RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación
Capítulo o parte de un libro (BookPart)
Spray and Combustion Characterizations of Acetone-Butanol-Ethanol (ABE) blend at High-Pressure and High-Temperature Conditions
ÈN] Abstract
The intermediate fermentation mixture of butanol production, Acetone, Butanol and Ethanol (ABE), is increasingly
considered as a new alternative fuel in CI engines due to its physical and chemical properties, which are similar to
those of butanol, and its advantages of no additional cost or energy consumption due to butanol separation. In a
previous study, the High-Pressure and High-Temperature (HPHT) chamber, called ‘New One Shot Engine” (NOSE),
was used to investigate macroscopic spray-combustion parameters by validating Spray-A conditions of the Engine
Combustion Network. The present study concerns the spray-combustion characteristics of the ABE mixture (volume
ratio 3:6:1), blended with n-dodecane at a volumetric ratio of 20% (ABE20), compared to n-dodecane as reference
fuel. The macroscopic spray and combustion parameters were investigated, for non-reactive conditions, in pure
Nitrogen and for reactive conditions, in 15% oxygen, at ambient pressure (60 bar), ambient density (22.8 kg/m3
)
and different ambient temperatures (800 K, 850 K and 900 K). The liquid and vapor spray penetrations were
investigated by the Diffused Back Illumination (DBI) and Schlieren techniques in non-reactive conditions. In reactive
conditions, the lift-off length was measured by OH* chemiluminescence images at 310 nm. The Schlieren technique
was also used to verify the choice of detection criterion. The ignition delay results of the two fuels were compared.
It was found that the behavior of the two fuels as a function of temperature was similar even if the liquid length of
ABE20 was shorter than that of n-dodecane at all ambient temperatures. On the other hand, no real difference in
vapor spray penetration between the two fuels was observed. The vaporization properties and the lower autoignition
ability of ABE20 led to longer ignition delays and lift-off length., The authors acknowledge the National Research Agency (contract ANR-14-CE22-0015-01) for financial support to
the ECN-France project and Region Centre Val de Loire (CPER 2007-2013 Energies du Futur) and FEDER for
financial support to build the experimental set-up. We also thank G.Bruneaux and M.Bardi from IFPen for interesting
discussions that helped us to refine the analysis.