Pasar al contenido principal

FLUJOS BAROCLINOS Y BALANCE DE ENERGIA SUPERFICIAL EN TERRENO COMPLEJO

CGL2012-37416-C04-01

•
Nombre agencia financiadora Ministerio de Economía y Competitividad
Acrónimo agencia financiadora MINECO
Programa Programa Nacional de Proyectos de Investigación Fundamental
Subprograma Subprograma de Proyectos de Investigación Fundamental no Orientada
Convocatoria Proyectos I+D
Año convocatoria 2012
Plan Estatal 2008-2011 Plan Nacional de Investigación Científica, Desarrollo e Innovación Tecnológica
Unidad de gestión Secretaría de Estado de Investigación, Desarrollo e Innovación
Centro beneficiario UNIVERSIDAD DE LAS ISLAS BALEARES
Identificador persistente http://dx.doi.org/10.13039/501100003329

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

Repositori Obert UdL
Publicación Artículo científico (JournalArticle)

Daytime sensible heat flux estimation over heterogeneous surfaces using multitemporal land‐surface temperature observations

  • Castellví Sentís, Francesc
  • Cammalleri, C.
  • Ciraolo, G.
  • Maltese, A.
  • Rossi, F.
Equations based on surface renewal (SR) analysis to estimate the sensible heat flux (H) require as input the mean ramp amplitude and period observed in the ramp‐like pattern of the air temperature measured at high frequency. A SR‐based method to estimate sensible heat flux (HSR‐LST) requiring only low‐frequency measurements of the air temperature, horizontal mean wind speed, and land‐surface temperature as input was derived and tested under unstable conditions over a heterogeneous canopy (olive grove). HSR‐LST assumes that the mean ramp amplitude can be inferred from the difference between land‐surface temperature and mean air temperature through a linear relationship and that the ramp frequency is related to a wind shear scale characteristic of the canopy flow. The land‐surface temperature was retrieved by integrating in situ sensing measures of thermal infrared energy emitted by the surface. The performance of HSR‐LST was analyzed against flux tower measurements collected at two heights (close to and well above the canopy top). Crucial parameters involved in HSR‐LST, which define the above mentioned linear relationship, were explained using the canopy height and the land surface temperature observed at sunrise and sunset. Although the olive grove can behave as either an isothermal or anisothermal surface, HSR‐LST performed close to H measured using the eddy covariance and the Bowen ratio energy balance methods. Root mean square differences between HSR‐LST and measured H were of about 55 W m−2. Thus, by using multitemporal thermal acquisitions, HSR‐LST appears to bypass inconsistency between land surface temperature and the mean aerodynamic temperature. The one‐source bulk transfer formulation for estimating H performed reliable after calibration against the eddy covariance method. After calibration, the latter performed similar to the proposed SR‐LST method., This research was funded by project CGL2012‐37416‐C04‐01 and CGL2015‐65627‐C3‐1‐R (Ministerio de Ciencia y Innovación of Spain), CEI Iberus, 2014 (Proyecto financiado por el Ministerio de Educación en el marco del Programa Campus de Excelencia Internacional of Spain), and Ayuda para estancias en centros extranjeros (Ministerio de Educación, Cultura y Deporte of Spain).
Repositori Obert UdL
Publicación Artículo científico (JournalArticle)

Combining the bulk transfer formulation and surface renewal analysis for estimating the sensible heat flux without involving the parameter KB-1

  • Castellví Sentís, Francesc
  • Gavilán, Pedro
  • González‐Dugo, M. P.
The single‐source bulk transfer formulation (based on the Monin‐Obukhov Similarity Theory, MOST) has been used to estimate the sensible heat flux, H, in the framework of remote sensing over homogeneous surfaces (HMOST). The latter involves the canopy parameter, , which is difficult to parameterize. Over short and dense grass at a site influenced by regional advection of sensible heat flux, HMOST with  = 2 (i.e., the value recommended) correlated strongly with the H measured using the Eddy Covariance, EC, method, HEC. However, it overestimated HEC by 50% under stable conditions for samples showing a local air temperature gradient larger than the measurement error, 0.4 km−1. Combining MOST and Surface Renewal analysis, three methods of estimating H that avoid dependency have been derived. These new expressions explain the variability of H versus , where is the friction velocity, is the radiometric surface temperature, and is the air temperature at height, z. At two measurement heights, the three methods performed excellently. One of the methods developed required the same readily/commonly available inputs as HMOST due to the fact that the ratio between and the ramp amplitude was found fairly constant under stable and unstable cases. Over homogeneous canopies, at a site influenced by regional advection of sensible heat flux, the methods proposed are an alternative to the traditional bulk transfer method because they are reliable, exempt of calibration against the EC method, and are comparable or identical in cost of application. It is suggested that the methodology may be useful over bare soil and sparse vegetation., This research was funded by CERESS project AGL2011–30498 (Ministerio de Economía y Competitividad of Spain, cofunded FEDER), CGL2012–37416‐C04‐01 (Ministerio de Ciencia y Innovación of Spain), and CEI Iberus, 2014 (Proyecto financiado por el Ministerio de Educación en el marco del Programa Campus de Excelencia Internacional of Spain).
Recercat. Dipósit de la Recerca de Catalunya
Publicación Artículo científico (JournalArticle)

