RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación
Artículo científico (JournalArticle)
Dynamic acousto-elastic test using continuous probe wave and transient vibration to investigate material nonlinearity
This study demonstrates the feasibility of the dynamic acousto-elastic effect of a continuous high frequency
wave for investigating the material nonlinearity upon transient vibration. The approach is
demonstrated on a concrete sample measuring 15 15 60 cm3
. Two ultrasonic transducers (emitter
and receiver) are placed at its middle span. A continuous high frequency wave of 500 kHz propagates
through the material and is modulated with a hammer blow. The position of the hammer blow on the
sample is configured to promote the first bending mode of vibration. The use of a continuous wave allows
discrete time extraction of the nonlinear behavior by a short-time Fourier transform approach, through
the simultaneous comparison of a reference non-modulated signal and an impact-modulated signal.
The hammer blow results in phase shifts and variations of signal amplitude between reference and perturbed
signals, which are driven by the resonant frequency of the sample. Finally, a comprehensive analysis
of the relaxation mechanisms (modulus and attenuation recovery) is conducted to untangle the
coupled fast and slow hysteretic effects.
2016 Elsevier B.V. All rights reserved., The authors want to acknowledge the financial support of the Ministerio de Economia y Competitividad (MINECO), Spain and FEDER funding (Ondacem Project: BIA 2010-19933). J.N. Eiras is grateful to the Ministerio de Economia y Competitividad (MINECO), Spain, Grant BES-2011-044624 and Grant EEBB I-15-10178, in support of an extended visit to the Aix-Marseille Universite. The French National Research Agency is also thanked for support under the EVADEOS (Grant ANR-11-VILD-0002) and ENDE (Grant ANR-11 RSNR 0009) programs.