Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación
Contribución de congreso (ConferenceOutput)
A new ABS conductive material to develop fully 3D-printed patch antennas
Additive manufacturing technology is rapidly overcoming some of its initial limitations and, thus, creating a very useful engineering option for prototyping complex geometries for a wide range of electronic devices. Based on important advantages such as turn-around, reliability, material waste reduction, and low implementation costs, the technology is being continuously developed and improved. This paper presents a completely 3D-printed microstrip patch antenna to demonstrate the feasibility of a new conductive Acrylonitrile Butadiene Styrene (ABS) material in the fabrication of three-dimensional (3D) antennas using additive manufacturing method. The prototype of the antenna has been fabricated using Raise3D E2 printer, commercial ABS and a new ABS filament developed by Naitec for dielectric and conductive parts of the antenna, respectively. The fabricated antenna is compact and light. Preliminary prototypes and fabrication techniques are presented., The authors would like to thank Navarre Government for
the funding provided by “Ayudas para la contratación de
doctorandos y doctorandas, Doctorados industriales 2021”,
Resolución 87E/2021 and Project AMELEC, PC017-018
AMELEC - Advanced Manufacturing of Materials, as well
as the Spanish Research Agency, for funding the Project
PID2019-109984-RB-43/AEI/10.130 39/501100011033.