Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 8
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Vehicle Identification by Means of Radio-Frequency-Identification Cards and Magnetic Loops

  • Mocholí-Belenguer, Ferran
  • Mocholí Salcedo, Antonio
  • Arroyo Núñez, José Humberto
  • Martinez-Millana, Antonio|||0000-0003-1056-5067
[EN] At present, many detectors installed on both urban and interurban roads are capable of extracting information from vehicles such as speed, length or direction of traffic. However, very few sensors are currently able to communicate and exchange information with vehicles in real time. For this reason and due to the existing need for vehicle-infrastructure communication in Intelligent Transportation Systems (ITS), this paper proposes the use of Radio-Frequency-Identification cards together with the magnetic loops already in operation on the road to extract and exchange information about different vehicles through bidirectional communication. This usage will lead to many applications. Therefore, different RFID cards and their operating mode and the electrical circuits necessary for accurate system operation will be presented and analyzed
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Fluctuations in measured radioactive decay rates inside a modified Faraday cage: Correlations with space weather

  • Milián-Sánchez, V.
  • Scholkmann, F.
  • Mocholí Salcedo, Antonio
  • Mocholí-Belenguer, Ferran
  • Iglesias-Martínez, M. E.
  • Kolombet, V. A.
  • Panchelyuga, V. A.
  • Fernández de Córdoba, Pedro|||0000-0002-0347-7280
  • Castro-Palacio, Juan Carlos|||0000-0002-0132-9989
  • Verdú Martín, Gumersindo Jesús|||0000-0001-5098-080X
[EN] For several years, reports have been published about fluctuations in measured radioactive decay time-series and in some instances linked to astrophysical as well as classical environmental influences. Anomalous behaviors of radioactive decay measurement and measurement of capacitance inside and outside a modified Faraday cage were documented by our group in previous work. In the present report, we present an in-depth analysis of our measurement with regard to possible correlations with space weather, i.e. the geomagnetic activity (GMA) and cosmic-ray activity (CRA). Our analysis revealed that the decay and capacitance time-series are statistically significantly correlated with GMA and CRA when specific conditions are met. The conditions are explained in detail and an outlook is given on how to further investigate this important finding. Our discovery is relevant for all researchers investigating radioactive decay measurements since they point out that the space weather condition during the measurement is relevant for partially explaining the observed variability., This work has been partially financed by: grant no. 20170764 (Equipos de deteccion, regulacion e informacion en el sector de los sistemas inteligentes de transporte (ITS). Nuevos modelos y ensayos de compatibilidad y verificacion de funcionamiento) (Spain), by grant no. RTI2018-102256-B-I00 (Spain), by the Generalitat Valenciana (Spain) under project Bioingenieria de las Radiaciones Ionizantes. Biorad (PROMETEO/2018/035) and the project MEMO RADION (IDIFEDER/2018/038) co-financed by the Programa Operativo del Fondo Social Europeo 2014-2020", and by grant No.075-00845-20-01 (Russia).
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

The Effectiveness of Alert Sounds for Electric Vehicles Based on Pedestrians&apos, Perception

  • Mocholí Belenguer, Ferran
  • Mocholí Salcedo, Antonio
  • Martinez-Millana, Antonio|||0000-0003-1056-5067
  • Castells, Francisco|||0000-0001-5044-3545
[EN] One of the largest problems with electric vehicles is that they often go unnoticed by pedestrians due to the absence of noticeable noise generated by electric motors, which is a potential cause of accidents and collisions. Surprisingly, this positive property in terms of reducing the noise pollution is in fact becoming a road safety problem. In addition, with the promotion of electric traction vehicles due to new environmental policies and the current proliferation of personal mobility vehicles, this problem could even be increased in the coming years. Therefore, the future global road regulation has included aspects on noise and warning sounds that electric vehicles must emit in the years to come. However, despite the requirements, no specific signal type or many other features have been established. Only the emission levels have been set (56-75 dB). Consequently, within the framework of this problem, this article evaluates the acoustic characteristics of the sound that should he emitted by electric vehicles so that pedestrians can easily detect them and the optimal sound pressure level they should emit to not unnecessarily raise noise pollution levels, concluding that the emission limits established are excessive in certain scenarios and that optimal warning sounds must be focused on electronically imitating combustion engine noises., This work was supported by the Universitat Politecnica de Valencia through its Internal Project Equipos de deteccion, regulacion e informacion en el sector de los sistemas inteligentes de transporte (ITS)-(20170764). The Associate Editor for this article was S. Hamdar.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Double Magnetic Loop and Methods for Calculating Its Inductance

