Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Alumina/molybdenum nanocomposites obtained by colloidal synthesis and spark plasma sintering

  • Fernández-González, Daniel
  • Suárez-Menéndez, Marta
  • Piñuela-Noval, Juan
  • Díaz, Luís Antonio
  • Gómez-Rodríguez, Carlos
  • García Quiñonez, Luís V.
  • Fernández-Valdés, Adolfo
  • Borrell Tomás, María Amparo|||0000-0003-4292-4538
[EN] Alumina/molybdenum nanocomposites were prepared by colloidal synthesis from alumina powder and molybdenum (V) chloride using ethanol as dispersion medium. Modified alumina was calcined at 450 ¿C in air atmosphere to remove chlorides, and then treated in a tubular furnace at 850 ¿C under Ar/H2 to reduce the MoO3 formed in the previous stage and obtain Al2O3 with molybdenum nanoparticles on the surface. Three different molybdenum contents were proposed (1, 5 and 10 wt % Mo), and pure alumina was used as reference, that were sintered by spark plasma sintering (SPS) under vacuum atmosphere at 1400 ¿C for 3 min with an applied pressure of 80 MPa. Composites were characterized by microstructure, hardness, toughness, and three-point bending test. The presence of molybdenum nanoparticles resulted in a fine-grained structure promoted by the presence of molybdenum at grain boundaries and triple points, as well as by the utilization of the SPS equipment. Hardness is at least a 20% greater and fracture toughness 30% larger in the composites than in the monolithic alumina., Daniel Fernandez-Gonzalezacknowledges the grant (Juan de la Cierva-Formacion program) FJC2019-041139-I funded by MCIN/AEI/10.13039/501100011033 (Ministerio de Ciencia e Innovacion, Agencia Estatal de Investigacion). The authors also acknowledge the financial support received from FICYT (IDI/2021/000106). Juan Pinuela Noval acknowledges the Programa Severo Ochoa of Grants for Research and Teaching of the Principality of Asturias for the funds received for the elaboration of the Ph. D. Thesis (Ref: BP20 041).
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Effect of Mo content on the properties of graphite MoC composites sintered by spark plasma sintering

  • Suárez, Marta
  • Fernández-González, Daniel
  • Díaz, Luís Antonio
  • Piñuela-Noval, Juan
  • Moya, José Serafin
  • Torrecillas, Ramón
  • Fernández, Adolfo
  • Borrell Tomás, María Amparo|||0000-0003-4292-4538
[EN] Graphite-molybdenum-titanium powders prepared by colloidal processing technique were sintered by Spark Plasma Sintering (SPS). This material is proposed in this manuscript due to its potential interest as heat sink. The influence of the molybdenum content (2.5, 5.0 and 10.0 vol.%) on the thermal, electrical, and mechanical properties of the composite are studied to define the composite with the best properties. Thermal, electrical, and mechanical properties of the composite graphite¿10 vol.% Mo¿1 vol.% Ti (that are composites of graphite with molybdenum and titanium carbides after sintering) are significantly better than those ofthe composites with lower molybdenum contents (2.5 vol.% and 5 vol.%). This way, flexural strength, electrical conductivity, and thermal conductivity are 1.5, 7.8 and 18 times greater, respectively, than in the composite graphite¿2.5 vol.% Mo¿1 vol.% Ti. In the case of comparing with the composite graphite¿5 vol.% Mo¿1 vol.% Ti, flexural strength, electrical conductivity, and thermal conductivity are 1.2, 5.1 and 3.2 greater in the composite graphite¿10 vol.% Mo¿1 vol.% Ti, respectively., This research was funded by the Spanish Ministry of Science and Innovation. Call Programa Estatal de I+D+i Orientada a los Retos de la Sociedad (RTI2018-102269-BI00). Daniel Fernández-González acknowledges the grant (Juan de la Cierva-Formación program) FJC2019-041139-I funded by MCIN/AEI/ 10.13039/501100011033 (Ministerio de Ciencia e Innovación, Agencia Estatal de Investigación). Amparo Borrell acknowledges for her RYC-2016-20915. Juan Pinuela Noval acknowledges the Programa Severo Ochoa of Grants for Research and Teaching of the Principality of Asturias for the funds received for the elaboration of the Ph.D. Thesis (Ref: BP20 041).