Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Schlieren Methodology for the Analysis of Transient Diesel Flame Evolution

  • Pastor, José V.|||0000-0003-4113-4681
  • Payri, Raul|||0000-0001-7428-5510
  • García-Oliver, José M|||0000-0002-2676-9681
  • Briceño Sánchez, Francisco Javier
[EN] Schlieren/shadowgraphy has been adopted in the combustion research as a standard technique for tip penetration analysis of sprays under diesel-like engine conditions. When dealing with schlieren images of reacting sprays, the combustion process and the subsequent light emission from the soot within the flame have revealed both limitations as well as considerations that deserve further investigation. Seeking for answers to such concerns, the current work reports an experimental study with this imaging technique where, besides spatial filtering at the Fourier plane, both short exposure time and chromatic filtering were performed to improve the resulting schlieren image, as well as the reliability of the subsequent tip penetration measurement. The proposed methodology has reduced uncertainties caused by artificial pixel saturation (blooming). Additionally, an algorithm to calculate Lift-off length from schlieren images has been developed and compared to the more conventional OH* imaging technique. By means of the improved setup, the analysis of transient diesel flame has been performed throughout the ignition and early combustion phases. When compared to a non-reacting vaporizing spray, the temporal evolution of the reacting case departs from the inert one at the start of combustion, when expansion in both axial (i.e. spray tip increase) and radial direction are observed. After that, the tip penetration progressively decreases on a clear transient period where the flow tries to re-organize itself in response to the induced reaction zone. Eventually, the spray undergoes an acceleration period where the reacting spray tip progresses above the non-reacting one. A parametric study has been conducted for three injection pressure levels to investigate the influence of this parameter upon transient flame evolution., This work was partially funded by the Spanish Ministry of Education and Science through the “LES METHODS FOR THE SIMULATION OF MULTIPHASE SPRAYS” project (ENE2010-18542). Mr. Francisco J. Briceño wishes to acknowledge financial support through a PhD studies grant (AP2008-02231) also sponsored by the Spanish Ministry of Education and Science
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

An experimental analysis on the evolution of the transient tip penetration in reacting Diesel sprays

  • Desantes J.M.|||0000-0002-4124-9393
  • García-Oliver, José M|||0000-0002-2676-9681
  • Pastor, José V.
  • Briceño Sánchez, Francisco Javier
Schlieren imaging has helped deeply characterize the behavior of Diesel spray when injected into an oxygen-free ambient. However, when considering the transient penetration of the reacting spray after autoignition, i.e. the Diesel flame, few studies have been found in literature. Differences among optical setups as well as among experimental conditions have not allowed clear conclusions to be drawn on this issue. Furthermore, soot radiation may have a strong effect on the image quality, which cannot be neglected. The present paper reports an investigation on the transient evolution of Diesel flame based upon schlieren imaging. Experimental conditions have spanned values of injection pressure, ambient temperature and density for typical Diesel engine conditions. An optimized optical setup has been used, which makes it possible to obtain results without soot interference. Based on observations for a long injection event (4 ms Energizing Time), the analysis has resorted to extensive comparison of inert and reacting sprays parameters, which have made it possible to define different phases after autoignition. Shortly after autoignition, axial and radial expansion of the spray have been observed in terms of tip penetration and radial cone angle. After that, during a stabilization phase, the reacting spray penetrates at a similar rate as the inert one. Later, the reacting spray undergoes an acceleration period, where it penetrates at a faster rate than the inert one. Finally, the flame enters a quasi-steady penetration phase, where the ratio of reacting and inert penetration stabilizes at a nearly constant value. The duration of the reacting spray penetration stages shows modifications when varying engine parameters such as air temperature, air density, injection pressure, and nozzle diameter. However, the proportionality between reacting and inert penetration has been observed to depend mainly on temperature, in agreement with observed reductions in entrainment when shifting from inert to reacting conditions. (C) 2014 The Combustion Institute. Published by Elsevier Inc. All rights reserved., This work was partially funded by the Spanish Ministry of Science and Technology through the "EFFICIENT AND CLEAN COMBUSTION IN COMPRESSION IGNITION ENGINES USING THE DUAL-FUEL CONCEPT" Project (TRA2011-26359). Mr. Francisco J. Briceno wishes to acknowledge financial support through a PhD studies Grant (AP2008-02231) also sponsored by the Spanish Ministry of Education and Science. Last, but not least, authors would like to express their gratitude to Jose Enrique del Rey for his enthusiasm, proactiveness and help during data acquisition.