plot_Ux.png: Summary plot from the available Ux model run., No
UPCommons. Portal del coneixement obert de la UPC
Publicación Artículo científico (JournalArticle)

Constraints on stress tensor from microseismicity at Decatur

  • Guo, Tian
  • Alexandrov, Dmitry
  • Eisner, Leo
  • Jechumtalova, Zuzana
  • Williams-Stroud, Sherilyn Coretta
  • Bin Waheed, Umair
  • Vilarrasa Riaño, Víctor|||0000-0003-1169-4469
Induced microseismicity has been detected in the Decatur CO2 sequestration area, providing critical constraints on the stress state at the reservoir. We invert the full stress tensor with two subsets of source mechanisms from the induced microseismic events. To achieve this, we incorporate additional information on the vertical stress gradient and instantaneous shut-in pressure (ISIP) measured in the area. Additionally, our results demonstrate that constraining the intermediate stress tensor to a vertical orientation is essential to achieve a consistent stress inversion. The inverted stress is then used to estimate the minimum activation pressure required to trigger seismicity on fault planes identified by the source mechanisms. The comparison of the minimum activation pressure with injection pressure indicates one of three possibilities: the ISIP pressures are significantly lower than predicted (approximately 28–29¿MPa), the maximum horizontal principal stress is extremely high (exceeding 120¿MPa), or the coefficient of friction is significantly lower than 0.6 on a large number of activated faults. Our analysis also shows that poorly constrained source mechanisms do not lead to reasonable stress constraint estimates, even when considering alternative input parameters such as ISIP and vertical stress. We conclude that induced microseismicity can effectively be used to estimate the stress field when source mechanisms are also well constrained. For future CO2 sequestration projects, measuring and constraining ISIP pressure and maximum horizontal stress in the reservoir will ensure that more accurate estimates of stress state from moment tensor inversions can be obtained for improved prediction of the long-term reservoir response to injection., This research has been supported by the Horizon Europe Marie Skłodowska-Curie Actions (grant no. 101073281). The article processing charges for this open-access publication were covered by the CSIC Open Access Publication Support Initiative through its Unit of Information Resources for Research (URICI), Peer Reviewed