Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Seismic structure and composition of the southern central Iberian crust: The ALCUDIA wide angle seismic reflection transect

  • Palomeras, Imma
  • Ehsan, Siddique A.
  • Martínez Poyatos, David J.
  • Ayarza, P.
  • Martí, David
  • Carbonell, Ramón
  • Azor, Antonio
  • Parra, Luís M.
  • Marzán, Ignacio
The nature of the crust beneath central Iberia was estimated by a wide-angle seismic reflection/refraction transect, ALCUDIA-WA, which sampled the southern half of the Variscan Central Iberian Zone, covered in the north by the Cenozoic Tajo Basin. The shot gathers recorded by vertical component sensors revealed well defined P- and S-wave phases. These arrivals were modeled by an iterative forward approach providing 2D crustal models showing variations in the velocity distribution with upper crustal P- and S-wave velocities increasing northwards. The lower crust P-wave velocities are homogeneous along the profile while the S-wave velocities slightly increase northwards. The Moho is placed at 32 km depth in the southern edge of the profile, deepening northward down to 35 km beneath the Tajo Basin. The Poisson's ratio, calculated from P- and S-wave velocities, varies along the profile at upper crustal depths. The highest values are located below the Mora and Pedroches batholiths. These resulting physical properties can serve to constrain the crustal composition by comparing them with laboratory measurements on rock samples. Our results suggest that the upper crust in the southern and central segments of the ALCUDIA profile is made up of low-grade metasedimentary rocks, while the northern segment is dominated by igneous rocks, in agreement with the surface geology. Separated by a sharp boundary located between 12 km (south) and 18 km (north) depth, the lower crust is more homogeneous and shows low Poisson’ ratios compatible with a rather felsic composition. However, outstanding lamination described in coincident vertical incidence data indicates some degree of intercalation with mafic components., The authors thank the Associated Editor and the anonymous reviewers for their thoroughly valuable suggestions and comments that improved the manuscript. Seismic data were collected in 2012 with funding provided by the Spanish Ministry of Science and Innovation (grants: CGL2004-04623/BTE, CGL2007-63101/BTE, CGL2011-24101, CSD2006-00041). Instrumentation was provided by the IRIS-PASSCAL instrument center, Socorro, New Mexico, USA. The seismic data, including experiment geometry are stored in the IRIS-PASSCAL facilities and can be accessed through the IRIS-PASSCAL data management center. I.P. is funded by the Spanish Government and the Universidad de Salamanca with a Beatriz Galindo grant (BEGAL 18/00090). S.A. Ehsan is funded by the European Commission grant Marie Curie Actions (264517-TOPOMOD-FP7-PEOPLE-2010-ITN). We thank Instituto Geologico y Minero de Espana for providing the logistic help and an academic crew for data acquisition. GMT was used to prepare some of the figures shown in the paper., Peer reviewed
Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

Tracking climate variability in the western Mediterranean during the Late Holocene, a multiproxy approach