  • Mocholí-Belenguer, Ferran
  • Mocholí Salcedo, Antonio
  • Milian Sánchez, Victor
  • Arroyo Nuñez, José Humberto
[EN] Due to their simplicity and operating mode, magnetic loops are one of the most used traffic sensors in Intelligent Transportation Systems (ITS). However, at this moment, their potential is not being fully exploited, as neither the speed nor the length of the vehicles can be surely ascertained with the use of a single magnetic loop. In this way, the vast majority of them are only being used to count vehicles on urban and interurban roads. For this reason, in order to contribute to the development of new traffic sensors and make roads safer, this paper introduces a theoretical study to explain the design and peculiarities of the innovative double loops, how to calculate their magnetic field and three different methods to calculate their inductance. Finally, the different inductance values obtained by these three methods will be analyzed and compared with experimental measurements carried out by our research group in order to know which method is more accurate and if all of them are equally reliable., Ha recibido financiación del proyecto Equipos de Detección, Regulación e Información en el sector de los Sistemas Inteligentes de Transporte (ITS). Nuevos Modelos y Ensayos de Compatibilidad y Verificación de Funcionamiento (Universitat Politècnica de València)
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Vehicle modeling for the analysis of the response of detectors based on inductive loops

  • Mocholí-Belenguer, Ferran
  • Mocholí Salcedo, Antonio
  • Milián Sánchez, Victor
  • Martinez-Millana, Antonio|||0000-0003-1056-5067
[EN] Magnetic loops are one of the most popular and used traffic sensors because of their widely extended technology and simple mode of operation. Nevertheless, very simple models have been traditionally used to simulate the effect of the passage of vehicles on these loops. In general, vehicles have been considered simple rectangular metal plates located parallel to the ground plane at a certain height close to the vehicle chassis. However, with such a simple model, it is not possible to carry out a rigorous study to assess the performance of different models of vehicles with the aim of obtaining basic parameters such as the vehicle type, its speed or its direction in traffic. For this reason and because computer simulation and analysis have emerged as a priority in intelligent transportation systems (ITS), this paper aims to present a more complex vehicle model capable of characterizing vehicles as multiple metal plates of different sizes and heights, which will provide better results in virtual simulation environments. This type of modeling will be useful when reproducing the actual behavior of systems installed on roads based on inductive loops and will also facilitate vehicle classification and the extraction of basic traffic parameters., This research has been funded by the Universitat Politecnica de Valencia through its internal project `Detection, regulation and information equipment in the sector of intelligent transport systems (ITS). New models and tests of compatibility and verification of operation ' (20170764), which has been carried out at the ITACA Institute. The funder had no role in study design, data collection and analysis, decision to publish, or preparation of the manuscript.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Disdrometer Performance Optimization for Use in Urban Settings Based on the Parameters that Affect the Measurements

