Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

Biblos-e Archivo. Repositorio Institucional de la UAM
Publicación Artículo científico (JournalArticle)

Isolation and characterization of few-layer black phosphorus

  • Castellanos-Gomez, Andres
  • Vicarelli, Leonardo
  • Prada, Elsa
  • Island, Joshua O.
  • Narasimha-Acharya, K. L.
  • Blanter, Sofya I.
  • Groenendijk, Dirk J.
  • Buscema, Michele
  • Steele, Gary A.
  • Alvarez, J. V.
  • Zandbergen, Henny W.
  • Palacios Burgos, Juan José
  • Van Der Zant, Herre S J
This is the post-peer reviewed version of the following article: A. Castellanos-Gomez et al. “Isolation and characterization of few-layer black phosphorus”. 2D Matererials, 2014, 1(2) 025001 doi:10.1088/2053-1583/1/2/025001 Which has been published in final form at: http://iopscience.iop.org/2053-1583/1/2/025001, Isolation and characterization of mechanically exfoliated black phosphorus flakes with a thickness down to two single-layers is presented. A modification of the mechanical exfoliation method, which provides higher yield of atomically thin flakes than conventional mechanical exfoliation, has been developed. We present general guidelines to determine the number of layers using optical microscopy, Raman spectroscopy and transmission electron microscopy in a fast and reliable way. Moreover, we demonstrate that the exfoliated flakes are highly crystalline and that they are stable even in free-standing form through Raman spectroscopy and transmission electron microscopy measurements. A strong thickness dependence of the band structure is found by density functional theory calculations. The exciton binding energy, within an effective mass approximation, is also calculated for different number of layers. Our computational results for the optical gap are consistent with preliminary photoluminescence results on thin flakes. Finally, we study the environmental stability of black phosphorus flakes finding that the flakes are very hydrophilic and that long term exposure to air moisture etches black phosphorus away. Nonetheless, we demonstrate that the aging of the flakes is slow enough to allow fabrication of field-effect transistors with strong ambipolar behavior. Density functional theory calculations also give us insight into the water-induced changes of the structural and electronic properties of black phosphorus, A.C-G. acknowledges financial support through the FP7-Marie Curie Project PIEF-GA-2011-300802 (‘STRENGTHNANO’). This work was supported by the Dutch organization for Fundamental Research on Matter (FOM), the Spanish Ministry of Economy and Innovation through Grants Nos. FIS2010-21883-C02-2, FIS2012-37549-C05-03 and CONSOLIDER CSD2007-0010, the Generalitat Valenciana under Grant PROMETEO/2012/011, and the Ramón y Cajal Program (E.P). KLMA acknowledges support from the CCC of the Universidad Autónoma de Madrid
Repositorio Institucional del Instituto Madrileño de Estudios Avanzados en Nanociencia
Publicación Artículo científico (JournalArticle)

Precise and reversible band gap tuning in single-layer MoSe2 by uniaxial strain

  • Island J.O.
  • Kuc A.
  • Diependaal E.H.
  • Bratschitsch R.
  • Van Der Zant H.S.J.
  • Heine T.
  • Castellanos-Gomez A.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Local strain engineering in atomically thin MoS2

  • Castellanos-Gómez, Andrés
  • Roldán, Rafael
  • Cappelluti, E.
  • Buscema, M.
  • Guinea, Francisco
  • Zant, Herre S. J. van der
  • Steele, Gary A.
Controlling the bandstructure through local-strain engineering is an exciting avenue for tailoring optoelectronic properties of materials at the nanoscale. Atomically thin materials are particularly well-suited for this purpose because they can withstand extreme nonhomogeneous deformations before rupture. Here, we study the effect of large localized strain in the electronic bandstructure of atomically thin MoS2. Using photoluminescence imaging, we observe a strain-induced reduction of the direct bandgap and funneling of photogenerated excitons toward regions of higher strain. To understand these results, we develop a nonuniform tight-binding model to calculate the electronic properties of MoS2 nanolayers with complex and realistic local strain geometries, finding good agreement with our experimental results. © 2013 American Chemical Society., This work was supported by the European Union (FP7) through the program RODIN and the Dutch organization for Fundamental Research on Matter (FOM). A.C.-G. acknowledges financial support through the FP7-Marie Curie Project PIEF-GA-2011- 300802 (“STRENGTHNANO”). R.R. acknowledges financial support from the Juan de la Cierva Program (MINECO, Spain). E.C. acknowledges financial support through the FP7-Marie Curie Project PIEF-GA-2009-251904. F.G. and R.R. acknowledge support from MINECO (Spain), through grant FIS2011-23713 and ERC Advanced grant no. 290846., Peer Reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Strain engineering in semiconducting two-dimensional crystals

  • Roldán, Rafael
  • Castellanos-Gómez, Andrés
  • Cappelluti, E.
  • Guinea, Francisco
One of the fascinating properties of the new families of two-dimensional crystals is their high stretchability and the possibility to use external strain to manipulate, in a controlled manner, their optical and electronic properties. Strain engineering, understood as the field that study how the physical properties of materials can be tuned by controlling the elastic strain fields applied to it, has a perfect platform for its implementation in the atomically thin semiconducting materials. The object of this review is to give an overview of the recent progress to control the optical and electronics properties of 2D crystals, by means of strain engineering. We will concentrate on semiconducting layered materials, with especial emphasis in transition metal dichalcogenides (MoS2, WS2, MoSe2 and WSe2). The effect of strain in other atomically thin materials like black phosphorus, silicene, etc, is also considered. The benefits of strain engineering in 2D crystals for applications in nanoelectronics and optoelectronics will be revised, and the open problems in the field will be discussed., RR acknowledges financial support from the Juan de la Cierva Program, and the Spanish Ministry of Economy (MINECO) through Grant No. FIS2011-23713. AC-G acknowledges financial support by the European Union (FP7) through the FP7-Marie Curie Project PIEF-GA-2011-300802 (STRENGTHNANO) and by the Fundacion BBVA through the fellowship I Convocatoria de Ayudas Fundacion BBVA a Investigadores, Innovadores y Creadores Culturales (Semiconductores ultradelgados: hacia la optoelectronica flexible). EC acknowledges support from the European project FP7-PEOPLE-2013-CIG 'LSIE 2D', Italian National MIUR Prin project 20105ZZTSE, and the Italian MIUR program 'Progetto Premiale 2012' Project ABNANOTECH. FG acknowledges the European Union Seventh Framework Programme under grant agreement n604391 Graphene Flagship, and the European Research Council Advanced Grant program (contract 290846)., No