  • Nieto Moreno, V.
  • Martínez Ruiz, F.
  • Giralt, Santiago|||0000-0001-8570-7838
  • Jiménez Espejo, F.
  • Gallego Torres, D.
  • Rodrigo Gámiz, M.
  • García Orellana, Jordi|||0000-0002-0543-2641
  • Ortega Huertas, M.
  • De Lange, G. J.
Climate variability in the western Mediterranean is reconstructed for the last 4000 yr using marine sediments recovered in the west Algerian-Balearic Basin, near the Alboran Basin. Fluctuations in chemical and mineralogical sediment composition as well as grain size distribution are linked to fluvial-eolian oscillations, changes in redox conditions and paleocurrent intensity. Multivariate analyses allowed us to characterize three main groups of geochemical and mineralogical proxies determining the sedimentary record of this region. These three statistical groups were applied to reconstruct paleoclimate conditions at high resolution during the Late Holocene. An increase in riverine input (fluvial-derived elements - Rb/Al, Ba/Al, REE/Al, Si/Al, Ti/Al, Mg/Al and K/Al ratios), and a decrease in Saharan eolian input (Zr/Al ratio) depict the Roman Humid Period and the Little Ice Age, while drier environmental conditions are recognized during the Late Bronze Age-Iron Age, the Dark Ages and the Medieval Climate Anomaly. Additionally, faster bottom currents and more energetic hydrodynamic conditions for the former periods are evidenced by enhanced sortable silt (10-63 μm) and quartz content, and by better oxygenated bottom waters - as reflected by decreasing redox-sensitive elements (V/Al, Cr/Al, Ni/Al and Zn/Al ratios). In contrast, opposite paleoceanographic conditions are distinguished during the latter periods, i.e. the Late Bronze Age-Iron Age, the Dark Ages and the Medieval Climate Anomaly. Although no Ba excess was registered, other paleoproductivity indicators (total organic carbon content, Br/Al ratio, and organometallic ligands such as U and Cu) display the highest values during the Roman Humid Period, and together with increasing preservation of organic matter, this period exhibits by far the most intense productivity of the last 4000 yr. Fluctuations in detrital input into the basin as the main process managing deposition, reflected by the first eigenvector defined by the Principal Component Analyses, point to solar irradiance and the North Atlantic Oscillation variability as the main driving mechanisms behind natural climate variability over decadal to centennial time-scales for the last 4000 yr.
Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

The inverted Triassic rift of the Marrakech High Atlas, a reappraisal of basin geometries and faulting histories

  • Domènech, Mireia|||0000-0002-9166-0631
  • Teixell, Antonio|||0000-0002-7423-6361
  • Babault, Julien|||0000-0002-9602-0975
  • Arboleya, María Luisa|||0000-0002-9700-5566
The High Atlas of Morocco is an aborted rift developed during the Triassic-Jurassic and moderately inverted during the Cenozoic. The Marrakech High Atlas, with large exposures of basement and Triassic early syn-rift deposits, is ideal to investigate the geometries of the deepest parts of a rift, constituting a good analogue for pre-salt domains. It allows unraveling geometries and kinematics of the extensional and compressional structures and the influence that they exert over one another. A detailed structural study of the main Triassic basins and basin-margin faults of the Marrakech High Atlas shows that only a few rift faults were reactivated during the Cenozoic compressional stage in contrast to previous interpretations, and emphasizes that fault reactivation cannot be taken for granted in inverted rift systems. Preserved extensional features demonstrate a dominant dip-slip opening kinematics with strike-slip playing a minor role, at variance to models proposing a major strike-slip component along the main basin-bounding faults, including faults belonging to the Tizi n'Test fault zone. A new Middle Triassic paleogeographic reconstruction shows that the Marrakech High Atlas was a narrow and segmented orthogonal rift (sub-perpendicular to the main regional extension direction which was ~ NW-SE), in contrast to the central and eastern segments of the Atlas rift which developed obliquely. This difference in orientation is attributed to the indented Ouzellarh Precambrian salient, part of the West African Craton, which deflected the general rift trend in the area evidencing the major role of inherited lithospheric anisotropies in rift direction and evolution. As for the Cenozoic inversion, total orogenic shortening is moderate (~ 16%) and appears accommodated by basement-involved large-scale folding, and by newly formed shortcut and by-pass thrusting, with rare left-lateral strike-slip indicators. Triassic faults commonly acted as buttresses.
Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

Magnitude of rift-related burial and orogenic contraction in the Marrakech High Atlas revealed by zircon (U-Th)/He thermochronology and thermal modelling