Daytime sensible heat flux estimation over heterogeneous surfaces using multitemporal land‐surface temperature observations

  • Castellví Sentís, Francesc
  • Cammalleri, C.
  • Ciraolo, G.
  • Maltese, A.
  • Rossi, F.
Equations based on surface renewal (SR) analysis to estimate the sensible heat flux (H) require as input the mean ramp amplitude and period observed in the ramp‐like pattern of the air temperature measured at high frequency. A SR‐based method to estimate sensible heat flux (HSR‐LST) requiring only low‐frequency measurements of the air temperature, horizontal mean wind speed, and land‐surface temperature as input was derived and tested under unstable conditions over a heterogeneous canopy (olive grove). HSR‐LST assumes that the mean ramp amplitude can be inferred from the difference between land‐surface temperature and mean air temperature through a linear relationship and that the ramp frequency is related to a wind shear scale characteristic of the canopy flow. The land‐surface temperature was retrieved by integrating in situ sensing measures of thermal infrared energy emitted by the surface. The performance of HSR‐LST was analyzed against flux tower measurements collected at two heights (close to and well above the canopy top). Crucial parameters involved in HSR‐LST, which define the above mentioned linear relationship, were explained using the canopy height and the land surface temperature observed at sunrise and sunset. Although the olive grove can behave as either an isothermal or anisothermal surface, HSR‐LST performed close to H measured using the eddy covariance and the Bowen ratio energy balance methods. Root mean square differences between HSR‐LST and measured H were of about 55 W m−2. Thus, by using multitemporal thermal acquisitions, HSR‐LST appears to bypass inconsistency between land surface temperature and the mean aerodynamic temperature. The one‐source bulk transfer formulation for estimating H performed reliable after calibration against the eddy covariance method. After calibration, the latter performed similar to the proposed SR‐LST method., This research was funded by project CGL2012‐37416‐C04‐01 and CGL2015‐65627‐C3‐1‐R (Ministerio de Ciencia y Innovación of Spain), CEI Iberus, 2014 (Proyecto financiado por el Ministerio de Educación en el marco del Programa Campus de Excelencia Internacional of Spain), and Ayuda para estancias en centros extranjeros (Ministerio de Educación, Cultura y Deporte of Spain).
Recercat. Dipósit de la Recerca de Catalunya
Publicación Artículo científico (JournalArticle)

Combining the bulk transfer formulation and surface renewal analysis for estimating the sensible heat flux without involving the parameter KB-1

  • Castellví Sentís, Francesc
  • Gavilán, Pedro
  • González‐Dugo, M. P.
The single‐source bulk transfer formulation (based on the Monin‐Obukhov Similarity Theory, MOST) has been used to estimate the sensible heat flux, H, in the framework of remote sensing over homogeneous surfaces (HMOST). The latter involves the canopy parameter, , which is difficult to parameterize. Over short and dense grass at a site influenced by regional advection of sensible heat flux, HMOST with  = 2 (i.e., the value recommended) correlated strongly with the H measured using the Eddy Covariance, EC, method, HEC. However, it overestimated HEC by 50% under stable conditions for samples showing a local air temperature gradient larger than the measurement error, 0.4 km−1. Combining MOST and Surface Renewal analysis, three methods of estimating H that avoid dependency have been derived. These new expressions explain the variability of H versus , where is the friction velocity, is the radiometric surface temperature, and is the air temperature at height, z. At two measurement heights, the three methods performed excellently. One of the methods developed required the same readily/commonly available inputs as HMOST due to the fact that the ratio between and the ramp amplitude was found fairly constant under stable and unstable cases. Over homogeneous canopies, at a site influenced by regional advection of sensible heat flux, the methods proposed are an alternative to the traditional bulk transfer method because they are reliable, exempt of calibration against the EC method, and are comparable or identical in cost of application. It is suggested that the methodology may be useful over bare soil and sparse vegetation., This research was funded by CERESS project AGL2011–30498 (Ministerio de Economía y Competitividad of Spain, cofunded FEDER), CGL2012–37416‐C04‐01 (Ministerio de Ciencia y Innovación of Spain), and CEI Iberus, 2014 (Proyecto financiado por el Ministerio de Educación en el marco del Programa Campus de Excelencia Internacional of Spain).