Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

Minerva. Repositorio Institucional de la Universidad de Santiago de Compostela
Publicación Artículo científico (JournalArticle)

Defining Operational Limits of Low-Cost MSLA 3D Printing for Microfluidic Systems: Resin Performance, Cell Compatibility, and Fluid Dynamics

  • Radziunas Salinas, Yago
  • Blanco Fernández, Bárbara
  • Valdiglesias, Vanessa
  • Flores Arias, María Teresa
  • Bao Varela, María del Carmen
  • Gómez Varela, Ana Isabel
Additive manufacturing using low-cost masked stereolithography technology is an attractive option to democratize microfluidic devices fabrication, albeit with limits in spatial resolution, optical transparency, cytotoxicity, and replication that need to be addressed. In this work, five transparent masked stereolithography resins employed in an Anycubic Photon M7 Pro low-cost printer are systematically studied to address the limitations mentioned above. The working route was based on the analysis of the dimensions of negative and positive microfeatures, their transmission spectra, their cytotoxicity, the capability of building internal channels, replicability in PDMS, and validation by computational fluid dynamics simulations with experimental fluid assays. Resolution tests revealed that negative structures resolved less accurately due to subtle resin accumulation during the layer-by-layer printing process. Internal channel fabrication showed a practical lower limit of approximately 500 μm under the printing and postprocessing conditions used in the study, with resin viscosity, printing angle, and drainage behavior strongly influencing channel clearance. The Standard V2 and High Clear resins exhibited the highest printing resolution with microchannels printed in a vertical or almost-vertical position. Regarding thermally cured PDMS replication, the Tough Ultra, ABS-like Pro 2, and Water-Wash were the ones exhibiting the most accurate outcome. From a biological point of view, all resins were non-cytotoxic, with Standard V2 and High Clear exhibiting the highest cell viability, in some cases better than the control scenario. Contact angle measurements indicated that the Standard V2 and High Clear resins are highly hydrophilic, whereas the remaining resins exhibit a hydrophobic behavior. Swelling was found to be dependent on the media, where the Water-Wash found high swelling in Milli-Q water and PBS and the Tough Ultra in ethanol. Samples were only minimally affected by isopropyl alcohol. Finally, fluid flow assays were conducted on three different microfluidic chips to demonstrate that the introduction of microfeatures and zigzag architectures fosters the disruption of laminar flow conditions by introducing secondary flows and vorticity to mimic more physiological environments. These experiments were contrasted with simulations performed by computational fluid dynamics. It was verified that microfeatures can be adequately implemented in the chip architecture and result in enhanced mixing. This validation allowed defining a practical operating window for MSLA 3D printers for microfluidics.
Minerva. Repositorio Institucional de la Universidad de Santiago de Compostela
Publicación Artículo científico (JournalArticle)

Biocompatibility testing of UV-curable polydimethylsiloxane for human umbilical vein endothelial cell culture on-a-chip

  • Gómez Varela, Ana Isabel
  • Viña, Antonio
  • Bao Varela, María del Carmen
  • Flores Arias, María Teresa
  • Carnero Groba, Bastián
  • González Peteiro, María Mercedes
  • González Juanatey, José Ramón
  • Álvarez Castro, Ezequiel
Polydimethylsiloxane (PDMS) is extensively used to fabricate biocompatible microfluidic systems due to its favorable properties for cell culture. Recently, ultraviolet-curable PDMS (UV-PDMS) has shown potential for enhancing manufacturing processes and final optical quality while retaining the benefits of traditional thermally cured PDMS. This study investigates the biocompatibility of UV-PDMS under static and flow conditions using human umbilical vein endothelial cells (HUVECs). UV-PDMS samples were treated with oxygen plasma and boiling deionized water to assess potential improvements in cell behavior compared with untreated samples. We evaluated HUVECs adhesion, growth, morphology, and viability in static cultures and microchannels fabricated with UV-PDMS to test their resistance to flow conditions. Our results confirmed the biocompatibility of UV-PDMS for HUVECs culture. Moreover, plasma-oxygen-treated UV-PDMS substrates exhibited superior cell growth and adhesion compared to untreated UV-PDMS. This enhancement enabled HUVECs to maintain their morphology and viability under flow conditions in UV-PDMS microchannels. Additionally, UV-PDMS demonstrated improved optical quality and more efficient handling and processing, characterized by shorter curing times and simplified procedures utilizing UV light compared to traditional PDMS.
Minerva. Repositorio Institucional de la Universidad de Santiago de Compostela
Publicación Artículo científico (JournalArticle)

