Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Geochemical and Limnological Characterization of the Corta Atalaya Pit Lake (Riotinto Mines, Spain)

  • Santofimia Pastor, Esther
  • Rincón-Tomás, Blanca
  • López Pamo, José Enrique
  • González Sanz, Francisco Javier
  • Amils, Ricardo
Presented at the 2nd International Conference on Raw Materials and Circular Economy “RawMat2023”, Athens, Greece, 28 August–2 September 2023., This study examines some relevant limnological and hydrogeochemical characteristics of the most emblematic pit lake of the Iberian Pyrite Belt (IPB). Corta Atalaya (CA) open pit mine is known for its large size and for being one of the most important exploitations of copper in Europe. Despite its historical importance, little is known about the lake formed in this open pit. During this study, the pit lake presented a surface area of 16 ha, a maximum depth of 106 m, and a 5.8 hm3 volume of acid and metal-enriched water. CA pit lake shows permanent chemical stratification (meromictic lake), where three layers with different density and chemical composition can be differentiated: (i) a superficial layer of 5 ± 2 m water depth, with electric conductivity (EC) between 5.4–6.64 mS/cm, and oxygenated and Fe(III)-rich mixolimnion; (ii) an intermediate layer (between 5–30 m, chemocline), exhibiting strong vertical changes in parameters such as temperature (T) and EC, which show an increase with depth; and (iii) a thick bottom layer from 30 m to 106 m depth, with anoxic, elevated EC (47 mS/cm) and T (32 °C) values, and a concentration of Fe as Fe(II) (monimolimnion).The characterization of the water column is essential to know the potential sources of strategic and critical raw materials, and to evaluate their possible recuperation, thereby activating a circular economy., This work has been financially supported with funds from EMED-Tartessus Company, in collaboration with Autónoma University Foundation and Instituto Geológico y Minero de España. This study is a contribution the Horizon Europe project GSEU (HORIZON-CL5-2021-D3-02-14, Project 101075609)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Cobalt and Manganese Extraction from Ocean Nodules by Co-Processing with Steel Metallurgical Slag

  • Pérez, Kevin
  • Toro, Norman
  • Robles, Pedro
  • Gallegos, Sandra
  • Gálvez, Edelmira
  • González Sanz, Francisco Javier
  • Marino, Egidio
  • Hernández, Pía C.
[EN] Polymetallic nodules, also called manganese nodules (due to their high content of this element), contain various valuable metals such as Cu, Ni and Co. These seabed minerals are a good alternative source of Co and Mn due to the decrease in the grade of mineral deposits on the earth’s surface. For the treatment of manganese nodules, acid-reducing leaching is apparently the most attractive, due to its low cost compared to other processes, short operational times, and it is more friendly to the environment. In this investigation, the extraction of Mn and Co from manganese nodules from two different locations was studied in acid media and by reusing a steel slag obtained from a steel smelting process. An ANOVA analysis was performed to determine the most appropriate Manganese Nodule/Fe(res) ratio and time to dissolve Co and Mn from the nodules. Effect of temperature on the process was evaluated, and then a residue analysis was carried out. Finally, it was discovered that the best results were obtained when working at 60 °C in a time of 15 min, obtaining extractions of approximately 98% Mn and 55% Co. Additionally, the formation of polluting elements was not observed, nor the precipitation of Mn and Co species in the studied residues., This research was funded by project Fondecyt 1221702 and European project GSEU (HORIZON-CL5-2021-D3-02-14, Project101075609)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Modeling the Leaching of Cobalt and Manganese from Submarine Ferromanganese Crusts by Adding Steel Scrap Using Design of Experiments and Response Surface Methodology

