Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

System constants of synthesized poly(methyl-3,3,3-trifluoropropyl) siloxanes

  • Lebrón-Aguilar, Rosa
  • Quintanilla-López, Jesús Eduardo
  • Tello, A. M.
  • Pérez-Parajón, J. M.
  • Santiuste, J. M.
10 pages, 4 figures, 6 tables, The method of solvation model has been applied to five poly (methyl-trifluoropropyl) siloxanes (TFPSXX) prepared in our laboratories, at five trifluoropropyl (TFP) group contents, XX = 0, 11.5, 26.3, 35.5 and 50.0%, at 80, 100, 120 and 140 degrees C. Previously, specific retention volumes of 60-odd solutes of varied polarities were measured upon each of these stationary phases within the above temperature range. Constant s prevails over all other constants, TFPSXX stationary phases showing strong dipole/induced dipole forces with the solutes, moderate acidity and no basicity at all. Constant e is zero in the stationary phase without TFP groups, but has negative low-medium values for the other fluorine contents, XX from 11.5 to 50.0%, hinting at repulsive forces, as expected. Normal values for constant l, decreasing from the less cohesive TFPS00 to the more cohesive TFPS50, were found. For each TFP content constants s, a and l show a negative temperature dependence, while constant e increases as temperature increases. Constant c also decreases with increasing temperature. At each temperature, constants s and a increase with increasing %TFP (or increasing stationary phase polarity), whereas constants e and l show the opposite trend, diminishing with increasing polarity of the stationary phase. Principal component analysis shows that the five stationary phases presented in this work conform a group with other earlier synthesized trifluoropropyl siloxanes and other fluorinated stationary phases taken from literature: VB-210, QF-1, DB-200, DB-210 and PFS6, showing the same selectivity which only the fluorine atom confers. A dendrogram of 38 stationary phases supports these results., This work was financed by the Spanish Dirección General de Investigación under Project BQU 2002-03381., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Application of the solvation parameter model to poly(methylcyanopropylsiloxane) stationary phases

  • Tello, A. M.
  • Lebrón-Aguilar, Rosa
  • Quintanilla-López, Jesús Eduardo
  • Pérez-Parajón, J. M.
  • Santiuste, J. M.
12 pages, 15 figures, 7 tables, The solvation parameter model has been applied to the specific retention volumes of 65 solutes of varied polarity on glass capillary columns coated with commercial and synthesized poly(methylcyanopropyl)siloxanes (CNPXX) with eight different percentages of cyanopropyl group (CNP). Their system constants were determined at 75, 90, 105 and 120 degrees C. The polymers examined do not either show any acidity (b = 0) or interact with solute pi/n electrons (e = 0); the prominent constants, dipolarity/polarizability and hydrogen-bond basicity, are of the same order (s approximately a), and the cavity formation/dispersive forces have normal values. Constants s, l and a decrease linearly with temperature for each cyanopropyl percentage. At each temperature, the constants s and a increase with polarity of polymer according to a curve, while the constant l decreases slightly. Cluster analysis shows that six CNPXX with medium to high cyanopropyl substitution integrate into a group with other high-polarity cyano-containing stationary phases taken from the literature, while the other three CNPXX with low CNP percentage form a group with other low-polarity stationary phases of different chemical nature. These clusters are supported by the dendrogram of 52 stationary phases made with the nine polymers presented here and other 43 taken from the literature., This work was financed by the Spanish Direccion General de Investigacion and carried out under Project BQU 2002-03381., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

An accurate and easy procedure to obtain isothermal Kováts retention indices in gas chromatography

  • García-Domínguez, José Antonio
  • Lebrón-Aguilar, Rosa
  • Quintanilla-López, Jesús Eduardo
8 pages, 6 tables, Isothermal Kováts retention indices may be used in GC for identification purposes, but they are also useful in characterisation of stationary phases and for studying structural and physico-chemical properties of both the analyte and the stationary phase. They are currently reported as whole numbers with an accuracy of one index unit for non-polar stationary phases. The method recommended for their calculation uses a linear regression model, although non-linear models have also been applied with good results. In both cases, a computer programme and the retention times of a series of n-alkanes that elute correctly and resolved from the other compounds are needed, conditions which cannot always be fulfilled. However, it is possible to calculate retention indices with an accuracy of 0.1 retention index units (0.2 units for packed columns) with the help of only three n-alkanes using just a pocket calculator or a computer spreadsheet. The main requirement is that at least one of the n-alkanes has a retention index differing by no more than one hundred retention index units from that of the analyte being investigated. Examples are given for different stationary phases., The results presented in this paper have been obtained and elabo-rated under the Projects PB98-0537-C02 and BQU2002-03381 ofthe Dirección General de Investigación of Spain. The authors wishto express their thanks to M. A. de Diago for her help in some ofthe numerical calculations., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Isothermal retention indices on poly(3,3,3-trifluoropropylmethylsiloxane) stationary phases

  • Lebrón-Aguilar, Rosa
  • Quintanilla-López, Jesús Eduardo
  • Tello, Ana María
  • Santiuste, José María
13 pages, 6 figures, 9 tables, Isothermal retention indices (I) of 56 solutes of varied chemical nature and polarity were determined by a well-proven accurate method on poly(3,3,3-trifluoropropylmethylsiloxanes) with trifluoropropyl group percentages between 0 and 50% within the 353-413 K temperature range. The column temperature effect on the retention index for a representative set of solutes was studied. The linear model and the recent expression I = a + bT(-1) + c ln T were discussed. The retention index dependence on the polymer polarity was also investigated. Principal component analysis and multiple linear regression (MLR) were applied to obtain retention models relating the I values to physicochemical and molecular properties of the solutes chromatographed. The best model of prediction of the retention in these fluorinated stationary phases was obtained by using the Abraham's descriptors., This work was carried out under Projects BQU2002-03381 and CTQ2006-10512/BQU of Dirección General de Investigación, Ministerio de Educación y Ciencia, Spain, Peer reviewed