Marine macroalgae in rabbit feed – Effects on meat quality

  • Al Soufi, Sabela
  • García, Javier
  • Nicodemus, Nuria
  • Lorenzo, José M.
  • Cegarra, Eugenio
  • Muíños, Antonio
  • Losada García, Ana Paula
  • López Alonso, María Marta
The addition of macroalgae to livestock diets has demonstrated to enhance the quality of meat by improving the muscle stability, antioxidant capacity and fatty acid profile. However, information regarding rabbit meat is scarce. This study evaluated the effect of adding 1.025% of different macroalgae, dehydrated and as extracts (Saccharina latissima, Himanthalia elongata and Ulva spp.) to the diet of growing rabbits. Dietary supplementation with the Ulva spp. extract increased the fat content (0.96% vs 0.33% in control group) and the proportion of monounsaturated fatty acids (by 22%; P ≤ 0.022), but did not affect the moisture, protein or ash contents or the physicochemical properties of the rabbit longissiumus lumborum muscle. The antioxidant status of the meat was adequate and was not affected by the dietary supplements. The sensorial properties of the meat were also not affected, and dietary supplementation with both S. latissima and H. elongata actually enhanced the flavour and juiciness of the meat (P ≤ 0.01). Altogether, the study findings indicate that the addition of these sustainable ingredients to rabbit feed did not negatively affect meat quality, and some of them may potentially improve specific characteristics, which could make this meat more attractive to consumers
Minerva. Repositorio Institucional de la Universidad de Santiago de Compostela
Publicación Artículo científico (JournalArticle)

Nocturnal camouflage through background matching against moonlight

  • Negro, Juan J.
  • Bará Viñas, Salvador
  • Galadí Enríquez, David
  • Nieves, Juan Luis
  • Martínez Domingo, Miguel A.
  • Ferrero, Alejandro
  • Campos, Joaquín
  • Bao Varela, María del Carmen
  • Masana, Eduard
  • Camacho, Carlos
Camouflage is often considered a daytime phenomenon based on light and shade. Nocturnal camouflage can also occur, but its mechanistic basis remains unclear. Here, we analyze the conditions for background matching (BM) of avian predators against the night sky. Such concealment is achieved when the contrast between the predator and the sky is smaller than the contrast detection threshold of prey. This condition cannot be fulfilled under isotropic skies, as in fully overcast or moonless nights. However, on clear moonlit nights, the isotropy of the sky radiance is broken due to the presence of the Moon, and the conditions for BM can be met for a wide range of sky directions. This effect is mainly dependent on the altitude of the Moon above the horizon, rather than on Moon phase. We have modeled the feasibility of concealment through BM of a typically white barn owl (Tyto alba) when hunting rodents, based on its contrast against the moonlit sky. We considered the radiometric quantities of the sky, the ground, and the bird’s undersides. Our results show that a barn owl with highly reflecting underparts may approach a rodent from broad regions of the moonlit sky while keeping itself below the contrast detection threshold of the mouse M-cones and rods. S-cones, in turn, remain below their excitation threshold for most of the lunar cycle. Our results demonstrate that the white color of barn owls serves as camouflage tailored to the moonlit sky background, providing a mechanistic basis for understanding nocturnal camouflage.