  • Domènech, Mireia|||0000-0002-9166-0631
  • Teixell, Antonio|||0000-0002-7423-6361
  • Stockli, Daniel F.|||0000-0001-7652-2129
The Atlas of Morocco is a continental rift developed during the Triassic-Jurassic and moderately inverted during the Cenozoic. The High Atlas south of Marrakech, with exposures of basement and Triassic early synrift deposits, has been viewed as a high during the Mesozoic rifting. First zircon (U-Th)/He ages and thermal models obtained from 42 samples in the Marrakech High Atlas following two NNW-SSE transects across the mountain belt reveal that in contrast to previous models, the Triassic-Jurassic rift was well developed in the Marrakech High Atlas (with more than 4.5-6 km of rift-related deposits). Middle Jurassic-Early Cretaceous zHe cooling ages obtained indicate that rift-related subsidence in the Marrakech High Atlas finished in the Middle Jurassic and was followed by a period of exhumation where 2-3 km of rock were eroded. Thermal models from zHe data provide the first thermochronologic clue for a Late Cretaceous initiation of the Atlas compression-driven exhumation in the inner parts of the Marrakech High Atlas. The Triassic-Jurassic basin reconstruction assisted by thermochronology highlights a key role of inherited basement anisotropy in rift orientation and evolution, and on its subsequent inversion. Comparison of present-day and restored sections to the rifting stage aided by thermochronology suggests minimum values of total orogenic shortening in the Marrakech High Atlas of 13 to 14 km (21 to 17%), with exhumation of 1 to more than 5 km of rocks. Similar zHe ages on both sides of the Tizi n'Test fault evince minor vertical movements along the fault during the Atlas orogeny.
Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

Tectono-thermal history of an exhumed thrust-sheet-top basin, an example from the south Pyrenean thrust belt

  • Labaume, Pierre
  • Meresse, Florian
  • Jolivet, Marc
  • Teixell, Antonio|||0000-0002-7423-6361
  • Lahfid, Abdeltif|||0000-0002-1203-3438
This paper presents a new balanced structural cross-section of the Jaca thrust-sheet-top basin of the southern Pyrenees combined with paleo-thermometry and apatite fission track (AFT) thermochronology data. The cross-section, based on field data and interpretation of industrial seismic reflection profiles, allows refinement of previous interpretations of the south-directed thrust system, involving the identification of new thrust faults, and of the kinematic relationships between basement and cover thrusts from the middle Eocene to the early Miocene. AFT analysis shows a southward decrease in the level of fission track resetting, from totally reset Paleozoic rocks and lower Eocene turbidites (indicative of heating to Tmax.
Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

Crustal thickness and velocity structure across the Moroccan Atlas from long offset wide-angle reflection seismic data, the SIMA experiment

  • Ayarza, P.
  • Carbonell, R.
  • Teixell, Antonio|||0000-0002-7423-6361
  • Palomeras, I.
  • Martí, D.
  • Kchikach, A.
  • Harnafi, M.
  • Levander, A.
  • Gallart, Josep|||0000-0003-3833-9571
  • Arboleya, María Luisa|||0000-0002-9700-5566
  • Alcalde, J.
  • Fernández, M.
  • Charroud, M.
  • Amrhar, M.
The crustal structure and topography of the Moho boundary beneath the Atlas Mountains of Morocco has been constrained by a controlled source, wide-angle seismic reflection transect: the SIMA experiment. This paper presents the first results of this project,consisting of an almost 700 km long, high-resolution seismic profile acquired from the Sahara craton across the High and the Middle Atlas and the Rif Mountains. The interpretation of this seismic dataset is based on forward modeling by raytracing, and has resulted in a detailed crustal structure and velocity model for the Atlas Mountains. Results indicate that the High Atlas features a moderate crustal thickness, with the Moho located at a minimum depth of 35 km to the S and at around 31 km to the N, in the Middle Atlas. Upper crustal shortening is resolved at depth through a crustal root where the Saharan crust underthrusts the northern Moroccan crust. This feature defines a lower crust imbrication that, locally, places the Moho boundary at ~40-41 km depth in the northern part of the High Atlas. The P-wave velocity model is characterized by relatively low velocities, mostly in the lower crust and upper mantle, when compared to other active orogens and continental regions. These low deep crustal velocities together with other geophysical observables such as conductivity estimates derived from MT measurements, moderate Bouguer gravity anomaly, high heat flow, and surface exposures of recent alkaline volcanism lead to a model where partial melts are currently emplaced at deep crustal levels and in the upper mantle. The resulting model supports the existence of a mantle upwelling as mechanism that would contribute significantly to sustain the High Atlas topography. However, the detailed Moho geometry deduced in this work should lead to a revision of the exact geometry and position 43 of this mantle feature and will require new modeling efforts.