  • Pérez, Kevin
  • Toro, Norman
  • Mura, Mauricio
  • Saldaña, Manuel
  • Galleguillos, Felipe
  • Salazar Castillo, Iván
  • González Sanz, Francisco Javier
  • Marino, Egidio
  • Castillo Segura, Jonathan
  • Castillo Villagra, Ignacio
  • Hernández Avendaño, Pía C.
[EN] Due to the scarcity of high-grade minerals on the Earth’s surface and the ever-increasing demand for critical metals required in the production of clean energy, the search for alternative sources has become essential. Ferromanganese crusts, a mineral resource located in the depths of the ocean, contain high concentrations of valuable metals, particularly cobalt (Co) and manganese (Mn). A leaching process using sulfuric acid, with the addition of steel scrap, has been proposed for processing this resource. The study investigated the extraction of manganese (Mn) and cobalt (Co) under acidic conditions at 25 °C, employing a factorial experimental analysis. Statistical models were adjusted using response surface methodology to evaluate the effects of time and the ferromanganese crust/Fe(res) (iron residue) ratio as predictive variables. The results demonstrated that the extraction of Mn and Co could be effectively modeled through multiple regression, with strong goodness-of-fit indicators. Optimal extraction was achieved at extended durations (30 min) and lower ferromanganese crust/Fe(res) ratios (1/3) for the sampled values. Gradient analysis revealed that extraction efficiency was directly proportional to time and inversely proportional to the ferromanganese crust/Fe(res) ratio, except in the case of Co extraction at higher durations and lower ratio levels. Additionally, no precipitation of Mn or Co species was observed in the analyzed residues., This study was funded by the ATLANTIS project (PID2021-124553OB-I00) of the Spanish State Investigation Agency (AEI), European contract EMODnet-Geology (EASME/EMFF/2016/1.31.2-Lot 1/SI2.750862), and the Horizon Europe projects GSEU (HORIZON-CL5-2021-D3-02-14, Project 101075609). Kevin Perez acknowledges the infrastructure and support of the PhD Program in Mineral Processes Engineering of the Universidad de Antofagasta. The authors are grateful for the support of ANID-Chile through the research projects FONDECYT Iniciación 11230550 and ANID/FONDAP 1522A0006 Solar Energy Research Center SERC-Chile., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Multiscale Cartographic Integration for Exploring and Predicting Critical Raw Materials in Coastal Placers of the Rías Baixas (NW Spain)

  • Ng-Cutipa, W.L.
  • González Sanz, Francisco Javier
  • Lobato Otero, Ana Belén
  • Medialdea Cela, Teresa
  • Somoza, Luis
  • Boixereu Vila, Ester
  • Georgalas, Georgios P.
  • Zananiri, Irene
  • Piña, Rubén
  • Teodoro, Ana Claudia
28 p. - Dentro del número especial "Development and Challenges in Marine Geology"., [EN] The exploration of coastal placer deposits, often enriched in critical raw materials demanded by industry, is significantly challenged by the dynamic marine environment and by the limited research devoted to developing dedicated exploration methodologies. This study presents the first systematic integration of multi-source geospatial data in the Rías Baixas for placer mineral prediction in the initial exploratory stage of these deposits. The primary objective is to investigate the presence of Titanium (ilmenite, and rutile), Zirconium (zircon), and Rare Earth Element (REE)-bearing minerals (monazite, xenotime, allanite, and garnets) in Rías Baixas (NW Spain). The methodology includes a lithological reclassification and the generalization of coastal types. These features are then integrated with watershed, coastline dynamics, and mineral occurrence data. Validation includes existing semi-quantitative and qualitative mineral identification data, and new field observations of heavy mineral accumulations. This integration allowed us to identify nine potential and ten predictive areas with a high probability of hosting coastal placers. The validation process showed a 79% spatial correlation, confirming a significant heavy mineral accumulation in 15 areas. This work underscores the efficacy of integrated cartography in prioritizing potential and predictive areas during the crucial first stage of mineral exploration. The methodology can be further enhanced by incorporating additional data, such as stream sediment geochemistry and the application of remote sensing techniques., This study is funded by the European Union under grant agreement no. 101091616 (https://doi.org/10.3030/101091616 (accessed on 19 November 2024)) project S34I—Secure and Sustainable Supply of Raw Materials for EU Industry, under topic HORIZON-CL4-2022-RESILIENCE-01-08–Earth observation technologies for the mining life cycle in support of EU autonomy and transition to a climate neutral economy (RIA). This work is also supported by the IGME’s funds through INTRAMURAL program (Ref. Proyecto 20043M236), EMODnet-Geology project of European Commission (EASME/EMFF/2020/3.1.11/Lot2/SI2.853812) and Horizon Europe projects GSEU (HORIZON-CL5-2021-D3-02-14, Project 101075609)., Peer reviewed