  • Mocholí-Belenguer, Ferran
  • Mocholí Salcedo, Antonio
  • Milián Sánchez, Víctor
  • Martinez-Millana, Antonio|||0000-0003-1056-5067
  • Palomo-Anaya, M Jose|||0000-0002-9811-8685
[EN] There are currently different types of commercial optical disdrometers to measure the rainfall intensity, of which many are commonly used for monitoring road conditions. Having information about the amount of rain, the composition of the precipitation particles and visibility are essential to avoid accidents, which requires intelligent systems that warn drivers and redirect traffic. However, few studies related to Intelligent Transport Systems (ITS) have been performed regarding why these devices are not optimized for this type of applications. Therefore, this paper analyzes and evaluates the operating mode of these equipment through their theoretical model, which will allow the design of prototypes of disdrometers with different characteristics. In addition, this model will be implemented in a simulation program, through which an exhaustive study analyzing how the type of precipitation and its intensity affect the measures provided by the model will be conducted. In this way, the results will help optimize its operation to be thus used in urban settings, which will allow obtaining more accurate real-time information, better traffic management, and a reduction in the number of accidents., This research has been funded by the Universitat Politecnica de Valencia through its internal project "Equipos de deteccion, regulacion e informacion en el sector de los sistemas inteligentes de transporte (ITS). Nuevos modelos y ensayos de compatibilidad y verificacion de funcionamiento", which has been carried out at the ITACA Institute.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Design, Implementation, and Configuration of Laser Systems for Vehicle Detection and Classification in Real Time

  • Gallego Ripoll, Maria De Las Nieves
  • Ballester Merelo, Francisco José|||0000-0002-2464-5116
  • Gómez Aguilera, Luís Enrique
  • Mocholí-Belenguer, Ferran
  • Mocholí Salcedo, Antonio
[EN] The use of real-time vehicle detection and classification systems is essential for the accurate management of traffic and road infrastructure. Over time, diverse systems have been proposed for it, such as the widely known magnetic loops or microwave radars. However, these types of sensors do not offer all the information currently required for exhaustive and comprehensive traffic control. Thus, this paper presents the design, implementation, and configuration of laser systems to obtain 3D profiles of vehicles, which collect more precise information about the state of the roads. Nevertheless, to obtain reliable information on vehicle traffic by means of these systems, it is fundamental to correctly carry out a series of preliminary steps: choose the most suitable type of laser, select its configuration properly, determine the optimal location, and process the information provided accurately. Therefore, this paper details a series of criteria to help make these crucial and difficult decisions. Furthermore, following these guidelines, a complete laser system implemented for vehicle detection and classification is presented as result, which is characterized by its versatility and the ability to control up to four lanes in real time., This research has been funded by the Universitat Politecnica de Valencia through its internal project `Equipos de deteccion, regulacion e informacion en el sector de los sistemas inteligentes de transporte (ITS). Nuevos modelos y ensayos de compatibilidad y verificacion de funcionamiento', which has been carried out at the ITACA Institute.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Advantages offered by the double magnetic loops versus the conventional single ones

  • Mocholí-Belenguer, Ferran
  • Mocholí Salcedo, Antonio
  • MILIAN SANCHEZ, VICTOR
  • Guill Ibáñez, Antonio|||0000-0001-8546-264X
[EN] Due to their simplicity and operating mode, magnetic loops are one of the most used traffic sensors in Intelligent Transportation Systems (ITS). However, at this moment, their potential is not being fully exploited, as neither the speed nor the length of the vehicles can be surely ascertained with the use of a single magnetic loop. In this way, nowadays the vast majority of them are only being used to measure traffic flow and count vehicles on urban and interurban roads. This is the reason why we presented in a previous paper the double magnetic loop, capable of improving the features and functionalities of the conventional single loop without increasing the cost or introducing additional complexity. In that paper, it was introduced their design and peculiarities, how to calculate their magnetic field and three different methods to calculate their inductance. Therefore, with the purpose of improving the existing infrastructure and providing it with greater potential and reliability, this paper will focus on justifying and demonstrating the advantages offered by these double loops versus the conventional ones. This will involve analyzing the magnetic profiles generated by the passage of vehicles over double loops and comparing them with those already known. Moreover, it will be shown how the vehicle speed, the traffic direction and many other data can be obtained more easily and with less margin of error by using these new inductance signatures., This research has been funded by the Universitat Politecnica de Valencia through its internal project 'Equipos de deteccion, regulacion e informacion en el sector de los sistemas inteligentes de transporte (ITS). Nuevos modelos y ensayos de compatibilidad y verificacion de funcionamiento', which has been carried out at the ITACA Institute